CDA FWV900SS drink cooler
Contents
1. 5 Rotate the door 180 and then relocate it on the upper and lower hinge plates Refit both uf 6 To level the door adjust the upper and lower hinge plate screws and then tighten securely Please note Keep the spare upper hinge plate to be able to reverse the door back again Table of parts 1 Upper screws 2 Hinge pin cover 3 Upper hinge pin 4 Right upper hinge plate 5 Door 6 Left upper hinge plate 7 Lower hinge plate 8 Lower hinge pin 9 Lower screws Electrical information Warning This appliance must be earthed Green amp Yellow to Earth The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug To chai follow the steps below 1 Remove the fuse cover and fuse 2 Fit a replacement 13A fuse ASTA approved to BS 1362 type into the fuse cover 3 Replace fuse cover Important Do not use the appliance without the fuse cover in position How to connect an alternative plug If the fitted plug is not suitable for your socket outlet then it should be cut off and disposed o hazard A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows e The wire which is coloured GREEN and YELLOW must be connected to the terminal2. Down button Display Shelf H TT J Condenser Cabinet Leveling Leg To switch the power on off Press and hold the light and temperature set buttons simultaneously for five seconds To change the temperature e Press the temperature set button once to select the upper zone e The LED display for the upper zone will flash e Press the up or down buttons until the required temperature is shown on the display e Press the temperature set button again to select the lower zone e The LED display for the lower zone will flash e The preset temperature for the upper zone is 10C 50 F and for the lower zone is 16C 6 e To change the temperature display from Fahrenheit to Celsius or Celsius to Fahrenheit pres buttons simultaneously for five seconds e To view the set temperature in either zone touch the up or down button at any time and tl the LED display for five seconds Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15 C your wine can also be stored a red wine this is between 15 and 17 C and for white wine between 12 and 13 C To use the internal light e Press the light button to switch the light on or off Care and Cleaning Always disconnect the appliance from the mains electrical supply before any cleani Do not use abrasive products or detergents After washing rinse and dry thoroughly e The exterior of the appliance and the door seal should
3. be cleaned using mild soapy water e The interior cabinet should be cleaned using a solution of bicarbonate of soda and lukewai e Clean the shelves separately by hand using soap and water Do not put them in the dishwa e Ensure that the cloth is only moist when cleaning the control panel and electrical parts an dried off before reconnecting the power e Once cleaning is complete reconnect the mains electrical supply e Ifthe appliance is not to be used for prolonged periods of time unplug and clean the appli should be left slightly ajar to prevent the formation of odours or condensation Troubleshooting If you have any problems with your appliance you should check the troubleshootii CDA Customer Care to prevent unnecessary service calls and potential cost If the appliance is not working check e There is power to the appliance e The house fuses or circuit breakers are intact and the fuse in the plug has not blown e The plug socket is functioning correctly To check this plug another electrical appliance in t e The ambient temperature is between 5 38 C The appliance is working but not very well check e The appliance is not overloaded e The thermostat is set to an appropriate temperature e The door is closing properly e The door gasket is sealing properly e There is enough ventilation at the side and rear walls e The ambient temperature is between 5 38 C The appliance is noisy check e The appliance is level a
4. FWV450 and FWV900 C D A Wine Coolers Manual for Installation Use and Maintenance Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorr product Please note that CDA reserve the right to invalidate the guarantee supplied with th installation or misuse of the appliance or use in a commercial environment This appliance is not designed to be used by people including children with reduced capacity or who lack experience or knowledge about it unless they have had supervision the appliance by someone who is responsible for their safety Under no circumstances should any external covers be removed for servicing or maintenan personnel Appliance information Please enter the details on the appliance rating plate below for reference to assist CDA Cu fault with your appliance and to register your appliance for guarantee purposes CE Declarations of Conformity This appliance has been designed constructed and marketed in compliance with safety r 2006 95 EEC Low voltage and requirements of EMC Directive 2004 108 EEC IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCOR 2002 96 EC At the end of its working life the product must not be disposed of as urban waste It m authority differentiated waste collection centre or to a dealer providing this service Disposing of a household appliance separately avoids possible negative consequences for deriving f
5. elsewhere the plinth vent may not be necessary IMPORTANT Failure to follow the instructions regarding installation and ventilatic warranty supplied with your appliance To ensure the proper functioning of the appliance air vents should never be blocke To install the handle IMPORTANT Do not overtighten the screws and do not use power tools to install 1 Carefully remove the door seal on the side you wish to install the handle 2 Insert the screw from the inside of the door frame and screw it in to the handle using the s washers provided 3 Replace the door seal Reversing the door It is possible to reverse the door on this appliance if required To do so follow the steps below 1 With the door closed remove the upper hinge pin cover and then the upper and lower hin prevent it falling 2 Remove the door carefully and place it on a padded surface to avoid the risk of damage 3 Unscrew the four upper hinge plate screws on the right hand side and the blanking screws a Remove the right upper hinge plate Fit the left upper hinge plate supplied with the instructio screws and then fit the blanking screws on the right 4 Unscrew the four lower hinge plate screws on the right hand side and the blanking screws o Remove the right lower hinge plate and rotate the hinge plate 180 Refit the lower hinge plate using the four hinge plate screws and then fit the blanking screws on the right
6. is is a self defrosting appliance The compressor will not run during the thirty minute de e Do not pull the shelves beyond the anti stop position approximately one third out when Use and Controls FWV450 Digital Control Panel Key gt 1 Power button 2 Light button 3 Up button 4 Down button Handle Door Shelves Total 3 Condenser Cabinet Leveling Leg FWC450 control panel To switch the power on off Press and hold the power button for five seconds To change the temperature e Press the up or down buttons until the required temperature is shown on the display e The preset temperature is 12C 54 F e To change the temperature display from Fahrenheit to Celsius or Celsius to Fahrenheit pres buttons simultaneously for five seconds e To view the set temperature touch the up or down button at any time and the set temperat display for five seconds Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15 C your wine can also be stored a red wine this is between 15 and 17 C and for white wine between 12 and 13 C To use the internal light e Press the light button to switch the light on or off Use and Controls Fwv900 Key Door H 1 Light button Hange 2 Temperature set button Digital Control Panel 2 ene i 3 Up button Shelves Total 5 4
7. nd stable e The cooling gas will make some noise even when the compressor is not running e During operation it is normal for the fan to run even when the compressor is not running The light does not work check e There is power to the appliance e The house fuses or circuit breakers are intact and the fuse in the plug has not blown e The light button is not set to off Please note The LED lighting cannot be replaced without a service call If the light fails conta The door will not close properly check e The appliance is level and stable e If the door has been removed it may not have been correctly refitted e The door seal is dirty e The shelves are not positioned correctly The display show EL or EH e The temperature sensor has failed Installing the wine cooler This appliance is intended to be built in to a kitchen cabinet This appliance should be installed in a well ventilated dry room This appliance must not be installed 1 Indirect sunlight 2 Adjacent to a heat source oven or radiator 3 Below a hob unit Place your wine cooler in a location which is strong enough to support its weight when fully loai adjust the front levelling legs at the bottom of the wine cooler Ensure that there is an adequate flow of air at the rear of the cabinet as shown in the diagram Please note that a plinth vent of at least 200 cm is recommended to allow for sufficient ventila provided
8. rom inappropriate disposal and enables the constituent materials to be recovere in energy and resources As a reminder of the need to dispose of household appliances sep with a crossed out wheeled dustbin g Before first use You must allow the appliance to settle for at least twenty four hours prior to swi It is recommended that you remove all internal and external packaging and clean the interior of using a solution of bicarbonate of soda and warm water and then thoroughly dry the interior The appliance may have an odour to it at first use This will disappear as the appliance cools Please note e The appliance will work continuously until it gets to the correct temperature e Ifthe appliance is switched off you should allow five minutes before switching it on again t unnecessary damage to the compressor e The LED display may not show the selected temperature whilst the appliance first gets to tl normal and the display will be corrected automatically once the appliance has run for a few Use e Only store wine in sealed containers Do not overload the cabinet e Only open the door when necessary Do not cover the shelves with aluminium foil or anything else that will prevent air from circ e To prevent damage to the door seal ensure the door is fully open before removing the shel e This appliance has been designed to work at an ambient temperature between 5 38 C U these parameters may cause the unit to fail e Th
9. whic by the Earth symbol i or coloured GREEN and YELLOW e The wire which is coloured BLUE must be connected to the terminal which is marked with coloured BLACK e The wire which is coloured BROWN must be connected to the terminal which is marke coloured RED If in doubt regarding the electrical connection of this appliance consult a qualified electrician supply cable the appliance may require removing for servicing N B Ensure that the plug socket is situated in an easily accessible place CDA To contact our Customer Care Department or for Service please contact us on the details below
Download Pdf Manuals
Related Search