Metra 99-9000 mounting kit
Contents
1. ny Place the head unit kit assembly under the dash unused wires to prevent electrical short until the desired mounting location has been circuit established Mark the screw holes onto the dash Re connect the battery terminal and test the unit for proper operation Mount the head unit kit assembly to the pre marked holes on the dash with 8 Phillips screws supplied If the back of the Underdash Housing was removed in step 1 fewer screws will be used2. rev 230701 KIT FEATURES f ACORP 99 9000 AW 104UD pe Shot and DIN unit provisions gt Various mounting depth alternati D Wa 0 0 INSTALLATION INSTRUCTIONS Underdash Housing APPLICATIONS MOUNTS AN AFTERMARKET 2 SHAFT OR DIN RECEIVER COMPACT DISC PLAYER OR CB RADIO TO AN UNDERDASH LOCATION ey ejje 771 8 Phillips FUTU Screws TOOLS REQUIRED Phillips screwdriver RK Cutting tool J 1 800 221 0932 LI www metraonline com Adjustable wrench COPYRIGHT 2001 METRA ELECTRONICS CORPORATION Disconnect the negative battery terminal to prevent an accidental short circuit If an open back installation is desired for additional depth cut the Underdash Housing along the scored line and remove the rear portion of the Housing see Fig A 2 SHAFT HEAD UNITS Slide the aftermarket head unit into the Underdash Housing and secure with shaft nuts see Fig A DIN HEAD UNITS Cut and remove the shaft supports from the Underdash Housing Slide the DIN cage into the kit and secure by bending the metal locking tabs down Slide the aftermarket head unit into the cage until secure see Fig B A Strip wire ends back 72 B Twist ends together C Solder D Tape Locate the factory wiring harness in the dash Metra recommends using the proper mating adaptor and making connections as shown Isolate and individually tape off the ends of a
Download Pdf Manuals
Related Search