Smeg KEFV90 cooker hood
Contents
1. an electric socket is available and it is possible to connect a fumes discharge device to the outside only suction version e Carry out all the masonry work necessary e g installation of an electric socket and or a hole for the passage of the discharge tube Expansion wall plugs are provided to secure the hood to most types of walls ceilings However a qualified technician must verify suitability of the materials in accordance with the type of wall ceiling The wall ceiling must be strong enough to take the weight of the hood Do not tile grout or silicone this appliance to the wall Surface mounting only 10 Installation wall model Fig 5 When the vapour catcher is disassembled it must be fixed as shown in Fig a b c Using a pencil draw a line on the wall extending up to the ceiling to mark the centre This will facilitate installation 2 Rest the drilling template against the wall the vertical centre line printed on the drilling template must correspond to the centre line drawn on the wall and the bottom edge of the drilling template must correspond to the bottom edge of the hood 3 Place the lower support bracket on the perforation diagram making it coincide with the traced triangle mark the two external holes and perforate Remove the perforation diagram insert two wall dowels and fix the support bracket of the hood with two 5x45 mm screws Hang the hood onto the lower bracket Adjust the distance of the hood2. of the cooker hood and replacement of the filters may cause fire risks Therefore we recommend oserving these instructions The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations 11 Grease filter Traps cooking grease particles This must be cleaned once a month or when the filter saturation indication system if envisaged on the model in possession indicates this necessity using non aggressive detergents either by hand or in the dishwasher which must be set to a low temperature and a short cycle When washed in a dishwasher the grease filter may discolour slightly but this does not affect its filtering capacity To remove the grease filter pull the spring release handle Fig 2 Charcoal filter filter version only It absorbs unpleasant odours caused by cooking The charcoal filter can be washed once every two months or when the filter saturation indication system if envisaged on the model in possession indicates this necessity using hot water and a suitable detergent or in a dishwasher at 65 C if the dishwasher is used select the full cycle function and leave dishes out Eliminate excess water without damaging the filter then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100 C to dry completely Replace the mattress every 3 yea
3. from the wall Adjust the horizontal position of the hood Using a pencil mark the cooker hood permanent drill hole inside the suction group 8 Remove the hood from the lower bracket 9 Drill at the point marked 08mm 10 Insert 1 wall screw anchor 11 Apply the flues support bracket G to the wall adherent to the ceiling use the flues support bracket as a perforation diagram if present the small slot on the support must coincide with the line drawn previously on the wall and mark two holes with a pencil Make the holes 8mm and insert 2 dowels Fix the chimney support bracket to the wall using two 5x45mm screws 13 Hook the hood onto the bottom bracket Fix the hood into its final position on the wall ABSOLUTELY ESSENTIAL Connect a pipe pipe and pipe clamps not provided to be purchased separately for discharge of fumes to the connection ring located over the suction motor unit If the hood is to be used in ducting version the other end of the pipe must be connected to a device expelling the fumes to the outside If the hood is to be used in filter version then fix the deflector F to the chimney support bracket G and connect the other extremity of the pipe to the connection ring placed on the deflector F Connect the electricity Apply the chimney stacks and fasten them at the top to the chimney support G 17b using 2 screws 17a 18 Slide the bottom section of the chimney down until it completely covers
4. the suction unit and slots into the housing provided on top of the hood Remount the carbon filter frame and the fat s filter s and check the perfect functioning of the hood N eo e 12 15 16 17 Description of the hood Fig 1 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp 5 Vapour catcher 6 Telescopic chimney 7 Air outlet used for filter version only Operation Use the high suction speed in cases of concentrated kitchen vapours It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking Control panel ON OFF light switch b Speed 1 OFF switch C 2 speed selection d 3 speed selection ba Maintenance ATTENTION Before performing any maintenance operation isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse Or if the appliance has been connected through a plug and socket then the plug must be removed from the socket Cleaning The cooker hood should be cleaned regularly at least with the same frequency with which you carry out maintenance of the fat filters internally and externally Clean using the cloth dampened with neutral liquid detergent Do not use abrasive products DO NOT USE ALCOHOL WARNING Failure to carry out the basic cleaning recommendations
5. Montage und Gebrauchsanweisung Instruction on mounting and use Prescriptions de montage et mode d emploi Montagevoorschriften en gebruiksaanwijzingen Montaje y modo de empleo Instruc es para montagem e utilizac o Istruzioni di montaggio e d uso Monterings och bruksanvisningar lt A 6 x 3 5x6 5 EN Instruction on mounting and use Consult the designs in the front pages referenced in the text by alphabet letters Closely follow the instructions set out in this manual All responsibility for any eventual inconveniences damages or fires caused by not complying with the instructions in this manual is declined The hood can look different to that illustrated in the drawings in this booklet The instructions for use maintenance and installation however remain the same Note the elements marked with the symbol are optional accessories supplied only with some models or elements to purchase not supplied AN Caution WARNING Do not connect the appliance to the mains until the installation is fully complete Before any cleaning or maintenance operation disconnect the hood from the mains by removing the plug or disconnecting the home mains switch The appliance is not intended for use by children or persons with impaired physical sensorial or mental faculties or if lacking in experience or know how unless they are under supervision or have been trained in the use of the appliance by a person res
6. e outside the hood can be used in the filter version fitting an activated carbon filter and the deflector F on the support bracket G fumes and vapours are recycled through the top grille H by means of an exhaust pipe connected to the top air outlet B and the connection ring mounted on the deflector F exhaust pipe and pipe fixing clamps not provided Attention If the hood is not supplied with carbon filter then it must be ordered and mounted The models with no suction motor only operate in ducting mode and must be connected to an external suction device not supplied Installation The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers If the instructions for installation for the gas hob specify a greater distance this must be adhered to AN Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area If it not fitted with a plug direct mains connection or if the plug is not located in an accessible area apply a bi polar switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over current category Ill in accordance wi
7. lity for any problems damage or fires caused to the appliance as the result of the non observance of the instructions included in this manual This appliance is marked according to the European directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The symbol mw on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal For more detailed information about treatment recovery and recycling of this product please contact your local council your household waste disposal service or the shop where you purchased the product Use The hood is designed to be used either for exhausting or filter version Ducting version The hood is equipped with a top air outlet B for discharge of fumes to the outside exhaust pipe and pipe fixing clamps not provided Attention If the hood is supplied with carbon filter then it must be removed Filter version Should it not be possible to discharge cooking fumes and vapour to th
8. ponsible for their safety Children should be monitored to ensure that they do not play with the appliance Never use the hood without effectively mounted grating The hood must NEVER be used as a support surface unless specifically indicated The premises must be sufficiently ventilated when the kitchen hood is used together with other gas combustion devices or other fuels The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels The flaming of foods beneath the hood itself is severely prohibited The use of exposed flames is detrimental to the filters and may cause a fire risk and must therefore be avoided in all circumstances Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames As regards the technical and safety measures to be adopted for fume discharging it is important to closely follow the relations provided by the competent authorities The hood must be regularly cleaned on both the inside and outside AT LEAST ONCE A MONTH it is in any event necessary to proceed in accordance with the maintenance instructions provided in this manual Failure to follow the instructions as concerns hood and filter cleaning will lead to the risk of fires Do not use or leave the hood without the lamp correctly mounted because of the possible risk of electric shocks We decline any responsibi
9. rs and when the cloth is damaged Remove the filter holder frame by turning the knobs g 90 that affix the chimney to the cooker hood Insert the pad i of activated carbon into the frame h and fit the whole back into its housing j Fig 3 It is possible to use a traditional carbon filter neither washable nor regenerable to be replaced every 3 4 months The filter holder frame of the carbon filter is welded together the eventual frame supplied with the hood is not therefore to be used Insert it into its housing and fix it turning the 2 plastic knobs Replacing lamps Disconnect the hood from the electricity Warning Prior to touching the light bulbs ensure they are cooled down Fig 4 1 Using a flat head screwdriver or equivalent tool carefully pry loose the light cover 2 Remove the damaged light and replace with a new 12 Volt 20 Watt Maximum halogen light made for a G 4 base SUITABLE FOR USE IN OPEN LUMINAIRES Follow package directions and do not touch new light with bare hands 3 Reinstall the light cover it will snap shut If the lights do not work make sure that the lamps are fitted properly into their housings before you call for technical assistance
10. th installation instructions Warning Before re connecting the hood circuit to the mains supply and checking the efficient function always check that the mains cable is correctly assembled Mounting Before beginning installation e Check that the product purchased is of a suitable size for the chosen installation area e To facilitate installation remove the fat filters and the other parts allowed and described here dismantle and mount it To remove see also the relative paragraphs e Remove the active carbon filter s if supplied see also relative paragraph This these is are to be mounted only if you want lo use the hood in the filtering version e Check for transport reasons that there is no other supplied material inside the hood e g packets with screws guarantees etc eventually removing them and keeping them e If possible disconnect and move freestanding or slide in range from cabinet opening to provide easier access to rear wall ceiling Otherwise put a thick protective covering over countertop cooktop or range to protect from damage and debris Select a flat surface for assembling the unit Cover that surface with a protective covering and place all canopy hood parts and hardware in it e Disconnect the hood during electrical connection by turning the home mains switch off e In addition check whether near the installation area of the hood in the area accessible also with the hood mounted
Download Pdf Manuals
Related Search