Tunturi T60F Treadmill User Manual
Contents
1. 4 Plug the washer into a regular 220 24 0Volt 50Hz 0 outlet Note Carefully inspect around the machine for any leaks and tighten any loose connections Caution If after completing these steps you are unsure that unit is properly installed contact a qualified installer To ensure that your washer is properly installed it is recommended that it be installed by a certified installer ELECTRICAL REQUIREMENTS Earthing Instructions This appliance must be grounded In the event of an electrical short circuit grounding reduces the risk of electric shock by providing an escape wire for the electric current This appliance is equipped with a grounding wire with a grounded plug The plug must be inserted into an outlet that is properly installed and grounded Improper use of the plug can result in a risk of electric shock A Consult a qualified electrician or service person if the grounding instructions are not completely understood or if doubt exists as to whether the appliance is properly grounded Wiring Requirements The washer must be plugged into at least 0 220 240 VOLT 50 HZ GROUNDED OUTLET If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Note If a standard two prong outlet is encountered it is the c E personal responsibility and obligation of the consumer to have it replaced with2. a properly grounded three prong outlet Extension Cords We do not recommend that you use an extension cord CAUTION If this appliance is supplied from a cord extension set or electrical portable outlet device the cord extension set or electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture Power Interruptions Occasionally there may be power interruptions due to thunderstorms or other causes Remove the power cord from AC outlet when a power outage occurs When power has been restored re plug power cord toAC outlet If outage is fora prolonged period clean washer before using it again 14 SPECIFICATIONS Rated voltage frequency 220 240V 50Hz Rated washing spinning capacity 7 5kg 7 5kg Spin speed max 650rpm Inlet pressure 0 03 1 0 Net weight 59kg Dimensions mm 686 Depth x 686 Width x 1105 Height
3. solvents or any other explosive or flammable substances that could ignite and explode Do not add or mix any flammable or explosive substances to the wash Do not try to remove clothes while the washer is in motion Wait until it comes to a complete stop The lid must be closed when the machine is in operation Do not use this appliance for commercial applications Do not operate this appliance unless all panels are properly intact The appliance is not to be used by children without adult supervision This appliance must be connected to an approved electrical outlet with 220 240V power source Do not repair or replace any part of the appliance this can only be done by an authorised technician To reduce the risk of electric shock or fire do not use extension cords or adapters to connect the unit to electrical power source For washing machines having ventilation openings in the base the installation instructions shall state that the openings must not be obstructed by a carpet Use the hoses provided If this appliance is supplied from a cord extension set or electrical portable outlet device the cord extension set or electrical portable outlet device must be positioned so that it is not subject to splashing or ingress of moisture OPERATING INSTRUCTIONS Parts and Features Top lid 7 Balance ring 13HotWater Inlet Valve 2 Control panel Inner tub 3 Levelling feet 9 Agitator 4
4. Door switch 9 Drain hose joint 5 Bleach injection inlet D Power Cord 220Volt 50Hz 6 Outer tub cover 12 Cold Water Inlet Value Operating Instructions Program Select 7 Off Wash Rinse Cycle Progress Super Normal Spin Only Hot Cold Large Soak eal oe Medium Wash old Co Small Rinse us Whites Quick SH 9 Delicate Extra Small vr Load Size Colors Heavy Duty ea Temperature Wash Rinse 1 To select inlet water temperature for wash and rinse Selection here may vary per the cycle chosen All selections are not available in all cycles Load Size Water Level 2 Load Size Water levels may be set at the beginning of the wash or in pause mode During Soak Wash or Rinse press this button to manually replenish water Release for the water to stop Function automatically is inactive when water reaches the overflow protection level Cycles 3 Normal Use this cycle for normally soiled cottons and mixed fabric loads Whites Use this cycle for white and light colored clothing Colors Use this cycle for lightly soiled dark or highly dyed natural fabrics such as cotton that may be susceptible to dye loss e Heavy Duty Use this cycle for heavily soiled durable garments Also this cycle could be used for towels sports gear childrens clothes etc Delicate Use this cycle to wash lightly soiled garments and delicate clothes that need gentle washing Quick Use this cyc
5. Haier Washing Machine USE amp CARE GUIDE MODEL HWM75TLA TABLE OF CONTENTS PAGE IMPORTANT SAFETY INSTRUCTIONS 2 3 OPERATING INSTRUCTIONS e 4 Partscand d riu e 4 Operating instructions ee ERREUR 5 CARE AND CLEANING 7 Cleaning and 2 112 7 Moving amp Vacationing 8 TROUBLE 5 22 2 8 INSTALLATION 1 10 Tools and Materials 10 Unpacking Your Washer eeeeeeseeeeeeeeeee eee Levelling Your Was We rises 1 Steps for Ista lAtiONs 12 ELECTRICAL 6 14 Power INterruptions ccss sccccssoceccssosccecsasseceesoaucecsssseceedies eaa 14 5 Back Cover IMPORTANT SAFETY INSTRUCTIONS Warning To reduce the risk of fire electric shock or injury when using your appliance follow basic precautions including the following I Read all instructions before using the appliance 2 This appliance is not intended for use by persons including children with reduce
6. d physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance 3 Use this appliance only for its intended purpose as described in this user and care guide 4 Use only detergents or softeners recommended for use in this appliance and keep them out of the reach of children 5 This appliance must be properly installed in accordance with the installation instructions before it is used 6 Never unplug your appliance by pulling on the power cord Always grasp the plug firmly and pull straight out from the outlet 7 Replace worn power cords loose plugs and power outlets immediately 8 Unplug your appliance before cleaning or before making any repairs Repairs should only be done by authorised technician 9 Do not operate your appliance when parts are missing or broken 10 Do not tamper with controls I Il not operate your appliance in the presence of explosive fumes or toxic flammable vapours 12 Do not use hot water that exceeds 60 C in temperature This refers to hot water entering the machine If temperature cannot be controlled use WARM wash only 2 14 2 22 23 24 25 Do not use this appliance to wash clothes which are stained spotted or washed in gasoline dry cleaning
7. eaters cooking appliances etc Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer The washer must be placed at room temperature You must not place washer where the temperature is at below freezing For this machine having ventilation openings in the base make sure the openings must not be obstructed by a carpet Installing Your Washer Read installation instructions carefully before installation 1 not use water inlet hoses without a flat washer on each end The washer in the coupling has to be placed firmly Flat water inlet hose washers are preinstalled in each end of the water inlet hoses New hose sets supplied with the appliance are to be used and that old hose sets should not be reused NOTE You may have to use pliers to tighten the coupling Do not over tighten because you may cause damage to the valve Cold water inlet hose Hot water inlet hose 2 Connect the hot and cold water inlet hoses to the hot and cold water faucet 12 3 Install the drain hose to the back of the washer using the drain hose clamp provided The drain hose must be placed into a drain pipe or sink at least 3 5cm in diameter Use the goose neck to fix the hose in place To avoid possible flush back of water the drain hose must be fixed ata minimum height of 1000mm and a maximum height of 1500mm Water Inlet Goose Neck Water Supply Hose Drain Hose
8. erature add detergent as wash tub is being filled with water Reduce detergent dosage or pre dissolve detergent before adding to wash Spots or stains on your clothes this is due to incorrect use of fabric softener Refer to manufacturers instructions on the container and follow directions Clothes are grayed or yellowed this may be due to not using sufficient detergent for large loads Add more detergent to the load Clothes are ripped amp holes excessive wear amp tear this may be due to sharp objects left in washing Remove all small loose sharp objects fasten belts zippers metal snaps etc Check if you are using undiluted bleach Never add undiluted bleach to wash LED Display Notes Trouble Codes Reasons Rinse and spin indicators flash Unit does not drain or the speed of draining is too slow The washer is out of balance Please open the lid All progress indicators flash andrebalancethe load All load size water level indicators flash The water inlet time exceeds the preset time Small and Extra Small load size Water overflow protection water level indicators flash P Super and Large load size water level indicators flash The water level sensor fault Call service Beeps Top lid not close properly INSTALLATION INSTRUCTIONS Tools and Materials Required You will need to have following tools to help you with the installation o
9. eveling legs clockwise all the way in Move and store your washer in upright position only To prevent mold or mildew leave lid open so moisture inside machine can evaporate Insert transporting bolts if you are relocating the washer Ensure removal prior to usage TROUBLE SHOOTING If washer does not operate Check the unit is plugged in The plug may have come loose Check if the electrical wall receptacle is of proper voltage Check if the circuit breaker needs to be reset or if the fuse needs replacing Check if the washer is overloaded load may need to be re arranged or redistributed evenly Check if the lid is open You may have to close the lid properly The washer pauses in some cycles This is normal in delicate or hand wash cycles which has short period of time You will not hear washer operation for a short period of time When the soak time is over it will start automatically Problems with water Not enough water coming out Water faucet may need to be completely turned on Hoses may be tangled or kinked Straighten out hoses Check water level selection it may need to be readjusted Water temperature is incorrect Check your water heater temperature Hot water needs to be at a temperature of at least 20 F 140 F 49 C 60 C Check to make sure the inlet hoses are properly connected E g Hot to hot amp cold to cold Water leaks This may be due to incorrectiy installed drain hose or
10. f your washer Pliers Wrench Tape Measure Gloves Level 10 Accessories Supplied Quantity I Hot amp Cold inlet hoses 2 2 Drain Hose Hook 3 Pipe Clip brace 4 Outer Drain Hose uy mW Unpacking Your Washer Remove all packing materials This includes the foam base and all adhesive tape holding the washer accessories inside and outside Open the top lid to remove the drum brace Pull to remove NOTE Save drum brace Reinstall when moving the washer Inspect and remove any remains of packing tape or printed materials before using the washer WARNING To avoid danger of suffocation keep plastic bag and other packing material away from babies and children Do not use this bag in cribs carriages and playpens The plastic bag could block nose and mouth and prevent breathing This bag is not a toy Leveling Your Washer Your washer has 4 leveling legs which are located on the four bottom corners After properly placing your washer in its final position you can level your washer Leveling legs can be adjusted by turning them counterclockwise to raise your washer or turning them clockwise to lower your washer Adjustable foot High Low WARNING Leveling of washer is very important to prevent vibration during spin Steps for Installation Select a suitable location for the washer on a hard even surface away from direct sunlight or heat source e g radiators baseboard h
11. fill hoses Your home drain may be clogged You may need to tighten hoses check the plumbing or call a plumber for assistance Water will not drain This may be due to not installing your drain hose correctly Check the position of the drain hose order to drain properly make sure that top of drain outlet is less than 5 ft 1 5 m above the floor Washer is making noise Washer may need to be reinstalled Check washer installation section Washer load may need to be re balanced as the load may be uneven Coins loose change buttons or other heavy objects could create noise related sounds Squealing sound Due to overloaded wash tub Vibration Noise may be caused by not leveling washer properly on the floor or uneven distribution of clothes in the tub Normal Operating Sounds The following sounds are normally heard during the operation of the washer Tumbling sounds This is normal as the heavy wet clothes in the washer are continuously being lossed around Air rushing noise This happens when the washer tub spins at very high speeds Wash and Rinse cycles going on and off will also make clicking sounds Problems with clothes Clothes become excessively creased this is due to improper sorting overloading or washing in excessively hot water repeatedly Avoid overloading and resort your load Wash in cooler water Soap residue detergent may not be dissolved in water Check water temp
12. le to wash small lightly soiled loads that are needed in a hurry Spin only Use thiscycle to remove excess water from clothes For certain delicate and cotton clothes that you do not wish to put in the dryer this is an ideal cycle Process Status 4 This shows the current cycle status of the wash load Extra Rinse 5 Press button once to activate Press again to deactivate n this option the wash load will go through one extra rinse at the end of the cycle An Extra Rinse will automatically be added to the Whites Cycle Loading the Washer When loading the clothes into your washing machine there are a few points to remember Separate the white from the colored items Separate heavily soiled items from light or delicate items Carefully check all pockets and cuffs for small items Remove pins and other sharp objects from clothing to avoid damages to the interior parts Pre treat all stains and heavily soiled areas for better result Load each item loosely For better results load smaller items in first followed by larger items Do not overload the washer When loading wet items keep water level high enough so items can float easily in the water Close the lid after loading the laundry With the lid open the washer will not start Note Please only use a low sudsing or high efficiency type detergent Bleach use and dispenser Bleaching of clothes can help remove stains heavy s
13. oiling and kill bacteria Bleach should not be used on silk wool rayon or drip dry clothes Bleach dispenser is located on the front corner under the lid Fill the dispenser with the manufacturer s recommended dosage during the first water fill Be careful not to spill undiluted bleach onto the washer cabinet or your clothes Note Use only liquid bleach in dispenser CARE AND CLEANING GUIDE Warning Always unplug your washer to avoid electric shock before cleaning Ignoring this warning may result in injury Before using cleaning products always read and follow manufacturer warnings to avoid personal Injury or product damage Cleaning and Maintenance Use only a damp or sudsy cloth for cleaning the control panel To avoid any kind of damage to cabinet finish wipe washer cabinet as needed If you spill liquid powdered softener bleach or detergent on the cabinet wipe cabinet immediately Do not use any abrasive harsh chemicals ammonia chlorine bleach concentrated detergent solvents or metal scouring pads These chemicals may dissolve damage and or discolor your washer Leave lid open after washing to allow inside of washer to dry and assist in preventing unwelcomed bad odours 7 Moving amp Vacationing Turn off water supply at the faucet and disconnect hoses Drain water from all hoses Disconnect electrical plug Dry inner wash tub If moving washer disconnect drain hose Turn the l
Download Pdf Manuals
Related Search