Dyson DC02 Vacuum Cleaner User Manual
Contents
1. Check both electrostatic filters whenever the bin is emptied and replace at least every months Please note that if the filters are not checked regularly and changed as required the motor may overheat which will cause the thermal cut out to operate NOTE Vacuuming builder s dust and some carpet fresheners may cause the filters to require changing more frequently Dyson does not recommend the use of carpet fresheners Replacement filters are available from your local retailer or direct from Dyson Call or fax the Helpline for orders IMPORTANT Use only genuine Dyson filters which have been tested and approved for this cleaner Your Dyson has a built in thermal cut out to protect it in the event of a restriction to the airflow and may suddenly stop working temporarily if you do not change the filters at the stated time or if blockages are not cleared immediately If the vacuum cleaner suddenly stops working ie the motor makes no sound when switched on then please check your cleaner for blockages as Check that your supply corresponds to that shown on the rating plate The appliance must only be used as rated it should be fitted with an ASTA approved fuse to BS1362 European conformity information A sample of this product has been tested and found to be in conformity with the following European Directives 73 23 EEC Low voltage safety Directive 93 68 EEC CE Marketing Directive and 89 336 EEC EMC D2. months or if filters are heavily coated with dust Price correct at time of printing 2 Lift clear bin out of machine Remove cyclone top lid 1 Check entry swivel by pressing yellow buttons amp pulling out hose Clear any debris feiss 1 Hose amp wand assembly Assemble hose and wand by fitting together at joints O and Push yellow cuffs in until both buttons click into place oes LERAP The plug is situated underneath the tool cover on the right hand side On off switch Press left switch 2 Check wand handle swivel MS by pressing yellow buttons and E N yp gy A pulling hose from wand Clear gt J any debris y 4 Wrap a plastic bag O Invert clear bin and wait at least 3 Check wand joint Sa by pulling wand ey Vip mn and wand handle 9 apart Clear any blockage y with rod or wire tightly around the rim 10 seconds before releasing Press buttons and pull hose to release of the clear bin OPTIONAL Tool storage Press yellow release catch to open the tool storage cover and insert required tool into end of wand or wand handle Please note that tools may feel warm when machine has been running this is perfectly normal iF i S TTB A Self adjusting Floor tool Fit floor tool by pushing firmly into end of wand 4 Remove floor tool from wand O and check for wipe
3. pick up flammable or combustible substances or place hot ashes or burning objects of any kind Do not use near such substances 4 Do not fit anything other than Dyson spare parts available on the Helpline i 11 Do not work below the cleaner on the stairs on 01666 827272 Use of non Dyson parts could invalidate your guarantee 12 Do not immerse the whole cleaner in water for cleaning The clear bin alone may be washed out after emptying Ensure this is completely dry before Do not continue to use the cleaner if any part appears to be faulty missin R f yY P PP ty g using the cleaner again or damaged In these cases contact the Dyson Helpline on 01666 827272 7 13 Static charge can occur in many ways and when vacuuming certain carpets 6 Do not put any part of the body clothes or any object near or into the 3 i 3 may generate small static charges in the clear bin These are entirely openings or moving parts of the machine Do not use the machine with any A harmless and are not associated with the mains supply To minimise any of the openings blocked with any object that may restrict the airflow effect from this do not put your hand or insert any object into the clear bin 7 Do not pull on the supply cord run over it or pull it around sharp edges or unless you have first emptied and rinsed out the clear bin with water DYSON CUSTOMER CARE TETBURY HILL Helpline 01666 827272 Facsimile 01
4. shroud holes Do not use strong blockage fee oral ce dene detergents and ensure clear bin is fully dry before replacing in machine Note The yellow bin inner should not be removed from the bin when it is cleaned Cord rewind Press right switch for cord rewind pn Za I O Replace clear bin and cyclone top and close machine pal cyclong Es Height adjustment ECHO LoS WARNING For your own safety please Use selector to adjust to hard floor n 3a remember to unplug the machine when not in or carpet Forward for carpets and a haw use and before carrying out maintenance back for smooth floors Ensure release catch clicks into position before using the vacuum cleaner or lifting the machine by the carrying handle
5. 666 827298 ee oreyaicefoi mic dell E I A R IC arg ENGLAND SN16 ORP qual Cyclon CHnoLos dyson 03 28 208 05 28 055 14 02 97 REV 1 Changing filters Your DCO 2 is fitted with two high area H level electrostatic cartridge filters Alternatively a standard S level filter may be purchased Q Insert top filter ensuring that it fits snugly against the black rubber seal on the machine H H Level Slide rear filter into the grooves and push it down fully Clear bin full mark Note Do not fill above this line sS Fiting instructions for the standard S level filters are printed on the filter itself 2 H level C gt 1 S level Automatic suction control trigger Hold the yellow trigger down to reduce suction for upholstery and curtains To maintain reduced suction press the trigger down hard until it clicks To unlock and resume full suction press down the opposite end of the trigger Sits securely on the stairs However always work above the machine on stairs for your own safety Telescopic wand Press yellow button and slide wand down to adjust length Blockage procedure Please note Any Blockage only repairs will incur a charge of 35 00 Please check your machine carefully Q To enpty clear bin pull back release catch under carrying handle and raise top of machine Check filters replace if older than 3
6. ilters at least Always replace filter at least every 3 months every 3 months detailed in this operating manual Remember also to check the fuse in the plug Having established that there are no blockages and that the filters have been replaced within the stated time leave your vacuum cleaner unplugged for 60 minutes and then try using it again If the vacuum cleaner still does not work please call Dyson Customer Care Tel 01666 827272 IMPORTANT The wires in the mains lead are coloured in accordance with the following codes Brown Live Blue Neutral As the colours of the wires in the mains lead may not correspond with the colours or markings identifying the terminals in your plug proceed as follows The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black The wire that is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red Neither wire should be connected to the earth terminal of a three pin plug which is marked with the letter E or or coloured Green or Green and Yellow Always ensure that the cable clamp is fitted and that it clamps the cable outer and NOT the coloured wires If the supply cord of the appliance is damaged disconnect the appliance from the socket outlet immediately The supply cord must be replaced and only by Dyson Appliances Ltd or their appointed agent as special purpose tools and se
7. irective For your convenience this appliance is supplied with a plug which is fitted with a 13amp fuse of the appropriate rating Never put the plug into the socket outlet without the fuse cover fitted Replacement fuse covers are available from Dyson Customer Care If the plug supplied is not suitable for your socket outlet it should be cut off and destroyed safely disposed of Warning Under no circumstances should the severed plug be inserted into a 13A socket serious danger of electric shock would result from the exposed wires The mains lead can then be shortened to the minimum required length suitably prepared and the correct style of plug to suit your household wiring system should be fitted The following wiring instructions should be followed If in doubt consult a qualified electrician Unwanted products and the environment Should you find that your product needs replacing one day or is of no further use to you think of protecting the environment Dyson will accept your old products and recycle them in an environmentally friendly way qual cyclone o yson Facsimile High efficiency H level filters Wikel arias ALWAYS UNPLUG THE VACUUM CLEANER FROM THE WALL SOCKET BEFORE INSPECTING IT Helpline 01666 827272 01666 827298 Contact for all service assistance ENGLAND S S Level Standard S level filter Always replace both f
8. rvice techniques are required DYSON CUSTOMER CARE TETBURY HILL MALMESBURY WILTSHIRE SN16 ORP jual CyClon dyson Operating manual Please read carefully before assembling or using your DCO2 vacuum cleaner Important safety instructions please read before use WHEN USING THE DYSON DCO2 VACUUM CLEANER PLEASE ADHERE TO THESE SIMPLE PRECAUTIONS BY DOING SO YOU WILL REDUCE THE RISK OF FIRE ELECTRICAL SHOCK OR INJURY 1 Do not leave your Dyson cleaner with the plug connected to a mains outlet near over hot surfaces If damaged call the Dyson Helpline Do not handle unplug when not in use Turn the cleaner off with the switch button before the cleaner or plug with wet hands moving from the main tlet e Deen ang nn a 8 Do not use the cleaner if the cord or plug are damaged or if the cleaner has been damaged dropped or has come into contact with water or any other liquid In these cases contact the Helpline 2 Always remove the plug from a mains outlet before carrying out any maintenance Do not carry out any maintenance work on the cleaner other than that outlined in this manual especially where electrical components 3 ae P RRE y P 9 Do not use the cleaner to pick up water or any other liquid Electrical shocks are concerned could occur if used outdoors or on wet surfaces 3 Do not use without the clear bin assembly fitted correctly and both filters in i 10 Do not use the cleaner to
Download Pdf Manuals
Related Search