Dimplex DXDF20L Fan User Manual
Contents
1. NING SYMBOL E INDICATING THAT IT MUST NOT BE COVERED The instruction leaflet belongs to the appliance and must be kept in a safe place If changing owners the leaflet must be surrendered to the new owner IMPORTANT If the mains lead of this appliance is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard WARNING In order to avoid a hazard due to inadvertent resetting of the thermal cut out this appliance must not be supplied through an external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility Electrical connection This heater must be used on an A C supply only and the voltage marked on the heater must correspond to the supply voltage This heater is fitted with a plug incorporating a 13 amp fuse When replacing the fuse a 13 amp fuse approved by ASTA to BS 1362 must be used If the plug is not suitable for the socket outlets in your home the plug must be cut off and an appropriate one fitted A plug cut off from a mains lead will give a shock hazard if inserted into a 13 amp socket elsewhere in the house To avoid this it should be disposed of immediately NOTE The fuse cover of a non rewirable plug must be refitted when changing the fuse Should the cover become lost the plug must not be used until the correct replacement fuse cover is obtained from your supplier or by contac2. X lt Dimplex DXDF20 DXDF20L DXDF20 amp DXDF20L Designer Fan Heaters with Climate Control 08 35104 0 Issue 0 C The product complies with the European Safety Standards EN60335 2 30 and the European Standard Electromagnetic Compatibility EMC EN55014 EN60555 2 and EN60555 3 which cover the essential requirements of EEC Directives 73 23 and 89 336 DXDF20 amp DXDF20L 2kW Fan Heater THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE IMPORTANT SAFETY ADVICE DO NOT use the heater on deep pile carpets or the long hair type of rugs or less than 750mm away from any overhanging surface Keep combustible materials such as drapes and other furnishings clear from the front sides and rear of the heater Do not use heater to dry your laundry DO NOT use the heater in the immediate surroundings of a bath a shower or a swimming pool DO NOT place the heater directly below a fixed socket outlet The socket outlet must be accessible at all times to enable the mains plug to be disconnected as quickly as possible DO NOT COVER or obstruct the air inlet and outlet openings in any way The heater must be on a flat stable surface when in use DO NOT operate the heater with the mains lead overhanging the front outlet grille NEVER leave the heater unattended when it is used by or near the aged infirm person s or children THE HEATER CARRIES THE WAR
3. ars on the left hand side Use buttons 3 and 4 to set the desired room temperature when Low or High heat is selected The temperature can be set from 5 C to 35 C and this will be shown on the display When the temperature is reached the heater will automatically switch off If the ambient temperature drops the heater will come on again automatically Note the electronic climate control device conserves energy and assists with temperature regulation e g if the heater is set to HIGH heat and the temperature is set to 28 C at 27 C the heater will switch to LOW heat Then at 28 C the heater will switch OFF completely An audible beep can be heard when any button is pressed A double beep can be heard when 5 and 35 is selected the upper and lower limits By keeping buttons 3 and 4 pressed down the user can scroll quickly to the desired temperature Note The heater retains it s last setting once the appliance has been switched off or disconnected from the power supply Overheat cut out The built in overheat cut out switches off the appliance automatically in the event of a fault Disconnect the mains plug from the socket After a short cooling down phase the appliance switches into stand by mode and is ready for use again If the fault should occur again see your local dealer Cleaning WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER Do not use detergents abrasive c
4. is may result in loss or damage and delay in providing you with a satisfactory service Please retain your receipt as proof of purchase Glen Dimplex UK Limited Millbrook House Grange Drive Hedge End Southampton Hampshire SO30 2DF Customer Services Republic of Ireland c Glen Dimplex UK Limited UK customer help line 8 00AM 6 00PM Mon Fri 8 30AM 1 00PM Sat 0870 7270101 0870 7270102 e mail customer services glendimplex com 01 8424833 All rights reserved Material contained in this publication may not be reproduced in whole or in part without prior permission in writing of Glen Dimplex UK Limited
5. leaning powders or polish of any kind on the heater Wipe with a dry cloth to remove dust and a damp cloth not wet to clean off stains Be careful not to allow moisture into the heater Ensure that dust or fluff does not accumulate inside the heater as this could lead to overheating of the element Use a vacuum cleaner to remove any fluff which does accumulate Recycling For electrical products sold within the European Community At the end of the electrical products useful life it should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice in your country After Sales Service Your product is guaranteed for three years from the date of purchase Within this period we undertake to repair or exchange this product free of charge provided it has been installed and operated in accordance with these instructions Your rights under this guarantee are additional to your statutory rights which in turn are not affected by this guarantee Should you require after sales service you should contact our customer services help desk on 0870 727 0101 It would assist us if you can quote the model number series date of purchase and nature of the fault at the time of your call The customer services help desk will also be able to advise you should you need to purchase any spares Please do not return a faulty product to us in the first instance as th
6. ting our customer helpline IMPORTANT The wires in this mains lead are coloured in accordance with the following code BLUE NEUTRAL BROWN LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings in your plug proceed as follows Connect the BROWN wire to the terminal marked L or coloured RED Connect the BLUE wire to the terminal marked N or coloured BLACK Note L or N must not be connected to the EARTH terminal marked E or or coloured GREEN or GREEN AND YELLOW If in doubt consult your electrician General The heater has a loading of 2kW Heat output and temperature control on this appliance are provided using the electronic control With the unit plugged in and by pressing the STAND BY button see 1 in Fig 4 the heater can be turned on The appliance is provided with a handle for easy carrying see Fig 3 Operation see Fig 4 The heat output is electronically controlled according to the room temperature To switch the appliance On Off press button 1 Press button 2 to select Fan only Low heat High heat By pressing this button once Fan only is selected pressing twice provides Low heat and by pressing three times High heat is selected On the display screen see Fig 4 two temperature readings appear at the top of the screen The room ambient temperature appears on the right and the desired temperature appe
Download Pdf Manuals
Related Search