User`s Manual
Contents
1. Non contact AC Voltage and Metal Detector User s Manual CAUTION using this appliance in an environment with a strong radiated radio frequency electromagnetic field approximately 3V m may influence its measuring accuracy the measuring result can be strongly deviating from the actual value Read understand and follow Safety Rules and Operating Instructions of the manual before using WARNING BE EXTREMELY CAREFUL IN THE USE OF THIS DEVICE Improper use of this device can result in injury or death Follow all safeguards suggested in this manual in addition to the normal safety precautions used in working with electrical circuits DO NOT service this device if you are not qualified to do so SAFETY SYMBOLS A Important safety information refer to the operating manual Earth ground SPECIFICATIONS AC Voltage rang 20V 1000V AC 50 500Hz Metal detection distance gt 20mm Sound and light instructions Adjustable sensitivity Setting the default sensitivity Low battery detection Auto power off Designed to international safety standard EN61010 1 600V CAT III Battery 1X12V A23S Type alkaline battery Operating Temperature 32 to 122 F 10 to 50 C Storage Temperature 4 to 140 F 20 to 60 C Humidity lt 85 RH Dimensions 157 X24X20mm Weight APPROX 45g BATTERY INSTALLATION 1 Open the battery door end cap by gently prying up out at the pocket clip using a small screwdriver 2 Insert two AAA alkaline battery batter2. ies observe polarity 3 Replace the battery door NOTE If your meter does not work properly check the battery to make sure if it is still good and that it is properly inserted WARNING To avoid electric shock do not operate the meter until the battery cover is in place and fastened securely WARNING The measurement must be done only with the cap on the probe tip OPERATING INSTRUCTIONS WARNING When you detecting the High voltage circuits both AC and DC are very dangerous and should be measured with great care Keep hands and fingers on the body of the probe and away from the probe tip Before testing AC Voltage or Metal Object Before using to check for AC voltage or metal object the detector must be tested on a known voltage source or on a known metallic object to make sure it is operating properly Select detecting mode 1 Press the power switch 4 to turn the detector on By default it is under AC Voltage detecting mode If you press the button 3 and hold it for two seconds the detector will change into metal object detecting mode You may press the button 2 and hold it for two seconds to change the detector back to AC Voltage detecting mode To check AC electrical voltage in a socket 1 Press the power switch 4 to turn the detector on select the AC Voltage detecting mode The red LED will light And than setting sensitivity by press the button 2 to the high sensitivity or press the button 3 to the low sensitivity Once yo
3. u press the button 3 or button 2 make sure holding it less than 2 seconds 2 Touch the probe tip 1 to a cord plugged into the socket or insert into the socket hole If AC electrical voltage is present the detector light will flash and the buzzer will beep 3 If you want to change the default sensitivity of the detector you may first set the detector to a proper sensitivity and than press the button 2 and the button 3 at one time and hold it for two seconds the detector will save the sensitivity to default sensitivity itself To check and find Metal Object 1 First press the power switch 4 to turn the detector on and than select the metal object detecting mode by pressing the button 3 and hold it for two seconds at this time the green LED lit 2 Move the detector slowly and smoothly across the surface area 3 If metal object is present the red LED will flash and the buzzer will beep Auto power off If there s no any uperauon ana no AL vonage UF mera Ovject is Uetected within fifteen minutes after power is on the meter will auto power off with buzzer beep and the red LED flash Low battery detection Instrument state at boot when the battery power less than 9V Green LED slow flashing Prompted low battery power at low battery power state of the instrument does not guarantee the accuracy of the measurement results
Download Pdf Manuals
Related Search