User manual
Contents
1. gt AE f YC tne USERGUIDE VELA TANGO 100 100FB 100A 20A 1 0 INTRODUCTION se 1 1 5 1 3 UNPACKING THE 8 1 4 MAINTENANCE VELA TANGO 1 5 GENERAL INSTRUCTIONS TRAINS 1 5 2 Stabilityand Dalane 0 2 be wen Gee Ged Wie OU Seine oo ele Ge aoe Ae BE ee eek 159A COORONG 4 doe de eae a det Shea ebb eed ee ew a 1 6 VELA TANGO USERMANUAL 1 7 TECHNICAL 5 1 0 INTRODUCTION Dear customer Thank you for choosing VELA Tango which is certain to give you years enjoyable use The user manual contains useful information on set up operation maintenance technical data etc This user manual describes VELA Tango 100 100FB 100A 200 Important Please read this manual carefully and keep it for future reference It must always be readily available to the user This user manual must always be kept with the chair The manual is also a2. basis at work or in the home It is intended for quiet seated work All movements in VELA Tango have a bearing on the chair s centre of gravity To enhance safety we recommend the following e Maximum user weight is 125 kg however the level of activity is a key factor A person with extreme movements in the chair should contact a sales consultant before purchase e The chair is not intended for standing on e When moving the chair it should always be locked 1 5 3 RECYCLING Many of the materials used in the chair s construction can be recycled Deliver the chair to VELA or our local recycling centre 1 6 VELA TANGO USERMANUAL 4 SEAT HEIGHT To adjust the seat height just push the lever placed at your right hand The gas spring should always be replaced by a VELA technician or other qualified person with relevant experience lt SEAT TILT The seat tilt is changed by using the lever placed in the right side behind the armrest lt SEAT ROTATION SOME MODELS You can rotate the seat 90 to the left and 90 to the right by using the lever placed at your left hand Pull out the lever to use the open rotation 4 BACK TILT The back tilt changed by using the lever placed the right side 4 BACK HEIGHT The back height is changed by using the lever which 15 placed on the back of the chair Remember to tightend the lever again 4 BRAKE VELA Tango has centralbrake The hand brake is pushed torwa
3. f defects or trans port damage to the chair please contact VELA immediately You must not try to repair any damage yourself or start using the chair The box in which the chair was supplied should contain VELA Tango fitted with any additional accessories This user manual 1 4 MAINTENANCE OF VELA TANGO We recommend that you have your VELA Tango serviced once a year to identify any defective or worn parts However removable parts should be regularly checked and tightened Wheels Wheels should be regularly checked and cleaned of any fluff etc Base Wash with a mild solution of lukewarm water and pH neutral washing up liquid Upholstery The fabric needs to be vacuumed occasionally and wiped with a cloth rinsed in clean water and tightly wrung Make sure to remove any stains as quickly as possible Always use a moist clean white cotton cloth For more stubborn stains use a bit of mild washing up liquid Any incontinence cover should be machine washed on a gentle cycle 1 5 GENERAL GUIDELINES To ensure correct use of the VELA Tango please note the following 1 5 1 TRANSPORTATION Always remember to lock the chair in position when transporting VELA Tango No one should sit in the chair while it is being transported Temperature during transport 40 degrees to 70 degrees Humidity 15 95 Air pressure ppp up to 1 000 metres above sea level 1 5 2 STABILITY AND BALANCE VELA Tango is designed to be used on daily
4. om 4ax4scn _ 3 9838 Sitting height 38 48 cm 38 48 cm 40 55 cm 40 55 cm 40 55 cm 42 57 cm 42 57 cm 42 57 cm 47 67 cm 47 62 cm 47 62 cm 47 62 cm 47 67 cm 47 67 cm 52 67 cm 52 67 cm 52 67 cm 38 48 cm Interval regulation 2 10cm 2 10 cm 2 10 cm not on Tango 100FB E wom 286 zo WO VELA Goeteborgvej 12 9200 Aalborg SV Denmark 45 96 34 76 mail vela dk www vela eu Tango 100A VELA Tango 200 VELA Tango 100 100 200 2 2009 0
5. rds to lock the wheels and backwards to release them The brake can easily be changed the other side if requested Just remove the rubberstop and place the brake in the hole 6 ARMREST The height as well as the width of the armrests can be adjusted 4 HEIGHT ADJUSTMENT The height is adjusted by loosening the lever Remember to tighten them well again 4 WIDTH ADJUSTMENT The width 15 set by loosening the lever under the seat and adjusting the width Remember to tighten the levers again 4 BACK ANGLE ONLY VELA TANGO 200 The back angle on VELA Tango 200 can be locked in the needed position by adjusting the lever on the back lt ADDITIONAL ACCESSORIES 4 FOLDING FOOT RING Push the foot ring with the foot to make swing either up or down IMPORTANT Weight must not be placed on the foot ring while entering and exiting the chair as this can cause the chair to tip over 1 7 TECHNICAL DATA CONSTRUCTION Arched steel frame made from profile tubing ensures that all the wheels remain in contact with the floor even on uneven surfaces Each wheel is secured with a wheel spindle in a tower Outer tubing in lacquered steel with indications for height regulation Height adjustment with telescopic actuator VELA Tango 100 VELA Tango 100FB Height adjustment Gas 350N Gas 350N Gas 500N AA AA Gm Coxit seat with 47 x 49 cm two adjustable levers 44 x 44 saw ens gt om
6. vailable on VELA s website www vela eu If you have any questions please contact VELA You can also find information about VELA Tango on website www vela eu Safety This chair carries the CE mark and complies with all current EU regulations The chair is made by VELA Vermund Larsen A S Goeteborgve 12 9200 Aalborg SV Denmark The VELA Tango is designed for indoor use by people with slight disabilities VELA reserves the right to make changes 1 1 This chair carries the mark complies with all current EU regulations The chair is made by VELA Vermund Larsen A S Goeteborgvej 12 9200 Aalborg SV Denmark The VELA Tango chair is designed for use by people with slight disabilities 1 2 WARRANTY VELA refers to the Danish Sale of Goods Act with regard to warranty The warranty applies only if original spare parts and accessories are used and always provided that adjustments are carried out by authorised service technicians VELA assumes no liability for damage to the product or injury to the user as a result of e Transport Misuse Ordinary wear and tear Incorrect use Using non original spare parts and accessories Adjustments carried out by unauthorised service technicians 1 3 UNPACKING THE CHAIR VELA Tango 15 supplied in cardboard packaging which 15 developed and produced to ensure the least possible impact on the environment and with focus on ease of use In case o
Download Pdf Manuals
Related Search