9845 - DealerWorks Inc.
Contents
1. Horn Siren Output Horn Siren Door Lock Unlock Pulse 800ms DL Pulse 3 5 S DL Pulse L 800ms DL Pulse 800ms Dbl D U L Pulse Function Transmitter Button s Lock Unlock Button 1 O Button 2 Option Button Panic Button 1 L Button 2 Option Button Remote Trunk Release Button 1 Button 2 Option Button Remote Window Close Button 1 Button 2 LJ Option Button Remote Garage Door Opening _ Button 1 Button 2 L Option Button Remote Engine Starter Button 1 Button 2 Option Button SYSTEM FUNCTIONS AT A GLANCE LED INDICATORS RAPID FLASHING SLOW FLASHING OFF ON SOLID PASSIVE ARMING ARMED DISARMED VALET MODE OPTIONAL VEHICLE HORN OR SIREN CHIRP INDICATION 1 CHIRP ARM 2 CHIRPS DISARMED CONTINUOUS PANIC MODE ALARM PARKING LAMP INDICATIONS 1 FLASH ARM 2 FLASHES DISARM CONTINUOUS FLASH PANIC MODE 2002 Audiovox Corp 128 6190 Page 6 128 6190 6 of 62. Model PRO 9845B EME Owner s Manual SSS SS 3 Button Remote Keyless Entry System With Two Auxiliary Outputs FEATURES 2 Three Button RF Transmitters Four Channel Code Learning Receiver Remote Panic In All Modes Built In Parking Light Output LED Status Indicator Ignition Door Locking Unlocking Horn Output OPTIONS Remote Trunk Release Remote Power Window Control Remote Garage Door Interface Remote Engine Starter Starter Interrupt Siren Access Guard 2 Step Unlock Illuminated Entry Page 1 128 6190 1 of 6 Changed 1 23 02 note No Rev was Required Corrected 2 15 02 note No Rev was Required Your PRO 9845B Keyless Entry System has many features and available options some of which must be selected at time of installation For your reference the list on the back page of this manual shows what features and options have been installed with this particular system Consult your installing dealer for op tions that may have been installed and are not listed REMOTE DOOR LOCKING ACTIVE 1 Turn the engine off exit the vehicle and close all doors 2 Press and release the lock button of your key chain transmitter one time the doors will lock the parking lights will flash once the vehicle s horn or optional siren will chirp once and the dash mounted LED will begin to flash slowly confirming the system is locked SILENT LOCKING ACTIVE 1 Turn the engine off exit the vehicle and close all d
3. off before you started the siren will emit one short chirp indicating that the chirps are now on REMOTE PANIC OPERATION The lock and unlock buttons of your keychain transmitter also serves as panic buttons and will cause the vehicle horn or optional siren to sound on demand To use the panic feature you must be within the system s maximum operating range In an emergency situation to use the panic feature press and hold the lock or unlock button of your keychain transmitter for 3 seconds This will cause the lights to flash the vehicle horn or optional siren to sound and if the optional interior illumination circuit was installed the interior lights to flash The panic mode will continue for 30 seconds and then reset To disengage the panic feature before the 30 seconds are up press and hold the lock or unlock button of your keychain transmitter for 3 seconds or press the Option button momen tarily The doors can be unlocked or locked while in panic feature by momentarily pressing the lock or unlock button respectively ADDITIONAL REMOTE FUNCTION CHANNEL 3 The system has an additional output Channel 3 that can be connected to a number of different optional accessories Some of the more common uses for this channel are Q Remote Trunk Release Q Remote Window Close Page 4 128 6190 4of6 To operate the accessory associated with Channel 3 press and hold the Option button of your keychain transmitter for
4. four seconds NOTE You may access the Channel 3 command regardless of whether the system is locked or unlocked but not when the ignition switch is in the on position This is to prevent the output from accidentally opening the vehicle s trunk when the vehicle is in motion ADDITIONAL REMOTE FUNCTION CHANNEL 4 The system has an additional output Channel 4 that can be connected to a number of different optional accessories Some of the more common uses for this channel are Q Remote Engine Start OQ Remote Window Close Q Remote Garage Door Interface To operate the accessory associated with Channel 4 simultaneously press both buttons of your keychain transmitter which were configured and progeammed for this function NOTE The channel 4 output will remain active for as long as the transmitter buttons are held Certain accessories may take advantage of the extended output capability of this channel To discontinue the output simply release the transmitter buttons IGNITION DOOR LOCKING UNLOCKING The system is capable of being programmed for the added safety and security of ignition controlled door locking and unlocking These features are separate so the unit may be programmed for one or both or neither When the ignition door locking feature is programmed the system will cause all door locks to lock whenever the ignition switch is turned from the off to on position providing that all doors are closed at that time All doors wil
5. ition at any time the ignition switch is in the on position Page 3 128 6190 3 of 6 Note In the event that you lose your keychain transmitter or the transmitter fails to operate the keyless entry system the valet switch can be used to override the optional Starter Interrupt and therefore allow the engine to be started To override system 1 Open the door with the vehicle s door key 2 Turn the ignition switch to the on position 3 Flip the valet override switch to the on position The system will disarm allowing the engine to be started and the vehicle to be operated normally Always remember to move the valet switch to the off position to allow the passive arming and optional starter interrupt features to be operable the next time you park the vehicle ELIMINATING THE LOCK UNLOCK CHIRPS You can selectively eliminate the normal lock and unlock chirps by holding the transmitter button slightly longer when locking and unlocking This will prevent the siren chirps for one lock or unlock cycle If you find this inconvenient and wish to eliminate these chirps perma nently 1 Start with the valet switch in the off position 2 Turn the ignition switch on then off 3 Within 10 seconds of turning off the ignition flip the valet switch on off on off on off 4 If the chirps were on before you started the siren will emit 2 short chirps indicating that the chirps are now off If the chirps were
6. l lock approximately 3 seconds after the vehicle s ignition switch is turned on This is a nice feature for maintaining the personal safety of the occupants of the vehicle in an effortless and automatic manner When the ignition door unlocking feature is programmed the system will cause all door locks to unlock whenever the ignition switch is turned from the on to off position All doors will unlock immediately after the vehicle s ignition switch is turned off If 2 Step unlock was installed only the driver s door will unlock As stated these features are programmed separately so you may chose to use one both or neither Please consult with your dealer to consider your options TWO STEP UNLOCK ACCESS GUARD By pressing the unlock button of the keychain transmitter as you would normally Please see the section titled Unlocking The System earlier in this manual the system will disarm and only the driver s door will unlock If however you should then decide instead that you want all doors to unlock you can simply press the unlock button a second time and all doors will unlock Page 5 128 6190 5 of 6 Feature And Function Settings To Be Completed By Installer Feature Setting Passive Active Arming L Passive Active Ignition Door Locking On Off On Off Ignition Door Unlocking On Off LJ on Off Chirps On Off On LJ Off Passive Door Locking On Off
7. nterior light will turn on for 30 seconds or until the ignition key is switched on Note If the passive arming mode was selected at time of installation the dash mounted LED will start flashing rapidly indicating that the system is rearming Opening any door will suspend the automatic arming OPTIONAL ACCESS GUARD Two Step Unlock If the optional 2 step unlock feature was installed then only the driver s door will unlock after the first press of the unlock button If you want to unlock all doors you can simply press the unlock button of the keychain transmitter a second time Two Step unlocking is an optional feature that must be wired upon installation VALET PROGRAM MANUAL OVERRIDE SWITCH The valet switch allows you to temporarily prevent the system from arming eliminating the need to hand your keychain transmitter to parking attendants or garage mechanics When the system is in the valet mode it will not passively arm or activate the starter interrupt circuit However all keyless entry features as well as the remote panic feature will remain operational To enter the valet mode 1 Start with the valet switch in the off position 2 Turn the ignition switch to the on position 3 Flip the valet switch to the on position The dash mounted LED will turn on solid not flashing indicating that the valet mode has successfully been entered To return to the normal mode of operation move the valet switch to the off pos
8. oors 2 Press and hold the lock button of your key chain transmitter for two seconds the doors will lock the parking lights will flash once and the dash mounted LED will begin to flash slowly confirming the system is locked The horn or optional siren will not chirp BACKUP PASSIVE OPERATION AUTOMATIC If the passive arming feature has been selected Turn the engine off exit the vehicle and close all doors The dash mounted LED will immediately begin to flash rapidly indicating that the 30 second passive arming timer has begun If any entry point is opened during the 30 second arming cycle arming will be suspended When all entry points are closed the arming cycle will begin again At the end of the 30 seconds the parking lights will flash once the vehicle s horn or optional siren will chirp once and the dash mounted LED will begin to flash slowly confirming the system is armed Ifthe horn or optional siren did not sound when arming then the chirps have been turned off Please refer to the section titled Eliminating the Arm Disarm Chirps later in this manual Passive door locking is a selectable feature The doors may or may not lock passively dependent upon the setup during installation PROTECTION WHILE THE SYSTEM IS ARMED If the optional Starter Interrupt relay has been installed then whenever the system is armed the vehicle starter circuit is disabled even with the ignition key the vehicle will not start Should an attemp
9. t be made to start the engine while the system is armed the starter circuit will remain interrupted Whenever the system is armed the dash mounted LED will slowly flash This serves as a visual deterrent to a potential thief This LED is a very low current light emitting diode and will not cause the battery to drain even if left unattended for long periods of time Page 2 128 6190 2of6 UNLOCKING THE SYSTEM As you approach the vehicle press and release the unlock button on the keychain transmitter the doors will unlock the parking lights will flash two times the vehicle horn or optional siren will chirp twice and the dash mounted LED will turn off If you have the optional entry illumination circuit installed the interior light will turn on for 30 seconds or until the ignition key is switched on Note If the passive arming mode was selected at time of installation the dash mounted LED will start flashing rapidly indicating that the system is rearming Opening any door will suspend the automatic arming SILENT UNLOCKING 1 As you approach the vehicle press and hold the unlock button of your key chain transmitter for two seconds or until the system responds The doors will unlock the parking lights will flash twice and the dash mounted LED will turn off confirming that the system is disarmed The vehicle horn or optional siren will not chirp If you have the optional entry illumination circuit installed the i
Download Pdf Manuals
Related Search