Pie Warmer
Contents
1. technician in order to avoid a hazard Telephone Helpline 1300 225960 Introduction Please take a few moments to carefully read through this manual Correct maintenance and operation of this machine will provide the best possible performance from your APURO product Pack Contents The following is included e Pie Warmer e Wire rack x 3 e Sliding glass door x 2 e Element Guard e Glass display panel e Water Reservoir APURO prides itself on quality and service ensuring that at the time of packaging the contents are supplied fully functional and free of damage Should you find any damage as a result of transit please contact your APURO dealer immediately Installation To install the Pie Warmer 1 Remove the Pie Warmer from the packaging Make sure that all protective plastic film and coatings are thoroughly removed from its surfaces 2 Take the glass display panel and raise it at an angle into the upper track at the rear of the unit Fig 1 3 Once at the top of the track position the bottom of the glass above the lower track Fig 2 4 Carefully lower the glass into the bottom track Fig 3 Fig 1 Fig 2 Fig 3 Fig 4 5 Slide the wire racks into the bracket on the inner side of the Pie Warmer 6 Insert the two sliding door panels in the same manner as the display panel Ensure the handles are located towards the outside edges of the appliance Fig 4 7 Connect the plug to a suitable mains socket and t2. that the product must not be disposed of as household waste To help prevent possible harm to human health and or the environment the product must be disposed of in an approved and environmentally safe recycling process For further information on how to dispose of this product correctly contact the product supplier or the local authority responsible for waste disposal in your area APURO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international d independent and federal authorities EF APURO products have been approved to carry the following symbol All rights reserved No part of these instructions may be produced or transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written permission of APURO Every effort is made to ensure all details are correct at the time of going to press however APURO reserve the right to change specifications without notice DECLARATION OF CONFORMITY Equipment Type Model Legislation Standards Producer Name Producer Address Date Signature Full Name Position Pie Warmer GF454 A GF455 A C Tick AS NZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment EN 55014 1 2006 EN 55014 2 1997 A1 EN 61000 3 2 2006 EN 61000 3 3 1995 A1 A2 EN 60335 2 37 2002 A1 EN 60335 1 2002 A11 A1 A12 A2 A13 with AS NZ
3. O agent or qualified technician The unit heats up but Indicator light is faulty Call APURO agent or qualified technician the red indicator light is Off The unit is not heating Incorrect operation Ensure up or heats up slowly thermostat has been set correctly and the indicator light is On e doors are closed e thermostat sensor bulb has not been removed or damaged Thermostat failure Call APURO agent or qualified technician Element failure Call APURO agent or qualified technician Technical Specifications Dimensions Weight Approx Heat up Operating Voltage Current hxwxd kg Pie Time Temperatu fle dl O eree kd a 50Hz 220 240V 650W 2 8A 582 x 755x390 23 28 minutes 30 90 C 50Hz Electrical Wiring This appliance is supplied with a 3 pin moulded AUS plug and lead with a 13 amp fuse as standard The plug Is to be connected to a suitable mains socket This appliance is wired as follows e Live wire coloured brown to terminal marked L e Neutral wire coloured blue to terminal marked N e Earth wire coloured green yellow to terminal marked E This appliance must be earthed using a dedicated earthing circuit If in doubt consult a qualified electrician Electrical isolation points must be kept clear of any obstructions In the event of any emergency disconnection being required they must be readily accessible Compliance The WEEE logo on this product or its documentation indicates
4. Pie Warmer Instruction manual A RAS YA ER een Ro NA een a A gt Model GF454 A GF455 A Safety Tips Position the appliance on a flat stable surface When positioning the appliance maintain a distance of 20cm 7 inches between the appliance and walls or other objects for ventilation Increase this distance if the obstacle is a heat source A service agent qualified technician should carry out installation and any repairs if required Do not remove any components or service panels on this product Consult Local and National Standards to comply with the following e Health and Safety at Work Legislation e BS EN Codes of Practice e Fire Precautions e IEE Wiring Regulations e Building Regulations DO NOT immerse the Pie Warmer in water or use jet pressure washers to clean it Always switch off and disconnect the power supply to the appliance before cleaning Always allow the Pie Warmer to cool down before cleaning maintaining or moving to avoid the risk of burns DO NOT use the appliance for anything other than its intended use This appliance must only be used in accordance with these instructions and by persons competent to do so This appliance is not suitable for use by children Keep all packaging away from children Dispose of the packaging in accordance to the regulations of local authorities lf the power cord is damaged it must be replaced by an APURO agent or a recommended qualified
5. S 60335 1 2002 A1 A2 A3 EN 62233 2008 Apuro 15 Badgally Road Campbelltown NSW 2560 I the undersigned hereby declare that the equipment specified above conforms to the above Legislation and Standard s 05 03 13 O nant Richard Cromwell Marketing Director GF454 A GF455 A AB v2
6. urn on the power supply Operation 1 Add water 0 5L to the water reservoir 2 Set the thermostat to the desired temperature 3 he unit will cycle on and off to maintain the set temperature The green indicator light and illuminated interior lamp shows when the unit is switched on The red indicator light shows when the desired temperature has been reached Cleaning Care and Maintenance e Always turn off the appliance and disconnect from the power supply before cleaning e Allow the appliance to cool before cleaning e The inner body of the appliance should be wiped down at the end of each day s operation Additional cleaning may be required depending on frequency of use e Warm soapy water is recommended for cleaning Cleaning agents may cause damage or leave harmful residues when used for a prolonged period on stainless steel e A APURO dealer or qualified technician should carry out repairs if required Telephone Helpline 1300 225960 Troubleshooting If your APURO Pie Warmer develops a fault please check the following table before making a _ Fat ProbableCause Aenean The unit is not heating The unit is not switched on Check the unit is plugged in correct up and the green and switched on Plug and lead are damaged Call APURO agent or qualified indicator light is Of solo tac service Call Fuse in the plug has blown Replace the plug fuse Power supply Check power supply Internal wiring fault Call APUR
Download Pdf Manuals
Related Search