8051323 yakima whispbar racks k323 fit kit installation instructions
Contents
1. Prorack Loads of life GB Fitting Instructions for Basic Carrier x 4 M6 x 35 mm x4 Revision No 1 2 Fitting Kt First Time Installation k D a Tia Thay a i C Ho ae Remove parts from packaging and check contents Contact your Prorack dealer if parts are missing or damaged 5 B a D This kit fits type A B C and D These instructions show type A crossbar fitted They also apply to type B C and D _ Use keys to remove covers Fitting Kt Use hex screwdriver to reverse adjusting screw 10 turns Remove clamp block by pressing backwards Fit rubber pad supplied with crossbar to foot Make sure the pad fits into the holes underneath the foot Fitting Kt Carefully select desired position for crossbars on vehicle roof Adjust crossbar in or out to suit vehicle Refer to the crossbar instructions for crossbar adjustment Apply masking tape to vehicle roof in all four positions Make sure there is no interference between what you intend to carry with aerials sunroof or tailgate Place crossbar on vehicle Minimum recommended spacing between the bars is 700mm unless otherwise stated Trace around rubber pad using a pencil or pen Repeat for all four positions Remove both pins from each leg use spanner located inside left hand cover to ass2. ist Repeat for all legs Fitting Kt While holding foot detach crossbar from foot Drill through the two holes in the foot while holding foot tight on roof in marked position Remove masking tape and place silicon sealant around drilled holes on roof for all four positions Fitting Kt Fit rivets through plastic permanent mount blocks While holding the permanent mount block firmly on roof rivet the blocks to the roof Repeat for all four positions Fitting Kt Fit plastic plugs to permanent mount blocks over rivet heads If they appear very loose glue them in place Fitment Select grubscrews and screw into the vehicle s fixed points Do not over tighten Repeat for all four positions Fit nut to grubscrew Fitting Kt Using spanner supplied with crossbar and 3mm Allen key back grubscrew off half a turn and lock nut down Assemble foot and pad to crossbar legs by re inserting pins Select plastic internal block from fitting kit and insert into foot Repeat for all legs Fitting Kt Place crossbar foot over grubscrews Tighten the red plastic knob Ensure the red plastic knob is in the position shown when fully tightened Fitting Kt Tighten adjusting screw to 5 Nm Check crossbar is securely attached to the vehicle Use keys to f
3. it and lock covers CAUTION Regularly check screws are tight
Download Pdf Manuals
Related Search