EZPull Trap User Manual
Contents
1. Base Station Check Base Station is On and paired with remote units See Setup Guide 3 6 4 Unit is in Sleep mode turn unit On See above Section 1 32. the batteries 3 5 2 The On Off key does not turn unit On Check Replace the batteries 2 Release targets Unit must be On 3 6 Unit does not throw targets 2 1 Using Voice Stand approximately 2 3 away from the unit and call Pull The left light will glow for almost 1 second indicating the command has been detected and sent to the base station 2 2 Manually Press and quickly release the Target key The left light will glow for almost 1 second indicating the command has been detected and sent to the base station Base Station Pause Play Unit must be On Each of the remote units can put the base station in Pause or Play mode When the Base Station is in Pause mode it does not release targets 3 1 Pause Hold the Pause Play I key the lights will alternate quickly When the lights go off release the key 3 2 Pause Indicator 3 6 1 Unit is On left light blinking every 1 Sec and Voice command or manual release is followed by Steady glow of left light Check the Base station and Trap machine 3 6 2 Unit is On left light blinking every 1 Sec and Voice command or manual release is followed by rapid flashing of the left light Base station is in Pause mode Perform action in Section 3 3 to put base station in Play mode 3 6 3 Unit is On left light blinking every 1 Sec but Voice command or manual released followed by both lights flashing twice No link with
3. Operating EZPull Trap Remote 1 EZPull Trap has three operating Modes EZPull Trap User Manual For Trap RC version 2 HW4 3 SW6 0 12 2013 1 1 OFF no light are blinking To turn On press and quickly release the On Off key 1 2 SLEEP The rights light blinks every 4 seconds To turn On press and quickly release the On Off key To turn Off press and hold the On Off key until light stop flashing 1 3 ON in the active mode the left light is blinking every 1 second To turn Off press and hold the On Off key until light stop flashing 3 2 1 On a Voice Release RC when attempting to release a target the left LED will flash rapidly indicating the Base Station is in Pause mode 3 2 2 Ona Puller s Switch RC both lights will flash 3 3 Play Hold the Pause Play key the lights will alternate quickly When the lights go off release the key 3 4 Check voice sensitivity Unit must be On 3 4 1 Hold the Speaker 9 key both light s will flash quickly When the lights go off release the key 3 4 2 The Right LED will flash corresponding with the sensitivity setup value 3 5 Troubleshooting and indicators 3 5 1 Low Battery If after pressing any of the keys or after releasing a target both lights flash rapidly Warning To prevent serious injury you must turn off the EZPull units before handling trap machines or standing in front of a trap then it s time to replace
Download Pdf Manuals
Related Search