MS5902 Circuit Breaker Finder
Contents
1. 3 in 1 Scanner Instruction CONTENTS Maintenance General description Front panel Specification 5 5 4555 555 5 5 1 0 Maintenance Keep clean with a dry cloth When the symbol of battery is display on the LCD please unscrew and remove cover insert new 9V battery so as to the meter is well balanced 2 0 General description The functions of meter are accurately and safely Detects wood or metal edge metal pipe and AC voltage hidden behind board 3 0 Front panel 1 Flashlight 2 Display 3 on off button 4 Metal detection 5 Wood and metal stud edge detection 6 AC voltage detection 50 600VAC and backlight 7 Scan button 8 Metal marking tip to mark location of stud edge 9 Operate from 9 V battery 4 0 Specification Stud detection depth and accuracy 1 2 1 8 Metal Pipe detection depth 2 1 2 AC volt detection depth 3 1 2 Operationg Range Non contact AC Detector 50 600V AC 50 60HZ Automatism turnoff 7 minute Energy 9 V battery Operating temperature and humidity O 50 C 80 MAX 5 0 Notice Will not detect damp wood or board STUD mode Will not detect a combination of defects STUD mode Will not detect two hot wires in a circuit AC mode 6 0 Operatin2. d the scan button slowly slide the unit across the surface C When the unit detect a live 50V or higher source such as a wire the level of the signal is full and the beep sounds D Mark this location with the metal tip build into the top of the unit
3. g instrations 6 1 6 2 Stud detection wood and metal A Press the STUD button B Place unit flat on the wall Press and hold the scan button Do not move the unit until calibration is complete When calibration is complete the symbol of READY will display and concomitance a buzzer C If you calibrate over a stud the level of the signal is full and the beep sounds Move the unit a few inchs right or left release the scan button and iterate step B D After calibration is complete continue to hold the scan button and slowly slide the unit across the surface E When the unit detect a stud edge the level of the signal is full and the beep sounds Mark this location with the metal tip build into the top of the unit F Continue scanning beyond the marked spot until the level of the signal is vacancy Slide unit in reverse direction to locate other edge of stud The middle of the stud is centered between the two marks Metal pipe detection A Press the METAL Button B Place unit suspend in the air Press and hold the scan button Do not move the unit until calibration is complete When calibration is complete the symbol of READY will display and concomitance a buzzer C When the unit detect a metal pipe the level of the signal is full and the beep sounds D Mark this location with the metal tip build into the top of the unit 6 3 AC volt detection A Press the AC Button B Place unit flat on the wall Press and hol
Download Pdf Manuals
Related Search