dog training collar P006 User`s manual How it works: Thank you for
Contents
1. turned on automatically and be in the standby state This will consume small amount of electricity A frequent use of it will consume electricity quickly Therefore you should often check by the batteries by watching the indicator light In order to prolong the lifetime of the batteries when you don t want to use the receiver take off the collar receiver and place it in a place without vibration You can also take out its batteries Notes for use at first wearing this collar some pets will feel uneasy Give the pet some time to get used to it Don t use the functions of this product until you are sure that the pet has gotten used to it With an automatic vibration induction switch in the receiver the movement of the pet will automatically turn on the power of the receiver When you don t use it place it in a place without vibration or even take out the batteries so as to prolong the lifetime of the batteries The valid distance of remote controlling means the straight line distance between the remote controller and the receiver without obstacles in between If there are interference signals or signal screening around the actual remote control distance may vary Theoretical distance of 500meters the actual use may not be achieved This product is for pet training Only by training can the pet understand the intention of its master Good effect can only be achieved by lasting use of it Presently this product is the most effectiv2. what its master likes and doesn t like We suggest you give the dog weaker vibration before starting the static impulse After a time of training the vibration or the weak static can also curb the improper deeds of the pet effectively The static impulse only acts as a menace that might be unnecessary most of the time Prepare some socks for the dog as rewards for good deeds This will make better effect in the training Package Contents 2 Receiver 1 transmitter 1 manual Caution Please take a few minutes to read the instruction manual prior to your first use For best results follow these important rules The electronic dog collar is intended only for use on dogs A low battery may cause intermittent operation DO NOT USE if you suspect a low battery Allow your dog to get used to the collar before you begin training You want your dog to accept the collar as part of a routine not to associate the collar with correction DO NOT leave the collar on your dog for more than 10 hours per day NEVER perform set up procedures when the collar is on your dog An electronic collar should only be used under close supervision by the dog s owner KEEP OUT OF THE REACH OF CHILDREN Read all instructions before using this product
3. dog training collar P006 User s manual How it works Thank you for choosing P006 Remote Pet Trainer the best selling brand of electronic training solutions in the world Our mission is to be the most trusted brand in the pet ownership experience We want to ensure your pet s safety by providing you with the tools and techniques to successfully train your pet POO6 Remote Pet Trainer is regulate the behavior of high tech electronic products It is an independent stop bark collar is a remote training collar It warned that the use of sound vibration stimulation with static punishment to correct some bad pet habits and behavior It can follow the will of the pet owner to train make your pet more intelligent more to love Main features Voice warning Vibration stimulate 20 levels Static punishment 20 levels Receiver is repeat charging A transmitter control two dogs Low power indicates Switch and Key Function K s voice warning SS is Vibration stimulate 4 is Static punishment is Vibration and Static Enhanced is Vibration and Static Weakened A button Receiver ID confirm A B switch state dog work B button Receiver ID confirm A B switch state dog work ID confirmation The transmitter batteries confirm works correctly Press the receiver key the receiver led light for about 10 seconds then press the transmitter A key receiver indicator is off complete ID confirmation followed by another
4. e and safest tool for training pet Following the correct operational instructions you can effectively train the pet and bring it no harm Though the receiver is water resistance you cannot immerse it into the water for a long time And you should keep the remote controller out of water Check that batteries are installed in the remote controller and the receiver Checking the remote controller press the buttons on the remote controller one by one it will make a BB sound If no change the batteries Checking the receiver with the vibration induction switch in it the receiver will be turned on automatically upon shaking and then the receiver will be in the standby state The receiver will be automatically turned off when it is in stillness for more than 2 to 3 minutes so as to save the electricity Please notice the color of the power indicator light on the receiver and the color of the cover and correspond them with the left buttons or the right buttons on the remote controller Connect the collar and the receiver Adjust the length of the collar so that it suits the neck of your pet best Don t make it too tight while the discharging point of the receiver can touch the neck of the pet The static impulse of the collar is to curb the improper deeds of the pet After each successful check the master should let the pet know what should be done and what should not be done After a number of training the pet will understand
5. earing the collar Don t use any of the functions at that time until you are sure that the pet has gotten used to the collar The static impulse is to curb the improper deeds of the pet Don t use it casually or to make fun of the pet 3 the static impulse can be strong or weak Training the dog is to let it associate the static with the vibration Reduce using the static gradually 4 the strong static impulse is only used in emergency 5 if you don t use this product take the collar and receiver off the dog and place them in a place without vibration so as to prolong the lifetime of the batteries 6 if you don t use the collar receiver for a long time take out the batteries How to change the batteries Remote controller the battery cell cover is at the lower part of the back of the remote controller Open the cover by pressing it following the direction of the arrow Take out the battery model 6F22 9V pay attention to the polarity of the batteries Put a new one back and then close the cover The batteries used for this product are ordinary ones which can be found in supermarkets and department stores Please provide the correct model while buying them The lifetime of the batteries vary according as how you use the product Since the remote controller only consumes electricity when you press the buttons to send signals its batteries lifetime is usually more than one year Upon receiving vibration the receiver will be
6. receiver to learn key led light for 10 seconds press the transmitter B keys light is off complete ID confirmation Charging When the receiver battery is low the low battery indicator light flashes need to charge the receiver open the receiver charge cover charger into the charging port of the receiver which is connected to the power supply the charging light led goes out automatically after charging is complete that is finished charging Receiver auto sleep with the vibration induction switch in it the receiver will be turned on automatically upon shaking and then the receiver will be in the standby state The receiver will be automatically turned off when it is in stillness for more than 2 to 3 minutes so as to save the electricity The receiver low battery red light flashes every seconds and bb tone Remote controller auto sleep To save the electricity remote controller will be in the standby state The Remote controller will be automatically turned off when it is in stillness for more than 2 to 3 minutes If you want to use again just press the A or B key the remote controller will be awakened in normal working condition Operational instructions 1 open the insert buckle of the collar and put the collar round the neck of the pet adjust the tightness of collar Don t make it too tight while the discharging point of the receiver can touch the neck of the pet 2 most pets feel uncomfortable at first w
Download Pdf Manuals
Related Search