Messager USBi by Nel-Tech Labs, Inc. Installation & User Manual
Contents
1. 01 15 Copyright 1984 2015 by Nel Tech Labs Inc2. 3 encryption then it will only play encrypted MP3 or WAV files Talk to your dealer or service provider for more information Messager USBi Layout Summary Front of Unit SPEAKER The SPEAKER switch can be turned ON and OFF to monitor audio playback The switch has no effect on the audio output connections on the rear of the unit Switch should normally be kept OFF NOTE The monitor speaker volume is fixed and is independant of the Volume control on back of the unit USB JACK The USB drive is inserted here to load audio to internal memory If insertion of drive is difficult turn the drive over and try reinserting Drive should slide into jack smoothly STATUS The STATUS indicator is a BLUE LED that during normal operation will be SOLID during playback If loading from USB media to the internal FLASH the LED will SLOW BLINK If there is a problem with the drive it is not inserted or is empty the LED will FAST BLINK Rear of Unit MADE IN USA VOLUME OUTPUT prat 500mA O 80 6000 VOLUME This pot is used to control the 80 and 6000 output level of the stored messages Volume up is clockwise volume down is counter clockwise 80 and 6000 OUTPUT This jack connects to the INPUT of the phone systems MOH port or PA system Depending upon the systems impedance use either the 8Q or 6000 jack DO NOT USE BOTH 12VDC This is where the supplied 12VDC 500mA power pack is connected Installation The Mes
3. Messager USBi by Nel Tech Labs Inc Installation User Manual Note AI units support MP3 playback of up to 128Kbps 48KHz Units with serial numbers starting with 15 or above will support the addition of WAV playback done in PCM 16 bit format Index Introduction iia 3 Messager USBI Layout SOI iii 4 Installat On sonia a a aea 5 Message Programming amp Dperalion au Ac 6 Troubleshooting a een 6 Warranty amp POC en a 7 Introduction The Messager USBi is a state of the art digital audio playback device designed to provide a continuous play audio source for message on hold background music or any other audio application where high quality audio playback is required Messages are transferred from standard USB flash drives to internal NAND Flash memory Once transferred the USB stick is not required for operation Unpacking and Inspection Before you begin installation unpack and verify you have all ofthe correct parts 1 Messager USBi 1 USB flash drive 1 12VDC 500mA power supply 1 Instruction manual 1 RCA to RCA cable 1 1 8 Adapter 2 Wall mount screws 4 Rubber feet If you are missing any of these parts STOP and call your dealer Important Notes Some USB drives have an indicator LED This LED may blink slow fast or may stay solid during playback Any description in the manual about the LED is referring to the BLUE STATUS LED on the player If unit is equipped with Sonocrypt Level
4. Operation All messages that are available for the Messager USB play are stored on an industry standard USB flash drive Messages should be formatted as a mono MP3 or WAV files not to exceed 128Kbps 48KHz MP3 or PCM 16 bit WAV Follow these steps to add or remove files from a USB flash drive Step 1 Plug the USB flash drive into an available USB port on a any PC or MAC compatible computer The flash drive should show up as a Removable Disk on the computer Step 2 Drag n drop the file s to the USB flash drive in the order you want them to be played on the unit If removal of files are required then select the files and press the lt delete gt key on the keyboard E MS MS Pro Sa Removable Disk M Step 3 Remove the USB flash drive from the computer Step 4 Plug hot swap the USB flash drive into the Messager USBi while power is ON to load audio The Status LED will SLOW BLINK while audio is being loaded to the internal memory A standard MOH production will take about 15 to 20 seconds to load Step 5 When the Status LED is SOLID the transfer is complete and the unit will begin playing from internal memory The USB flash drive can be left in the Messager USBi or removed If the USB drive ever needs to be erased completely then it can be formatted using your computer Drives smaller than 2GB can be formatted using FAT and drives 2GB or larger can use FAT32 Note Audio files should be named using alpha num
5. acement of any eligible part or equipment covered under this warranty through a Nel Tech Labs dealer only Buyer is responsible for all shipping and handling charges in connection with the performance of this warranty Products returned to Nel Tech Labs must be securely packaged to prevent damage in transit freight prepaid and insured for replacement value A return authorization number assigned by Nel Tech Labs must be clearly marked on the outside of the shipping container Proof of purchase must accompany shipment Items delivered to Nel Tech Labs without a return authorization clearly marked on the outside of the shipping container and or without proof of purchase is refused CONTACT Please contact Nel Tech Labs at the address and phone number below to receive a return authorization number and to arrange for the repair or replacement of a flawed part covered by this warranty Please indicate the Product s serial number in all correspondence or a RMA authorization number in the absence of a serial number Nel Tech Labs 4 Ash Street Extension Derry NH 03038 Phone 1 603 425 1096 COPYRIGHT NOTICE Unauthorized or unlicensed use of copyrighted audio content is illegal and Nel Tech Labs Inc takes no responsibility for such action by the user of this equipment FCC Part 15 This equipment has been tested and found to comply within the limits for a Class A digital device pursuant to Part 15 of the FCC rules These limits are designed to provide re
6. asonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications Operation of the equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct interference at his own expense In order to maintain compliance with FCC regulations shielded cables must be used with this equipment Operation with non approved equipment or unshielded cables is likely to result in interference to radio amp television reception Changes or modifications not expressly approved by Nel Tech Labs could void the users authority to operate the equipment IC ES 003 This Class A digital apparatus complies with Canadian ICES 003 C et appareil num rique de la classe A est conform e la norme NMB 003 du Canada CE CONFORMITY The Nel Tech Labs Messager USB conforms with the following standards in accordance with the EU Safety EMC Emissions amp EMC Immunities EN 60950 1 2001 EN 55022 1998 for Class A EN 55024 1998 A1 2001 A2 2003 EN 61000 4 2 1995 A1 1998 EN 61000 4 3 1995 EN 61000 4 4 1995 EN 61000 4 5 1995 EN 61000 4 6 1996 EN 61000 5 11 1994 Nel Tech Labs Inc 4 Ash Street Extension Derry NH 03038 1 603 425 1096 www nel techlabs com Rev
7. eric labels A Z 0 9 Any other characters or symbols such as amp etc should NOT be used Troubleshooting Files are encrypted with Sonocrypt or improperly named MOH message not playing Check to see if unit is loading Check volume output level by adjusting the VOLUME pot Check OUTPUT connection from unit to phone or PA system Try switching between the 80 and 6000 OUTPUT connections Skipping over files File not compatible with unit encrypted file Popping audio File was encoded using too high of a bit rate File incompatible with unit File audio starting too close to beginning of file Distorted audio Check to make sure volume is not too high Check MP3 or WAV file quality Try switching between the 80 and 6000 OUTPUT connections File was encoded using too high of a bit rate File was encoded using too low of a bit rate File incompatible with unit Limited Warranty TERMS Nel Tech Labs warrants to the original purchaser Buyer that the Product sold is free from defects in material and workmanship at the time of purchase The warranty period begins at the time of Product s original purchase by the first end user The warranty applies for five 5 year from the original date of purchase or as long as the product is owned by the original purchaser whichever comes first Included in the warranty are parts and labor Buyer must provide written notice to Nel Tech Labs of any defective part or conditions within the
8. sager USBi should be installed using the following steps Step 1 Wall or shelf mount the unit Screws and rubber feet are supplied in the accessory kit Step 2 If connecting to an amplifier make sure it is turned OFF for this part of the installation Step 3 Connect a RCA cable supplied in the accessory kit to the OUTPUT jack on the rear of the unit Depending upon the required impedance use either the 80 or 6000 output RCA jack Connect the other side to the MOH port on the phone system PA system or speaker Step 4 If unit is already preloaded then skip to Step 5 Insert USB media If insertion of drive is difficult turn the drive over and try reinserting Drive should slide into jack smoothly See Message Programming amp Operation section for correct loading of your audio Step 5 Attach the included power pack to a wall or power strip receptacle then attach the other end to the jack on the rear of the unit labeled 12VDC Step 6 If any amplifiers were turned OFF during installation then turn them back ON now Step 7 Adjust the volume level pot labeled VOLUME on the rear of the unit Depending upon the application either call into the phone system and be placed on hold OR listen to the PA systems speakers to fine tune volume Volume up is clockwise volume down is counter clockwise MADE IN USA VOLUME OUTPUT kk 80 6000 OR e_ To MOH port or PA System Wiring Diagram 5 Message Programming amp
9. warranty period If the defect is not the result of improper use service maintenance or installation and if the equipment has not been otherwise damaged or modified after shipment Nel Tech Labs or its authorized representative shall either replace or repair the defective Product at Nel Tech Labs s option No credit shall be allowed for work performed by Buyer or unauthorized parties Out of warranty repairs are invoiced at the current Nel Tech Labs hourly rate plus the cost of parts shipping and handling In the event that the product serial number is missing or has been tampered with in any way the foregoing warranty is void and without effect and Nel Tech Labs shall have no liability whatsoever on account of defects to such product LIMITATIONS Except as stated above there are no warranties expressed or implied that extend beyond the specifications for the product Nel Tech Labs expressly disclaims any warranty expressed or implied that equipment sold hereunder is of merchantable quality or that it can be used or is fit for any particular purpose Buyer purchases and accepts equipment solely on the basis of the warranty here in above expressed Under no circumstances shall Nel Tech Labs be liable by virtue of this warranty or otherwise for any special indirect secondary or consequential damages to any person or property arising out of the use or inability to use the product REPAIRING OR REPLACING PRODUCT Buyer may obtain the repair or repl
Download Pdf Manuals
Related Search