User Manual Nanight Sport v1.1
Contents
1. Se nanight User Manual Nanight Sport Dive light Thank you for choosing a dive light from Nanight The lamp is designed for diving at depths of up to 100m We at Nanight hope your new lamp will give you many rewarding days and nights of diving 1 PRODUCT DESCRIPTION e LED Type Cree XM L2 U2 e Battery 14 4V Panasonic Li lon 3350 mAh e 4 step dimming e Operating temperature 0 35 C e Operating voltage 5 20V Luminous Flux emitter lumen Burn time with max output hours LED ALTERNATIVE LI ION 14 4V 6X AA BATTERY CREE XM L2 TRIPLE 3000 1500 LED CREE XM L2 SINGLE 1000 600 LED LED ALTERNATIVE LI ION 14 4V 6 X AA BATTERY CREE XM L2 TRIPLE 1 45 min LED CREE XM L2 SINGLE 3 2 LED 2 NANIGHT SPORT INCLUDES THE FOLLOWING PARTS e Dive Light e Charger e Lens 5 15 or 35 degrees e Battery holder 3 BEFORE USE 3 1 CHARGE THE BATTERY e Open the dive light by unscrewing the sealing plastic plug counterclockwise e Disconnect the battery connector by pressing down on the latch and pull the onnee anan see picture e Connect the charger connector to the battery connector It is important that the connectors are connected to each other in the correct orientation see picture Plug the charger into a wall outlet The charger s indicator light turns from red to green when the battery is fully charged When the battery is fully charged disconnect the charger connector and reconnect2. light directly into the eyes of yourself or others e When using the dive light above water it may become hot Be careful not to burn yourself or others e Do not disassemble the dive light while its still wet e Do not recharge the battery if the water has penetrated into the dive light 6 RECYCLING This product contains electronic components and must not be disposed of with household waste Leave the product for recycling in designated areas such as municipal recycling center 7 WARRANTY Provided the product is used as intended one year of warranty is given on the lamp The warranty is valid provided that a receipt of the purchase can be presented and includes repair or replacement of defective parts 8 CONTACT INFORMATION Nanight AB info nanight se http divelight nanight se For information in English please visit http divelight nanight se 9 ACCESSORIES Goodman handle Battery holder Cree XM L2 Triple LED module Cree XM L2 Single LED module
3. t 2 minutes a number of short flashes indicate battery charge status Flashes Battery Level 75 100 75100 50 75 25 50 If the battery level falls below 5 the amount of light will automatically be reduced to save the battery and allow the user to terminate the dive safely 3 6 SWITCH OFF THE LIGHT Turn the knob counterclockwise until it touches the locking position the light will go off with a delay of 2 seconds Turn the knob counterclockwise past the locking position to ensure that the light does not come by accident for example during transport 3 7 DIM THE LIGHT Turn the knob counterclockwise until it touches the locking poisition and back again within 2 seconds Repeat the maneuver for further dimming In this way the light is dimmed gradually in four steps and back again to the highest brightness Note that the light automatically dims down to 10 brightness when reaching 5 battery level 4 AFTER USE 4 1 MAINTENANCE Rinse the dive light in fresh water after use Lubricate the seals with silicone grease if necessary Disconnect the battery if the light is not used for long periods or when transporting by air Make sure the o rings are clean from debris and undamaged Replace o rings if necessary 5 WARNINGS AND PRECAUTIONS When diving in dark water a backup dive light should always be brought Nanight Sport Backup is a great addition e Nanight Sport is a bright light Never direct the
4. the dive light connector It is important that the connectors are connected to each other in the correct orientation see picture Inspect the o rings clean any debris and replace them immediately if damage exists Make sure that the velcro strap around the battery is tight and keeps cords and plugs in place Close the dive light by pushing the plastic plug into the pipe past the first o ring Tighten the plastic cap by turning clockwise Be careful so that the parts threading properly against each other 3 2 CHANGING THE LENS Open the dive light by unscrewing the sealing plastic plug counterclockwise Note that after having unscrewed the plug the negative pressure in the lamp head may require some force to pull the parts apart Remove the lens manually by gently wiggling it Insert the new lens being careful so that its legs are aligned correctly in the lamp base Close the dive light by pushing the plastic plug into the pipe past the first o ring Tighten the plastic cap by turning clockwise Be careful so that the parts threading correctly to each other 3 3 ANV NDNING Lampans funktioner styrs av det droppformade vredet Vredets tr ghet kan justeras genom att lossa eller dra t skruven 3 4 USAGE The drop shaped knob controls the functionality of the lamp Loosening or tightening the screw can adjust wrath of inertia 3 5 SWITCH ON THE LIGHT e Turn the knob clockwise e lf the lamp has not been used for at leas
Download Pdf Manuals
Related Search