480P Manual - HARMAN Professional
Contents
1. take it to a dealer for service Disconnect the unit during storms to prevent damage SAFETY INSTRUCTIONS NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD WARNING THIS APPLIANCE MUST BE EARTHED CAUTION EQUIPMENT IS NOT DISCONNECTED FROM MAINS WHEN SWITCH IS IN THE OFF POSITION The cores in the mains lead are coloured in accordance with the following code GREEN and YELLOW Earth BLUE Neutral BROWN Live As colours of the cores in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows e The core which is coloured green and yellow must be connected to_the terminal in the plug marked with the letter E or with the earth symbol or coloured green or green and go e The core which is coloured blue must be con nected to the terminal marked N or coloured ack e The core which is coloured brown must be con nected to the terminal marked L or coloured red This equipment may require the use of a different line cord attachment plug or both depending on the available power source at installation If the attachment plug needs to be changed refer servicing to qualified service personnel who should refer to the table below The green yellow wire shall be connected directly to the units chassis ance BROWN WARNING If the ground is defeated certain fault conditions in the unit or in the system to which it is connected can re2. 480P Rear Panel IEC Power Cord Receptacle The 480P comes with a IEC power supply cord and a selectable power supply Voltage Selector Switch The 480P allows you to select either 115V with 500mA 250V SLOW BLOW fuse or 230V with 250mA 250V Type T fuse WARNING Fuse must be changed to correspond with the desired power setting RS485 Link to 480R DB 9 connector type This connector is used to connect to the 480R Cable lengths 480R to 480P 300 feet max 500 feet with dbx proprietary cable RS485 Link to Network Master DB 9 connector type This connector is used to connect the 480R to the network master Connect to the CONTROLLER IN on the Network master 480P to Network cable length Up to 4000 feet RS485 Link to 480R RJ 45 connector type This connector is used to connect to the 480R and is wired in parallel with the DB 9 connector Cable lengths 480R to 480P 300 feet max 500 feet with dbx proprietary cable RS485 Link to Network Master RJ 45 connector type This connector is used to connect the 480R to the network master Connect to the CONTROLLER IN on the Network master and is and is wired in parallel with the DB 9 connector 480P to Network cable length Up to 4000 feet RS232 PC Connection This input is used to connect a PC to the 480R for 480R software updates RS485 PC Select Button This recessed button is used to select the link to master controller connector or the PC 4
3. 80P Front Panel Power Switch Turns the 480P and 480R on and off Specifications 480P Power Supply Inputs Connectors RS 232 and RS 485 Network Communication Connectors Power Requirements 30 Watts Selectable 100 120V 50 60Hz or 220 240V 50 60Hz Dimensions Dimensions Height 1 75 X Width 19 X Depth 7 90 Weight 8 Ibs Shipping Weight 9 5 Ibs 18 0294 A d b x PROFESSIONAL PRODUCTS q b X PROFESSIONAL PRODUCTS PROFESSIONAL PRODUCTS IMPORTANT SAFETY INSTRUCTIONS RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR WARNING to REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products The light ning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit The excla mation point in an equilateral triangle indicates that it is neces sary for the user to refer to the owner s manual These symbols warn that there are no user serviceable parts inside the unit Do not open the unit Do not attempt to service the unit yourself Refer all servicing to qualified personnel Opening the chassis for any reason will void the manufacturer s warranty Do not get the unit wet If liquid is spilled on the unit shut it off immediately and
4. dbx Professional Products Manufacturer s Address 8760 S Sandy Parkway Sandy Utah 84070 USA declares that the product Product name dbx DriveRack 480P Product option None conforms to the following Product Specifications Safety EN 60065 1993 IEC 60065 1998 CAN CSA E60065 99 EMC EN 55013 1990 EN 55020 1991 Supplementary Information The product herewith complies with the requirements of the Low Voltage Directive 73 23 EEC and the EMC Directive 89 336 EEC as amended by Directive 93 68 EEC dbx Professional Products Vice President of Engineering 8760 S Sandy Parkway Sandy Utah 84070 USA March 15th 2000 European Contact Your Local dbx Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy Utah 84070 USA PH 801 568 7533 FX 801 568 7583
5. g particular attention to cords at plugs conven ience receptacles and the point where they exit from the appliance SERVICING To reduce the risk of fire or electric shock the user should not attempt to service the appliance beyond that described in the operating instructions All other servicing should be referred to qualified service personnel FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSI BLE FUSE RECEPTACLE Replace fuse with same type and rating only MULTIPLE INPUT VOLTAGE This equipment may require the use of a different line cord attachment plug or both depending on the available power source at installation Connect this equipment only to the power Source indicated on the equipment rear panel To reduce the risk of fire or electric shock refer servicing to quali fied service personnel or equivalent IMPORTANT SAFETY INSTRUCTIONS LITHIUM BATTERY WARNING CAUTION This product may contain a lithium battery There is danger of explosion if the battery is incorrectly replaced Replace only with a Sony or equivalent bat tery Make sure the battery is installed with the cor rect polarity Discard used batteries according to man ufacturer s instructions ADVARSEL Lithiumbatteri Eksplosjonsfare Ved utskifting benyttes kun batteri som anbefalt av apparatfabrikanten Brukt batteri returneres apparatleverandgren ADVARSEL Lithiumbatteri Eksplosionsfare ved fejlagtig handter ing Udskiftning ma kun ske med bat
6. sult in full line voltage between chassis and earth ground Severe injury or death can then result if the chassis and earth ground are touched simultaneously WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS CLEAN ONLY WITH A DAMP CLOTH DO NOT BLOCK ANY OF THE VENTILATION OPENINGS INSTALL IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS HEAT REGISTERS STOVES OR OTHER APPARATUS INCLUDING AMPLIFIERS THAT PRODUCE HEAT ONLY USE ATTACHMENTS ACCESSORIES SPEC IFIED BY THE MANUFACTURER UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERI ODS OF TIME WATER AND MOISTURE Appliance should not be used near water e g near a bathtub washbow l kitchen sink laundry tub in a wet basement or near a swimming pool etc Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through Openings POWER SOURCES The appliance should be connected to a power supply only of the type described in the oper ating instructions or as marked on the appliance GROUNDING OR POLARIZATION Precautions should be taken so that the grounding or polarization means of an appliance is not defeated POWER CORD PROTECTION Power supply cords Should be routed so that they are not likely to be walked on or pinched by items placed upon or against them payin
7. teri av samme fabrikat og type Lev r det brugte batteri tilbage til leverand ren VAROITUS Paristo voi r j ht jos se on virheellisesti asennettu Vaihda paristo ainoastaan laitevalmistajan suosittele maan tyyppin H vit k ytetty paristo valmistajan ohjei den mukaisesti VARNING Explosionsfara vid felaktigt batteribyte Anv nd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren Kassera anv nt batteri enligt fabrikantens instruktion ELECTROMAGNETIC COMPATIBILITY This unit conforms to the Product Specifications noted on the Declaration of Conformity Operation is subject to the following two conditions e this device may not cause harmful interference and e this device must accept any interference received including interference that may cause undesired operation Operation of this unit within significant electromagnetic fields should be avoided e use only shielded interconnecting cables U K MAINS PLUG WARNING A molded mains plug that has been cut off from the cord is unsafe Discard the mains plug at a suitable disposal facility NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET Do not use the mains plug without the fuse cover in place Replacement fuse covers can be obtained from your local retailer Replacement fuses are 13 amps and MUST be ASTA approved to BS1362 DECLARATION OF CONFORMITY Manufacturer s Name
Download Pdf Manuals
Related Search