a PDF of the Climatemaster Manual to 2012
Contents
1. mounting board Fig 2 After unpacking please check whether the above mentioned accessories are included and check their purposes in the installation introduction in this manual Notes the cold only unit does not contain the drain hose Appearance and Function of Control Panel TIMER ON OFF button LED WINDOW OPERATION MODE button TEMPERATURE button FAN SPEED ADJUSTMENT button POWER indicator la ATER FULL indicator lamp SIGNAL receiver windo Operation Displa Auto mode icon Air volume selection icon Heat mode icon Cool mode icon Swing icon Temperature and timing figure icon Timer icon Temperature icon Dry icon Notes The cold only unit does not have ELECTRIC HEAT function Operation Introduction Before starting operations in this section 1 Find a place where there is power supply nearby 2 As shown in Fig 5 and Fig 5a install the exhaust hose and adjust the window position well 3 Insert the power cord into an grounded AC220 240V 50Hz socket 4 Press the ON OFF button to turn on the air conditioner drain hose _ Operation Introduction Notice Operation temperature range MAXIMUM HEATING MINIMUM HEATING DB WB C 27 0 MAXIMUM COOLING MINIMUM COOLING DB WB C 35 24 16 12 1 Before Using Check whether the exhaust hose has been mounted properly Cautions for cooling and dehumidifying operations When usin2. clip into openings at back of the air conditioner see Fig 8 3 Put the other end of the exhaust hose to a nearby windowsill Window Slider Kit Installation The installation can be horizontal or vertical As shown Fig 11 and Fig 11a check the min and max size of the window Window Size Min 61 5 m 2 22ft Max 123cm 4 D4ft Window Size Min 67 Som 2 22ft Max 123cm 4 D4ft Pre dd Os Maintenance Explanations Declaration 1 Before cleaning be sure to disconnect the unit from any electric supply outlet 2 Do not use gasoline or other chemicals to clean the unit 3 Do not wash the unit directly under a tap 4 If the conditioner is damaged please contact the dealer or repair shop 1 Air Filter If the air filter becomes clogged with dust dirt the air filter should be cleaned once every two weeks Dismounting Open the air inlet grille and take off air filter Cleaning Clean the air filter with neural detergent in lukewarm water and dry it up in the shade Mounting Putting the air filter into the inlet grille replace the components as they were 2 Clean the Air conditioner Surface First clean the surface with a neutral detergent and wet cloth and then wipe it with a dry cloth Troubleshooting Troubles Possible Causes Suggested Remedies 1 UNIT DOES NOT START WHEN PRESSING ON OFF BUTTON Water full indicator lam
3. time setting buttons Preset OFF Time is displayed on the operation panel OFF time can be regulated at any time in 0 24 hours 6 Water Pump Drainage Cold single type There is self evaporation water pump in the machine In cooling auto cooling and dehumidifying auto dehumidifying function the self evaporation water pump will work with the compressor to evaporate any water Heat pump type a There are two water pumps the drainage pump and self evaporation water pump When using the heating function connect the water pump drain hose to the unit before operating When the water level of internal water tank reaches a predetermined level the drainage water pump will be activated and drain the condensed water outside through the connected drain hose The maximum delivery lift is 3 0m Under this condition the drainage hole at the bottom of unit should be blocked with the rubber blockage to prevent continuous gravity drainage b In cooling auto cooling and dehumidifying auto dehumidifying function the self evaporation water pump will work with the compressor to evaporate any water 7 Continuous Gravity Drainage When you plan to leave this unit unused for a long time please remove the rubber blockage from the drainage hole at the bottom of unit and connect a drain hose to the lower fixing clip All the water in the water tank will drain out NOTE In the unlikely event of water pump damage gravity drainage
4. you can drain by hand Restart the unit and the failure may disappear Replace water pump Note In the event of failure contact the retailer from whom it was purchased 10
5. Koolbrceze Portable Air conditioner User s Manual For Model CLIMATEMASTER P 14000 HCJ Table of Contents 1 Safety AAN td 1 2 Na me of Pants ereto de cath aid Murine auton beets leen ot 2 3s PNOCCOSSONOS tt do mete 2 4 Introduction to Control Padua anti ds 3 5 Introduction to Operational das daa lis 4 6 Installation Explanada 7 7 Maintenance EXplanaliGnS ic nera 9 8 Tro blesho tingu aaa e a EE a a ie ita a 10 Before you use your portable air conditioner please read this instruction manual carefully so that you get the best from the unit This instruction manual is used for guidance and does not form part of a contract We reserve the right to make technical changes without prior notice thus the machine illustrated may look slightly different to that you have purchased E Ol oa 9 1 1 Safety Awareness Do not use the unit on a socket under repairs or not installed properly Do not use the unit Near to source of fire An area where oil is likely to splash An area exposed to direct sunlight An area where water is likely to splash mo o WwW gt Near a bath a shower or a swimming pool Never insert your fingers or rods into the air outlet Take special care to warn children of these dangers The appliance is not intended for use by young children or infirm persons without supervision Young children should be supervised to ensure that they do not play with the appliance Keep the u
6. can be used and under this condition the water pump is not activated The unit will continue to work efficiently Under this condition please connect a drain hose to the lower fixing clip then all the water in the water tank will drain outside You can either leave the drainage hose clipped permanently to the outlet or remove the rubber blockage when the tank is full and the water alarm operates 8 Internal Tank Water Full Alarm Function The inner water tank in the air conditioner has a water level safety switch When the water level reaches an anticipated height in the internal water tank the water full indicator lamp lights up Note it is normal that the water full indicator lamp will light up when the build in water tank is full as the unit works at room relative humidity of up to 70 Installation Explanations 1 Installation Explanations The air conditioner should be installed on a flat surface with space all around Don t block the air outlet The required distance around should be at least 30cm See Fig 7 Do not install in an excessively humid atmosphere such as a dry cleaners Socket wiring should be in accordance with the local electric safety requirements 3 Introduction to Exhaust Hose Installation ccc Ce A air outlet exhaust TI Fig 8 A Temporary installation 1 Twist both ends of the exhaust hose into the square fixing clip and the flat fixing clip 2 Insert the square fixing
7. g functions on cooling and dehumidifying keep an interval of at least 3 minutes between each ON OFF Make sure the water pump is mounted correctly That the power supply meets the requirements The socket is for AC use Do not share one socket with other appliances Power supply is AC220 240V50Hz 2 Cooling operation Press the Mode button till the Cool icon appears Press the or button to select a desired room temperature 16 31 Press the Fan Speed button to select wind speed 3 Dehumidifying operation Press the Mode button till the Dehumidify Indicator Lamp blinks Set the selected temperature to current room temperature minus 2 16 31 Set the fan motor to LOW wind speed 4 Heating operation this function is not available for a cold only Unit Press the Mode button till the Heat icon appears Press the 0 r button to select a desired room temperature 16 31 Press the Fan Speed button to select wind speed 5 Timer operation Timer ON setting When the air conditioner is OFF press the Timer button and select a desired ON time through the temperature and time setting buttons Preset ON Time is displayed on the operation panel ON time can be regulated at any time in 0 24 hours Timer OFF setting When the air conditioner ON press Timer button and select a desired OFF time through the temperature and
8. nit upward while transporting and in storage to protect the compressor Before cleaning the air conditioner always turn off or disconnect the power supply When moving the air conditioner always turn off and disconnect the power supply and move it slowly Do not use an electric heater near the air outlet or within 15 mm of plastic parts 0 To avoid the possibility of fire the air conditioner should not be covered 1 All the air conditioner sockets must comply with the local electric safety requirements If necessary please check it for the requirements Notes If any parts become damaged please contact the dealer or a designated repair shop In case of any damage please turn off the unit disconnect the power supply and contact the dealer or a designated repair shop Ensure the power cord shall is firmly grounded If the power cord is damaged please turn off the unit and disconnect the power supply It must be replaced from the dealer or a designated repair shop Fuse on PCB Type 618 3 15A 250VAC Characteristics symbol T Breaking capacity symbol L Name of Parts Rear cover side panel Operation panel front cover air inlet Air outlet ea drain hose remote controller air inlet A MI Power lifie l i Continuous caster drain outlet Front view Side view Rear view Accessories pats Parts name Qty Ca exhaust hose flat fixing clip At square fixing clip drain hose
9. p blinks and water tank is full Dump the water out of the water tank Room temperature is higher than the setting temperature Electric heating mode Reset the temperature Room temperature is lower than the setting temperature Cooling mode Reset the temperature 2 Not cool enough The doors or windows are not closed Make sure all the windows and doors are closed There are heat sources inside Remove the heat sources if the room possible Exhaust air hose is not Connect or clean the exhaust connected or blocked air hose Temperature setting is too high Reset the temperature Air inlet is blocked Clean the air inlet 3 Auto Power Off in heating Heating protection when the Restart the unit at when a lower mode temperature at the air outlet room temperature exceeds 70degrees the unit will power off automatically 4 Noisy The ground is not level or not Place the unit on a flat level flat enough ground if possible The sound comes from the It is normal flowing of the refrigerant inside the air conditioner 5 E0 Code Room temperature sensor failed Replace room temperature sensor the unit can also work without replacement 6 E1 Code Pipe temperature sensor failed Replace pipe temperature sensor the unit can also work without replacement 7 E2 Code RH70 ltisnormal the air is too Water pump failed humid
Download Pdf Manuals
Related Search