Home

Hydro-4 instructions

image

Contents

1. B B B B B B B B B B Atlan Alalal EXIT EXIT as AAMAS EDC A A A A A A A A A B B B B B B B r OK AhAAAAS EXIT se OK ALAaAAABA Hydro 4 cod 90829 Hades Hydro 4 USIOE EL Page 8 PROGRAMMING WATERING Test manual watering From the TEST page press Press to select which valve is to be activated press to activate it for 5 minutes Press to change the manual watering run time optional The symbol EXS appears and flashes on the display together with the number of minutes of manual watering remaining The solenoid valve automatically closes and stops watering operations when the set watering minutes have been reached If you wish to stop watering operations in advance ae ea the message OFF appears on the display a Hydro 4 cod 90829 PROGRAMMING WATERING Exiting the test manual watering page Move to the page where TEST is displa yed with the symbols 3 and flashing Press to exit TEST manual mode Press to go back to the page with the clock By entering TEST mode any automatic watering is stopped but this will be restored on exit Reset The factory settings can be restored by pressing and holding down amp and at the same time until 12 00 appears on the display approx 10 seconds Then completely reprogramme the water timer as described in the programming sections Hydro 4 cod 90829 Hades Hydro 4 User manual Page 9 PROGRAMMING WATER
2. current TIME DAY indicating as default 12 00 and Sunday By pressing the message OK appears and the days of the week disappear Press or to increase or decre ase the current time By holding down the key the time progresses more quickly until the required time setting is reached To confirm the modified parameter press C and move to the screen to set the current day Hydro 4 cod 90829 ereislcie User manual SETTING CURRENT DAY AND TIME Press or to scroll through and select the current day To confirm the modified parameter press C and move to the screen to set the type of programme to use Press or to enable the oon programme A or B or both programmes or set them to OFF To confirm the modified para meter press and exit programming and return to the time screen Hydro 4 cod 90829 PROGRAMMING WATERING Set modify the RUN TIME The RUN TIME page allows the user to set a watering run time for programme A and programme B for each LINE From the RUN TIME page press Oto enable modification gt the symbol ggg flashes indicating that the parame ters displayed can be modified and require a setting confirmation Using changes the value displayed by pressing and holding the keys the value will change more quic kly Press to confirm the set value By pressing the user moves to the RUN TIME setting of the next LINE up to a maximum of 4 lines to form a WATERING CYCLE If a watering cycle does not
3. neither a nor b are enabled oO 4 Ca 6 W any Indicate the time or in the i i mel programming pages the run time al jt jt ple T start time of watering A AV AAA A gA B B B B B B AHHH EXIT JE Indicates that watering is in progress Indicates the page for testing and manual watering Indicates the day of the week in programming it indicates the day of the week in which watering is required and with Indicates that we are in which of the two programmes change parameter mode Hydro 4 cod 90829 Hades Hydro 4 User manual Page 5 HOW TO USE THE KEYPAD Only three keys let you set all the parameters The keys and let you scroll through the various pages in order to select the one desired The key lets you access the EDITING of the para meter displayed When O is pressed OK appears in the bottom left display With OK the and keys turn on and let you edit the value of the parameter displayed If a key is not pressed for approximately 5 minutes the water timer automatically returns to the date and hour page without confirming the changes in progress When the desired value is reached exit from the changes by pressing the O key OK will appear on the lower right part of the display It is now possible to go back to the page with the and keys and change the values if needed Hydro 4 cod 90829 SETTING CURRENT DAY AND TIME When the batteries are first fitted the display shows the first page
4. ING Enabling programmes A and B and setting to off Activating deactivating programmes A and B of the water timer is useful in managing watering requirements based on the season for example programme A can be set for the summer maxi mum watering requirements and programme B for the spring low watering requirements simplified programming if just one programme is sufficient for your watering requirements it is possible to eliminate the display of the pages of the other programme simplifying setting operations for the programme being used setting to OFF to temporarily stop watering without losing the programme settings as described below The display normally shows the current TIME DAY screen press to go into the time programming and press it twice more Then press to select which programme is to be enabled The possible selections are 4 If programmes A and B are assigned on the same day this could cause the simultaneous opening of the two lines the system does not have a sufficient flow rate this could have a negative impact on the quality of the watering Once the selection has been made press O to confirm enabling of the programme s displayed Hydro 4 cod 90829 Hades Hydro 4 User manual Page 10 WATERING PROGRAMMING Rain Sensor RF From the RAIN SENSOR page press gt activates when the Rain Sensor RF activates deactivates Press gt to move the status from 4E5 sensor activated
5. User manual Page 1 Installation The valve box is to be installed outside buried at ground level 1 2 or resting on the surface 3 ensuring that the cover opening is free so that the valve inside the box can be programmed easily If installed below ground do not place it in areas which are frequently walked over or passed over by mechanical means eg ride on lawn mowers wW RN Mow Seg ay SD Dear re SW ae Oe Rtg fae Sh ha SSj ex e Seer Sar Pena iB oo a A th CA 91002 fy 91009 _5 91025 J 90326 7 90910 Turbina Turbo jet Colibr Pop up 90474 90260 90210 90019 90262 90220 90020 90230 Installation drawing parts not supplied to be purchased separately Once the valve box has been positioned make the hydraulic connections as indicated on the following pages depending on individual requirements it is possible to connect the valve box with pipes of different diameters using the specific fittings not supplied Below each link is referred to the example above x Hydro 4 cod 90829 Hades Hydro 4 User manual Page 2 FITTING THE BATTERY In order to operate the water timer requires two AAA LRO3 1 5V Alkaline batteries that must be replaced with two new charged batteries at the start of each season and are sufficient for at least the entire irrigation To install or replace the battery proceed as follows Uns
6. crew the two screws on the valve box cover 1 remove them 2 and remove the cover 3 Unscrew the plastic cover on the water timer 4 and lift it up 5 Take out the water time 6 Unscrew the battery compartment plug 7 take out the battery holder 8 and if present remove the drained batteries Fit the new batteries in the holder observing the correct polarity 9 Replace the battery holder into its housing 10 and screw down the plug checking that the seal is correctly placed in its seat 11 Insert the water timer into its seat 12 screw the cover back on 13 close the valve box with its cover 14 and secure it using the designated screws 15 16 Hydro 4 cod 90829 Hades Hydro 4 User manual Page 3 USE It is possible to set up two watering programmes A and B which operate independently from each other on one or more of the 4 lines 41 2 gt 3 gt 4 Each watering Programme A or B can be set to start watering on any day of the week WEEKLY SCHEDULE up to 4 times a day START TIME and for a maximum run time of 60 minutes for each line RUN TIME Nouba F AU Line via vila Tt t 3 Hydro 4 cod 90829 PROGRAMMING EXAMPLE In the example programme A starts watering at 5 00 START TIME and at 21 00 START TIME2 at these times the valves open in order RUN TIME valve 1 for 5 minutes valve 2 for 10 minutes valve 3 for 5 minutes valve 4 not used T
7. he programme starts on Mondays Wednesdays Fridays WEEKLY SCHEDULE Programme B starts watering at 6 00 START TIME at this time only valve 4 opens for 20 minutes RUN TIME The programme only starts on Saturdays WEEKLY SCHEDULE Start time watering time Start time 1 Start time 2 Start time 3 Start time 4 ore 5 00 ore 21 00 OFF OFF Run time watering amount Start time 1 Start time 2 Start time 3 Start time 4 ore 6 00 OFF OFF OFF 20 run time min Sunday Monday fa Tuesday i Wednesday a Thursdayjem Friday Saturday 4 AI aAa amp late Weekly schedule watering days Hydro 4 cod 90829 ereisicin User manual Page 4 GUIDELINES ON PROGRAMMING provides information about all the programming pages in the order they appear and allow the user to scroll through the different pages The key lets you access the EDITING of the parameter displayed Weekly Rain Manual Schedule Sensor Test Hydro 4 cod 90829 DISPLAY The following functions are assigned to the various keys or combination of keys Indicate the programmed start times start time for automatic watering Signals that the main number indicator represents the start time of the watering cycle start time Indicates of the selected programme battery level Taeao Indicates the line which 3 atx is being programmed lia K y Indicate which pogrommes JE only a only b both a and b my A B INE Gers
8. include the use of a specific line simply set the watering run time of that line to OFF Hydro 4 cod 90829 Hades Hydro 4 USIOE EL Page 7 PROGRAMMING WATERING Set modify the START TIMES The START TIME page allows the user to set up to start times per day for the WATERING CYCLE for programme A and 4 times for programme B From the START TIME page press to enable modification of the START TIME EB gt the symbol gam flashes indicating that the parameters displayed can be modified and require a setting confirmation Using amp changes the value displayed by pressing and holding the keys the value will change more quickly press to confirm the set value If necessary set the times of the next STARTTIMES E3 E3 E3 by pressing and repeating the operations described above Hydro 4 cod 90829 PROGRAMMING WATERING Set modify the WEEKLY SCHEDULE With the weekly programming WEEKLY SCHEDULE the user selects the days of the week on which the set Watering cycles are activated From the WEEKLY SCHEDULE page press gt the symbol A flashes Sunday Each time is pressed the screen displays which programme is to start on that day only A only B both A and B neither A nor B Press to move on to the next days and proceed in the same way to programme the days To exit go to by pressing a number of times when it flashes press O to display the screen WEEKLY SCHEDULE again 9 AIAI A A OQIAA OA B B B B B B
9. to nd sensor deactivated and vice versa Confirm by pressing Status of Rain Sensor RF e Off Sensor EMPTY or not active for the water timer e amp Permanently on Sensor FULL or active for the water timer With the sensor FULL any watering programmes are interrupted and other programmes start automatically while the symbol 4 remains active e4 Active and flashing the water timer has not received any information from the Rain Sensor RF for more than 24 hours and is working independently from the sensor Check the Rain Sensor RF installation and batteries Hydro 4 cod 90829 CLEANING AND MAINTENANCE Clean the outside of the valve box and the control module when necessary using a soft cloth dampened slightly with water or specific detergent follow the detergent cleaning instructions Do not use abrasive pads scourers or acid detergents n winter or long periods of inactivity close the tap or the gate valve upstream access the control module and manually open all 4 lines in sequence to discharge the pres sure remove the water timer store it in a dry area where the temperature does not fall below 3 C and remove the batteries LEED Hydro 4 cod 90829 For more information and further details please consult the instruction manual supplied with the product

Download Pdf Manuals

image

Related Search

Related Contents

MycAssay™ Aspergillus  Motores de Gasolina Manual del Usuario  取扱説明書【録画・再生編】  PDFファイル  Rexel Ecodesk  メモリハイロガー LR8431〔3.9 MB〕  Responsable Laboratorio Fitopatología.  Cisco Systems OL-15499-01 User's Manual  RAN - RAL  

Copyright © All rights reserved.
Failed to retrieve file