Home

instructions for using the motion pro # 08

image

Contents

1. Motion Pro Inc 867 American Street San Carlos CA 94070 Tel 650 594 9600 Fax 650 594 9610 www motionpro com INSTRUCTIONS FOR USING THE MOTION PRO 08 0141 PASSING LAMP TURN SIGNAL ALIGNMENT TOOL This tool is designed to assist in the proper alignment of the passing lamps and turn signals These instructions are to be used in conjunction with your vehicle s service manual they are for installation only Refer to your vehicle s service manual for disassembling and wiring techniques 1 Remove the two screws that fasten the turn signal to the mounting bracket 2 Install the alignment tool to the bottom of the mounting bracket using the screws removed in step 1 and the 10 24 wing nuts supplied 3 Position the passing lamp on to the passing lamp bracket Next install the mounting bracket with alignment tool attached washer and locknut Snug do not tighten the nut using a flare nut socket 4 Reroute and reconnect all wires see vehicle s service manual 5 Turn the passing lamps on and check them for proper operation Consult your vehicle s service manual to properly set the alignment of the passing lamps 6 While holding the passing lamp with one hand straddle the ratchet and alignment tool with the other hand Tighten the nut to a maximum torque of 18 ft lbs 24 Nm 7 Remove the alignment tool reinstall the turn signals and tighten the two screws 8 Recheck passing lamp turn signal alignment and ope
2. ration If the alignment is out repeat steps 1 through 7 108 0141 7 2010

Download Pdf Manuals

image

Related Search

Related Contents

Rust-Oleum Universal 247562 Instructions / Assembly  KLF 100 - Home Depot  Notice  bmw e65 specification - Video  U8500 U8500 BENUTZERHANDBUCH  User manual - Supercontrols  Installations- u. Betriebsanleitung    Pliko P3 Modular System On Track  

Copyright © All rights reserved.
Failed to retrieve file