Gloria+ - Caretech AB
Contents
1. Ca reTech Gloria A ger cae e s SS me Tm e 2013 Copyright CareTech AB Rev D En Table of contents OT ER 1 Read first Safety ln ten RE de pm 4 IFpoFtarit NOME NON ae 4 le lo O n es ei Gestes aitu piti 5 Description OF TUNCHONS MM T SAO mom EEE TE 8 gd 190 ES LA salle TTE 9 PRO CIO OCS Elo taa oi EE oda 10 eise e E I E LI LEE 11 Maintenance EE 11 F CANICAl ALG RUE elite eide ernennen ee Eee 12 Environmental NOTE ON ET m t m de to at 13 Read first Safety information e he compartment covers on the reverse may be opened only by authorized persons in accordance with the instructions in the service manual e battery replacement may be performed only by authorized persons in accordance with the instructions in service manual Only use recommended battery type as stated in the service manual CAUTION Hisk of explosion if battery is replaced by an incorrect type Dispose of used batteries according to the instructions e Installation must be performed only by authorized persons in accordance with the instructions in the service manual Only use recommended power supply as stated in the service manual A Always read and follow the safety information accompanied by this symbol Important Information All systems using radio and network communication are subject to interference beyond the user s control Products from CareTech are2. to the ON position Check that the ON indicator lamp has a steady green light e Connect the existing telephone to the intermediate plug Lift the receiver and check that you can hear the tone e Carry out a test alarm from the carephone Installation must be performed only by authorized persons in accordance with the instructions in the service manual Programming The carephone s telephone numbers alarm codes and settings are programmed via a computer using the programming cable and the Carelech CS software For help with programming and information about other programming tools please refer to the carephone s service manual or contact your supplier In some cases the carephone can be delivered ready programmed by the supplier Programming radio triggers Up to nine radio triggers or other radio alarm transmitters e g smoke detectors can be programmed for the carephone Programming radio transmitters e Hold down the green button for approximately four seconds until the green On light starts to flash e Press the radio trigger Once the carephone has received the radio signal you will hear a distinct tone signal e Confirm by pressing the red button on the carephone Check radio coverage This should always be done on installation e Hold down the green button for approximately four seconds until the green On light starts to flash e Press the radio trigger Ihe built in speaker will produce a tone
3. designed to minimise the impact of such interference Nevertheless the user must be aware that system components can be subjected to interference or other influences that may cause malfunction It is therefore important to regularly check that every part of the system works in all areas especially radio communications Contact your supplier immediately in case of any suspected malfunction Users should pay particular attention to the risk of disruption from products which communicate using the same or adjacent frequencies For further information please contact your supplier or refer to the service manual or the documentation at www caretech eu Package contents Gloria carephone Elliot radio trigger with accessories Telephone lead telephone adapter Power supply User guide Carephone parts here are three buttons on the front with the following standard functions Red button ALARM activates the alarm Yellow button LE function button ap Green button CANCEL stops the alarm The following indicator lights can be found on the front of the carephone 1 On Green normally lit during operation Steady light Indicates mains power receipt of radio signals on programming radio alarm Flashing light Radio programming state Q Alarm Red Slow flashing Alarm Rapid flashing Connection to alarm receiver on alarm Error Red Rapid flashing No connection to telephone line Slow flashing Powe
4. dity non condensed Refers to radio module C1 type 9340 Radio receiver parameters Max usable sensitivity 30dBm Blocking or desensitisation 16dBm Gloria can also be equipped with radio module type 9320 which allows maximum security and includes receipt of transmission automatic transmission repeat power control and frequency control See order information for indicating which radio module the unit is equipped with 113dBm Average usable sensitivity ver 28 dBuV m hor 27 0dBuV m Adjacent channel selectivity 26 2dBm 28 2dBm Intermodulation rejection 36dBm 37 dBm Spurious response rejection C 0402 Hereby Care ech AB Kalix Sweden declare that this equipment is in compliance with the essential requirements and other provisions of R amp TTE Directive 1999 5 EC and RoHS 2 directive 201 1 65 EU The comprehensive declaration of conformity is available at the address Care Tech AB Box 10030 SE 952 27 Kalix Sweden Environmental information his product complies with the requirements of the EU directives 2002 96 EC WEEE and 2006 66 EG These directives regulate the product liability for electrical and battery recycling with the purpose of increasing recycling and minimising waste The unit is marked with the crossed out wheeled bin logo which indicates that it shall be handed in for recycling u The product can be returned free of charge to a recycling station that is connec
5. eries should be disposed of in an environmentally responsible manner Maintenance Cleaning The carephone and portable alarm button should be cleaned using a slightly damp cloth Solvents should not be used when cleaning Replacing the carephone batteries Battery should be replaced a s a p after battery alarm or within three years Replacing the radio trigger batteries To replace the radio trigger batteries please refer to the service manual or contact your supplier AN Battery replacement may be performed only by authorized persons in accordance with the instructions in service manual Technical data Carephone Dimensions Power supply Backup batteries Backup time Inputs Output Communication Radio frequency Radio receiver class Number of radio transmitters Portable alarm button Dimensions Battery Battery life Water resistance Equipment class Environment Gloria 121 x 214 x 36 mm LxWxH Enclosed power adapter 4 x 1 2 V NiMH LRO AA Up to two days Two opto isolated Relay output potential free max 2A Analogue telephone line 869 2125 MHz 4 Up to 9 Elliot 45 x 30 x 13 mm LxWxH 3 V lithium battery CR2430 Up to five years Complies with IP67 Class 1 radio equipment Class f This product is intended for indoor use in a normal residential environment Temperature Humidity Environmental class 1 Operating temperature 5 C to 35 C 0 to 75 relative humi
6. r failure battery fault The following connectors can be found on the reverse of the carephone AUX Wired inputs TEL Connection to POWER Power supply and output telephone network programming cable a d EE Hole for wall mounting ON OFF On and off switch Battery compartment The compartment covers on the reverse may be opened only by authorized persons in accordance with the instructions in the service manual Description of functions Gloria is a practical well designed mains operated carephone that is ideal for use in the individual s own home The Elliot radio trigger is adapted for use with the Gloria carephone Elliot can be worn using a wristband neckband or pocket clip The CareTech Easy Press Concept EPC accessory makes it easier for those with reduced physical strength to activate the alarm Activating the alarm The assistance alarm can be activated with a radio trigger or by pressing the red button on the carephone On activation the carephone calls an alarm receiver to summon help Other alarm types can be activated using accessories If an alarm is activated accidentally it can be reset by pressing the green button on the carephone Different types of alarm transmitter Nine radio transmitters can be programmed with the carephone e g a radio trigger smoke detector motion detector etc In the event of an alarm from a radio transmitter the battery
7. signal on successful reception Repeat this in all areas where the alarm needs to operate Functional test Always check the function after installation and programming Test alarms shall be done regularly and in a way that secures the whole alarm chain from radio transmitter to alarm receiver Radio trigger Elliot Radio trigger Elliot uses two way radio communication this means that when Gloria receives an alarm from Elliot it will send an acknowledgement of the receipt This is shown on Elliot by the indicator light that changes colour from red to green light If Elliot doesn t get any acknowledgement the alarm will be repeated Elliot is equipped with two buttons that have programmable function Accessories included wristband wristband attachment neckband pocket clip easy press accessory and cover The accessories are attached to the alarm button with a simple click in action me Neckband attachment We Wristband attachment 9 y Indicator light Function button Alarm button WS Pocket Clip V p Easy press accessory e Cover General information If the telephone line is not working no alarm can be sent The carephone should be connected to the first telephone jack in the home In order for an alarm to be sent at least one alarm receiver response centre needs to be programmed The carephone must not come into contact with water or any other liquid Used batt
8. status of the radio transmitter is tested he Elliot radio trigger has the option of automatic battery monitoring Alarm receivers Up to six alarm receivers can be programmed The alarm is identified using an alarm code which is programmed into the carephone An alarm placed to a private receiver is identified by a recorded voice ID The person receiving the alarm can then speak directly with the person raising the alarm and take appropriate action Other functions Additional functions can be activated or changed by programming refer to the service manual or contact your supplier for further information Installation Connection The carephone is very simply to install connection to the telephone network is via the telephone lead adapter The carephone should be connected to the master telephone socket in the home in order for it to continue to work even if a telephone receiver is left off the hook or is faulty The master socket is normally the one closest to the entrance door for further advice contact your supplier Power is supplied via the power supply from a wall socket M M amp OFF ON TEL POWER tot e Disconnect the existing telephone from the telephone jack and connect the telephone lead adapter to the jack Connect the telephone lead to the TEL socket on the carephone e Connect the power supply to the wall socket and the power supply lead to the POWER socket on the carephone e Turn the power switch
9. ted directly or via a recycling system to Care Tech or to your distributor For detailed instructions please check with your distributor or visit our website www caretech se Note The WEEE information and recycling instructions applies to European Union member states only For other countries please check local legislation or contact your distributor Manufactured in accordance with the EU directive 2011 65 EU ROHS 2 The materials used in the radio trigger wristband and neckband meet the textile safety requirements of Oeko Tex standard 100 The information contained here is subject to change without notice The only warranties for CareTech products and services are set forth in the express warranty statements accompanying such products and services Nothing herein should be construed as constituting an additional warranty Care Tech shall not be liable for technical or editorial errors or omissions contained herein 13 14 15 Ca reTech I www caretech se
Download Pdf Manuals
Related Search