Sola Kleen Installation Manual For SSK300L Twin Panel - Gee-tek
Contents
1. 2 connect amp run the cold water expansion line as per normal local amp Australian plumbing standards STEP 5 8 turn on the cold water supply to system at the cold water valve set and fill the system remember to open the hot water expansion valve to bleed out the trapped air until the system is full Once the tank is full close the hot water expansion valve and inspect for leaks at all joins and rectify where necessary 7 connect hot water out let fitting and hot water expansion valve here and connect hot water supply to house here 2 tighten up short pipe fittings 6 connect cold water supply to here 3 make sure panels are rising to this side 5 tighten up the long pipe fittings at the panel amp Tank 1 tighten up 4 fix both panel straps to panel joiners panel box with short screws Hot water expansion valve Connect expansion line to here and run to just short of ground level in accordance to the local amp Australian plumbing standards Hot water supply to house Congratulations you have now finished this new solar water heater installation2. Sola Kleen Installation Manual For SK300LFB Twin Panel System This document was prepared for Sola Kleen and updated on 8 November 2004 By David Stannard This document remains the property of Sola Kleen PTY LTD STEP 1 1 fit tank straps first amp make sure that this tank strap is Front of the tank straps 1200mm tile roof 10mm higher up the roof than should be located on the 1400mm tin roof the left hand tank strap nose of the leading tile Zoe 2 fit panel strap 2000mm from front of tank strap to end edge of panel plus 50mm for up turn for fixing to the panel box 3 fit panel strap St X 1990mm from front of tank strap to end edge of panel box plus 50mm for up turn for fixing to the RM ERR BBB NE y 50mm turn up An ax on panel straps A STEP 2 1 fit tank amp secure to straps this end should be 10mm higher up the roof 3 fit right hand panel and secure to long pipe 2 fit long pipe STEP 3 2 fit panel joiners 1 fit short pipe to tank 4 secure short pipe to panel 3 fit right hand panel amp tighten up panel joiners 55mm gap between tank stand amp panel box STEP 4 1 install amp connect the cold water supply from the cold water supply valves that should be located on the wall of the house amp installed in accordance with the local amp the Australian plumbing standards
Download Pdf Manuals
Related Search