Husky H4310 Use and Care Manual
Contents
1. Reference Part Number Description Reference Part Number Description Number Number 1 975 7300P01 Motor Housing 17 980217 13 Pin 2 980202 Spring Pin 18 980218 22 Cylinder 3 970103 Air Inlet 19 980219 Front End Plate 4 9795804 Trigger 20 940309 Screw 2 5 980205 Valve Stem 21 975 725351 Decoration Ring 6 980206 1 Reverse Bushing 22 980222 Internal Gear 7 970107 0 Ring 23 980223 Planet Gear 3 8 975 730008 Valve Spring 24 930124 Pin 3 9 980209 0 Ring 25 980225 Bushing 3 10 980210 Reverse Lever 26 970526 Work Spindle 11 980211 Motor Gasket 27 5950 Key Chuck amp Key 12 970534 Clamp Nut 28 9080227 Ball Bearing 2 13 9030113 Ball Bearing 2 29 970133 Washer 14 980214 End Plate 2 30 970530 Screw 15 980215 Rotor 31 980247 0 Ring 16 980216 Rotor Blade 5 32 970110 Exhaust Diffuser2. lubrication instructions in this manual The air pressure is low Adjust the regulator on the tool to the maximum setting Adjust the compressor regulator to the tool s maximum setting of 90 psi The air hose leaks Tighten and seal the hose fittings with pipe thread tape if leaks are found The air pressure drops Ensure the hose is the proper size Long hoses or tools using large volumes of air may require a hose with an I D of or larger depending on the total length of the hose Do not use a multiple number of hoses connected together with a quick connect fitting This causes additional pressure drops and reduces the tool power Directly connect the hoses together There is a worn rotor blade in the motor Replace the rotor blade There is a worn ball bearing in the motor Remove and inspect the bearing for rust dirt and grit Replace or clean and grease the bearing with bearing grease There is moisture blowing out of the tool s exhaust There is water in the tank Drain the tank See the air compressor manual for instructions Lubricate the tool and run it until water is not evident Lubricate the tool again and run for 1 2 seconds HUSKYTOOLS COM Please contact 1 888 43 HUSKY for further assistance Service Parts
3. Maintenance Ensure the air line is shut off and drained of air before removing this tool for service or changing sockets This will prevent the tool from operating if the throttle is accidentally engaged LUBRICATION An in line filter regulator lubricator is recommended as it increases tool life and keeps the tool in sustained operation Regularly check and fill the in line lubricator with air tool oil Avoid using excessive amounts of oil Adjust the in line lubricator by placing a sheet of paper next to the tool s exhaust ports and holding the throttle open approximately 30 seconds The lubricator is properly set when a light stain of oil collects on the paper If it is necessary to store the tool for an extended period of time overnight weekend etc generously lubricate the tool through the air inlet Run the tool for approximately 30 seconds to ensure the oil is evenly distributed throughout the tool Store the tool in a clean and dry environment agents and an EP extreme pressure additive Troubleshooting Recommended lubricants Air tool oil or any other high grade turbine oil containing moisture absorbent rust inhibitors metal wetting Problem Possible Cause Solution The tool runs slowly or will not operate There is grit or gum in the tool Flush the tool with air tool oil or gum solvent The tool is out of oil Lubricate the tool according to the
Download Pdf Manuals
Related Search