Sea Gull Lighting 16004-15 Use and Care Manual
Contents
1. FAN OFF SETTING LIGHT ON OFF SET Turns fan off only S ON OFF S TING AND DIMMER Press and hold to dim light infinitively FAN SPEED Depress I dot for low speed 2 dots for medium or 3 dots for high To turn fan off press square LIGHT DIMMER To turn light on press light dimmer once quickly To turn off press once quickly while light is on To dim light hold down button light dimmer The light will cycle from bright to dim to bright until button is released Light will maintain last setting if turned off FORWARD REVERSE Depress rev button allow a few seconds for remote to change rotation direction For Customer Service Call 866 449 28212. 16004 15 16004 15 INSTRUCTIONS FOR YOUR NEW REMOTE FAN CONTROL SYSTEM CAUTION To reduce the risk of electric shock install only in Fan 1 Model CD 52 manufactured by Ja Yang E106510 2 Model 9701 manufactured by Furn Fan E141261 3 Model AC 552 manufactured by Air Cool E75795 CAUTION FOR CONTROL OF SHADE POLE PERMANENT SPLIT CAPACITOR OR UNIVERSAL MOTORS ONLY Connect the molex from the receiver to the molex in the switch housing plate by aligning and sliding together Note For longer distance operation coil receiver antenna around the natural wire white wire Capacitor a Speed 4 yaen f ph g j Reverse Switch l rA E Connectors view of switch housing plate AKA D 4 Vz Set dip switches on the Remote Transmitter and Remote Receiver to the same settings This must be done so the units will communcate properly If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter If you have more than one fan with remote You can set the dip switches to different positiosns to have seperate control Disconnect Molex Connectors in switch housing plate by pushing down on tab and pulling the two molex connectors apart Receiver Light Kit J Wires Receiver Gap Free Molex Connector Align gap in receiver with the screw between speed switch and reverse switch and slide receiver Dip switch facing housing
3. plate into switch housing plate Receiver should fit direct ly into area in the switch housing plate Note If installing light kit use the blue and white wire from the receiver 16004 15 The wall control transmits the command signals via radio waves to the receiver installed in the fan s hanging bracket or on the fan The receiver is required for the wall control to function Power for the wall control comes from the 12V bat tery located in the wall remote Duracell MN21 Eveready A23 GP 23A all 12V The frequency switches dip switches on the wall control and the receiver have been preset at the factory Please recheck to make sure the switches on the wall control and receiver are set to the same position Any combination of settings are fine as long as the wall control and ceiling fan receiver are set to the same posi tion CAUTION TURN OFF POWER AT FUSE BOX TO AVOID POSSIBLE ELECTRICAL SHOCK HAND HELD INSTALL Place face plate over battery compartment and buttons Place remote over 2 pins on front cover Attach cover of remote by placing over 4 pins and snaping into place Attach front cover to wall control Install wall control unit to outlet box with screws provided Snap battery using machine screws provided cover in place 16004 15 Remote Control Transmitter Features Forward Reverse Press once to change direction of MEDIUM SPEED the fan LED LIGHT LOW SPEED HIGH SPEED
Download Pdf Manuals
Related Search