Kraft Tool Co. GG600HD Instructions / Assembly
Contents
1. Gauge Rake Assembly Instructions CC975 01 CC976 01 No Description CC975 01 24 Gauge Rake and Parts CC976 01 36 Gauge Rake and Parts CC975 04 Replacement T Skates and U Bolts GG224 04 Replacement Bracket CC263 5 3 Piece Threaded Handle Tools Needed Small pair of pliers Parts Included Quantity A Gauge Rake 24 or 36 length 1 each B Bracket 2 each C 20 x Hex Flange Face Screw 2 each D Washers 2 each E 14 20 Wing Nuts 2 each F T Skates 2 each G U Bolt Clamps 2 each H U Bolts and Nuts 2 each Figure 1 Place a U bolt and U bolt clamp in line with the two holes near one end of the gauge rake Slide the threaded U bolt into the holes on the back of the gauge rake the side without the label The threaded ends should protrude out the front of the gauge rake Figures 2 3 Slide a I skate up through the U bolt The top of the T skate should extend through the top hole of the gauge rake Figure 4 Hold U bolt clamp and T skate in place Attach and lightly tighten nuts on the U bolt on the front opposite side of the gauge rake Figure 5 Measure for desired depth which is the distance from the floor or surface to the bottom edge of the gauge rake Tighten down the U bolt nuts to hold T skate firmly Repeat steps on other end www KraftTool com
Download Pdf Manuals
Related Search