Triarch CF-3000 User's Manual
Contents
1. 5 Lift canopy to hanger 2 Position blade Insert only one bracket Tighten all bracket so that it screw though blade screws rests flush against bracket and t securely blade Tighten all partially tighten screws securely Insert 2nd screw tighten and then tighten 1st screw Repeat with Warning For downrod mounting be remaining blades sure that the tab in the bracket rests in the slot of the ball end Install the 3 candelabra base 40 watt bulbs not included Remove the washer nut and finial from the light kit Remove the knob from switch housing Screw the light kit into the switch housing install the light kit into the fan Install the giobe and secure the globe by washer nut cap and finial Install the light bulbs of uplight Use 3 candelabra base 40 watt bulbs not included Page 3 Replacement Parts Keep this guide handy for ordering replacement parts Mounting Bracket Pin Qg Downrod Lock Pin Clip a ite Lock Pin pa ee Light kit Canopy Cover of Collar Screw Blade Blade Screw Light kit Bottom Glass o Finial Triarch International Inc Page 4 TAA50108022. CF 3000 52 CEILING FAN MODEL CF 3000 7 To Begin Weight 27 01 Lbs LISTED Check to make sure you have the following Required Helpful es YG electrical tape Phillips screwdriver A C Tester Light do it yourself guide ra q Y pliers safety glasses tape measure wire cutters step ladder wire strippers Page 1 Preparation Important When using an existing outlet box be sure the box is securely attached to the building structure and can support the full weight of the fan Failure to do so can result in serious injury or death Turn off circuit breakers and wall switch to the fan supply line leads A Warning Failure to disconnect power supply prior to installation may result in serious injury or death Secure mounting bracket to electrical box Important If using the angle mount make sure open end of mounting bracket is installed facing the roof Downrod Fan Mounting Downrod Mounting Check to make sure blades are at least 30 inches from any obstruction Check downrod fength to ensure blades are at least 7 feet above the floor Helpful Hint Downrod style mounting is best suited for ceilings 8 feet high or higher For taller ceilings you may want to use an extension rod not included Angle style mounting is best suited for angled or vaulted ceilings A longer extension rod will be needed to ensure proper blade clearance 1 Remove the clip and Slip the downrod pin fr
3. om the over the wire downrod Insert sleeve align the hole and reinstall the pin and clip Firmly tighten both downrod set screws the downrod through the canopy and cover of collar with the ball towards the ceiling Feed wires from the fan motor through the downrod Hang the fan in the mounting bracket Align the slot in the ball with the tab on the bracket Page 2 Wiring A Important Make sure wiring box is properly grounded or that a ground green wire is present Note Black wire is hot power for fan Blue wire is hot power for optional light kit White wire is common for fan and light kit Green wire is ground Orange wire is for uplight kit A Warning If house wires are different colors than referred to above Stop immediately A professional electrician is recommended to determine wiring 3 Screw on wire nuts in a clockwise direction Tape nuts and wires together If using downrod mount connect green wire from downrod to green wire on mounting bracket Strip 3 4 inches of insulation from wire ends Twist stripped ends together with Ppliers white to white black to black and blue to blue or black and blue to black and green to green ne A Warning Be sure no bare wire or ground Snip ends wire strands are visible after making connection Place green and white connections on opposite side of box from the black and blue if applicable connections Final Installation 1
Download Pdf Manuals
Related Search