Casio Watch 5138 User's Manual
Contents
1. The stopwatch lets you measure elapsed time up to 29 minutes 59 seconds To measure elapsed time 1 Press to start the stopwatch 2 Press to stop the stopwatch e You can resume the measurement operation by pressing again 3 Check the elapsed time e The example below shows an elapsed time of two minutes 25 seconds Stopwatch minute hand 2 minutes A J Stopwatch second hand 25 seconds Kee j e Press to reset the stopwatch This will enter the Timekeeping Mode Notes e Do not try to perform stopwatch operations while the crown is pulled out either to the first or second click If you try to press a button you might accidentally cause the crown to rotate and change the current time or day setting Perform the following procedure if the stopwatch minute hand and or second hand do not return to their proper positions when you press 8 to reset the stopwatch To adjust the positions of the stopwatch hands 1 Press 8 to reset the stopwatch and check the alignment of the stopwatch minute hand and second hand Pull out the crown to the second click Press to move the stopwatch minute hand and second hand e Use to advance the stopwatch second hand by one second Holding down will advance the hand at high speed e To return the stopwatch minute hand to the proper position press After making the adjustments you want push the crown back in to its normal position e Note that pulling the crown out al2. MA0909 EA Operation Guide 5026 5138 casio e The configuration of your watch may differ somewhat from that shown in the illustration To set the time Minute hand 1 Pull the crown out to the second click when the second hand First click stops Setting day and 2 Set the hands by rotating the day of the week crown Rotate the crown to move the hands clockwise Move the minute hand four or five minutes past the time you Second click want to set and then back it up Setting time to the proper setting e Carefully set the time making Da Crown A sure to distinguish between Second hand y Normal position AM and PM Push the crown back in to the Day of the week normal position to restart timekeeping To set the day 1 Pull the crown out to the first click 2 Set the day by rotating the crown away from you in the direction indicated by the arrow in the illustration 3 Push the crown back in to the normal position Avoid changing the date setting while the current time is between 9 00 p m and 1 00 a m To set the day of the week 1 Pull the crown out to the first click 2 Set the day of the week by rotating the crown towards you in the direction indicated by the arrow in the illustration 3 Push the crown back in to the normal position e Avoid changing the day of the week setting while the current time is between 11 00 p m and 2 00 a m Using the Stopwatch Stopwatch second hand Stopwatch minute hand
3. so stops the timekeeping second hand After performing the above procedure you should also adjust the timekeeping setting For a watch with an elapsed time bezel Rotate the elapsed time bezel to align the 7 mark with the minute hand After certain amount of time elapsed read the graduation on the elapsed time bezel which the minute hand points to The elapsed time is indicated Elapsed time bezel e Some water resistant models are equipped with a screw lock crown e With such models you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out Do not pull too forcibly on such crowns e Also note that such watches are not water resistant while their crowns are loosened Be sure to screw the crowns back in as far as they will go after making any setting Specifications Accuracy at normal temperature 20 seconds a month Display 3 analog hands timekeeping hour minutes and stopwatch seconds 3 dials timekeeping seconds stopwatch minutes and day of the week day Stopwatch function Measuring capacity 29 59 Measuring unit 1 second Measuring mode Elapsed time Battery One silver oxide battery Type SR626SW Approximately 2 years on type SR626SW assuming one stopwatch operation 60 min day
Download Pdf Manuals
Related Search