Koblenz BP-1400 vacuum cleaner
Contents
1. 4 Koblenz SERVICE MANUAL PARTS LIST BACKPACK VACUUM MODELS BP 1400 KOBLENZ ELECTRICA S A DE E mail thorne_scsm koblenz electric com J91A43S u APRIL 09 LP BP1400 200904 APRIL 09 l WARNING INSTRUCTIONS 3 II SAFETY PRECAUTIONS 4 SPECIFICATIONS 4 VI MAINTENANCE 4 V TROUBLE SHOOTING CHART 5 VI OPERATION INSTRUCTIONS 6 VII REPLACEMENT PROCEDURES 7 VIII ASSEMBLY VACUUM 8 IX PART LIST 9 2 APRIL 09 WARNING INSTRUCTIONS To reduce risk of fire electric shock or injury gt not use outdoors or on wet surfaces Donotleave vacuum cleaner unattended when plugged in Turn off the switch and unplug the electrical cord when not in use and before servicing Donotallow to be used as a toy Close attention is necessary when used by or near children Use only as described in this manual Use manufacturer s recommended attachments gt Do not use with damaged cord or plug If vacuum cleaner is not working as it should has been dropped damaged left outdoors or dropped into water return it to a service center before using gt not pull or carry by cord use cord as a handle close a door on cord or pull a cord around sharp edges or corners Do not run vacuum cleaner over cord Keep cord away from heated surfaces gt Do not use extension cords or outlets with inadequate current carrying capacity Turn off all controls before unplugging gt han2. APRIL 09 IX LIST PART No QTV 1 4 7 8 49 5802 1 POST FILTER 9 49 5803 9 PAPER BAG 10 PACK 10 11 12 13 14 15 16 49 5806 2 FRONT PLATE 17 49 5807 0 BACK PLATE 18 49 5808 8 COVER 19 49 5800 22 9 TOP MOTOR MOUNT 49 5800 26 0 LEFT SHOULDER HARNESS OO DINO ICO IS co 1 O JO1 NOT ILLUSTRATED 42 43 44 45 46 47 48 49 50 51 49 5800 27 8 TELESCOPE WAND 52 49 5800 28 6 50 CABLE EXTENSION 16 9 APRIL 09 k Koblenz FACTORY AUTHORIZED SERVICE Thorne Electric Company 610 Lanark Suite 205 San Antonio TX 78218 Tel 210 590 1226 Fax 210 590 1258 1 800 548 5741 FACTORY KOBLENZ ELECTRICA S A DE AV CIENCIA NO 26 CUAUTITLAN IZCALLI ESTADO DE MEXICO 54730 Web site http www koblenz com mx KOBLENZ ELECTRICA S A DE E thorne scsm koblenz electric com 10 APRIL 09
3. in the center of the lid will be forced into the central hole of the cardboard disk of the paper vacuum bag thus providing a tight seal Make sure the paper vacuum bag is tightly secured over the short nozzle before vacuuming Lock the lid down with the two latches Always ensure that the vacuum bag is empty before vacuuming Your Backpack vacuum has been fitted with a thermal overload switch to protect the motor against damage should the airflow be blocked for extended periods This may occur if the vacuum bag is overfull or if the vacuum hose is blocked The vacuum motor will stop before it can get too hot If this happens empty and thoroughly clean the vacuum bag or free any blockage and ensure that adequate airflow is restored The motor will automatically restart after it has cooled to a safe operating temperature 1 The vacuum hose is fitted into the cuff in the lid It should not be necessary to remove the hose in normal operation 2 Place the Backpack vacuum on your back adjust the shoulder straps until you feel comfortable and then tighten the waist belt The Backpack vacuum is designed to ride higher on your back for maximum comfort 3 Plug the cord into a 120 volt grounded outlet Always unwind the cord completely before vacuuming It is important to maintain the power cord in good condition This unit ships with a 50 16AWG x 3 conductor SJT extension cord Always use a 16x3 SJT extension cord when operation this u
4. E THE MOTOR 30 4 1 Follow the steps indicated on point 1 1 1 2 2 2 3 2 and 3 3 4 2 Remove screws 3 from the back rest 7 screws 6 of the Cabinet support 17 and the front cabinet 16 4 3 Remove the secondary filter plate and the seal body philips screws 5 4 4 Remove the motor cover 20 with the top motor mount 35 and the motor shroud top 37 and motor seal 38 4 5 Disconnect the harness switch and the line cable 4 6 Change the motor 30 and reassemble again 5 TO CHANGE THERMAL PROTECTION 5 1 Follow the steps indicated on point 1 1 1 2 3 2 4 2 to 4 4 5 2 Remove the shroud engine 31 together with the lower shroud for engine 5 3 Withdraw the philips screws bread head screw 4 and remove the thermal protection 5 4 Replace and reassembly again 6 TO CHANGE SWITCH HARNESS 29 6 1 Follow the steps indicated on point 1 1 1 2 2 2 3 2 4 2 to 4 5 6 2 Remove the nut heyco 13 and the safe heyco 12 to be able to remove the harness switch 6 3 Replace and reassembly again 7 TO CHANGE POWER HARNESS 10 FIG 2 7 1 Follow the steps indicated on point 1 1 1 2 2 2 3 2 4 2 to 4 5 7 2 Remove the the nut heyco 13 and the safe heyco 12 to be able to remove the harness switch 7 3 Replace and reassembly again 8 TO REPLACE POST FILTER 8 8 1 Remove the front cover 24 and the port filter 8 8 2 Replace and reassemble again 7 APRIL 09 ASSEMBLY VACUUM 8
5. dle plug or vacuum cleaner with wet hands gt not put any objects into openings Do not use with any opening blocked keep free of dust lint hair and anything that may reduce airflow gt This vacuum cleaner creates suction Keep hair loose clothing fingers and all parts of body away from openings gt Do not pick up anything that is burning or smoking such as cigarettes matches or hot ashes Do not use without dust bag in place Use extra care when cleaning on stairs Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present gt Store your cleaner indoors in a cool dry area Donotunplug by pulling on cord To unplug grasp the plug NOT THE CORD THESE MODELS ARE GROUNDED CONNECT TO A PROPERLY GROUNDED OUTLET ONLY SEE GROUNDING INSTRUCTIONS GROUNDING INSTRUCTIONS This appliance must be grounded If it should malfunction or breakdown grounding provides a path of least resistance for electric current to reduce the risk of shock This appliance is equipped with a cord having an equipment grounding conductor and grounding plug The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances WARNING Improper connection of the equipment grounding conductor can result in a risk of electric shock Check with a qualified electrician or service person if you are in doubt as to whether the ou
6. enter if you suspect any potential problems Use only approved paper vacuum bags Ensure that the flexible vacuum bag ring provides a proper seal 4 APRIL 09 V TROUBLE SHOOTING CHART 1 MOTOR DOES NOT RUN PROBLEM POSSIBLE CAUSE Bad ON OFF switch Check motor and wiring There is no voltage line Check voltage line 2 LOW SUCTION PROBLEM Full paper bag Closed hose or wand Slow motor Capped secondary filter LOW POWER PROBLEM POSSIBLE CAUSE Suction control dial Check position of suction control dial Motor damaged Bad electrical connection Filters obstructed Change of filters ELECTRICAL CHARACTERISTICS VOLTAGE pH oazy 60H2 5 APRIL 09 VIL OPERATING INSTRUCTIONS Please read the following operating instructions carefully They will help you to get the best performance from this professional quality vacuum cleaner and to maintain it in optimum condition Follow these simple steps for easy and effective operation of the Backpack vacuum Open the lid and ensure that the cloth bag is correctly located and the flexible ring provides a proper seal when the lid is closed For optimum filtration and maximum hygiene it is advisable to use a paper vacuum bag in addition to the standard cloth bag If you use a paper vacuum bag simply insert it into the cloth bag making sure that the cardboard disk is centered on the flexible sealing ring When you replace the lid the short nozzle
7. fabric Do not kink or twist the power cord Do not attempt to service the vacuum yourself Repair by anyone other than an authorized repair service center may void the warranty Do not vacuum water or liquids Do not vacuum up hard or sharp objects as they may damage the hose vacuum bag or the vacuum motor Do not drop the vacuum on the floor Do not operate the vacuum while it is standing on high pile carpet It is essential that the exhaust airflow is not restricted Do not wash or launder the cloth vacuum bag It would destroy the filtration capacity of the fabric Do not kink or twist the power cord Do not attempt to service the vacuum yourself Repair by anyone other than an authorized repair service center may void the warranty SPECIFICATIONS POWER AMPER FILTRATION Hz 1400 W 11 5 4 STAGE 60 IV MAINTENANCE Clean the cloth vacuum bag regularly After emptying the vacuum bag turn it inside out and shake as much dust out of the fabric as possible Optimum performance is achieved by using a paper vacuum bag with the cloth bag Check the power cord for damage Always unwind the cable completely Ensure that the vacuum hose the extension wand and the vacuuming accessories are not blocked Ensure that the electrical outlet and the plug are securely connected Incorrect connections may cause sparking and damage to the cable socket Have your Backpack Vacuum served by an authorized repair service c
8. nit Use care when pulling the cord around sharp edges and through doorways Never operate the Backpack vacuum if the power cord is damaged in any way 4 Attach the extension wand to the hose and fit the floor tool or any of the other vacuuming accessories on the wand 5 Tum the vacuum on The toggle switch is located on the switch box You may clip the switch box to the waist belt Turn off main power switch and unplug unit from wall outlet Remove vacuum hose from top of unit Release the two latches and lift off iid Separate lid from paper bag insert and dispose of paper bag Ly Remove cloth filter bag gt clean dust and replace Dp Insert new paper bag making sure to alian lid nozzle with bag hole and replace latches 5 APRIL 09 VIL REPLACEMENT PROCEDURES 1 TO REPLACE PAPER BAG 9 1 1 To change the bag of paper 9 release the cover side latches 2 1 2 Lift up the cover 18 1 3 Replace the paper bag and reassemble the cover 9 2 TO REPLACE CLOTH BAG 28 2 1 Follow the steps indicated on point 1 1 and 1 2 2 2 Remove the cloth bag 2 3 Change the fabric bag and reassemble again 3 TO CHANGE THE SECONDARY FILTER FRAME HEPA 22 3 1 Follow the steps indicated on point 1 1 1 2 and 2 2 3 2 Remove the framework of the secondary filter hepa 22 3 3 Remove the secondary filter hepa 22 and reasemble again 4 TO CHANG
9. tlet is properly grounded Do not modify the plug provided with the appliance if it will not fit the outlet have a proper outlet installed by a qualified electrician This appliance is for use on a normal 120 volt circuit and has a grounded plug that looks like the plug illustrated in sketch A A temporary adapter that looks like the adapter illustrated in fig B and C may be used to connect this plug to a 2 pole receptacle as shown in fig B if a properly grounded outlet is not available The temporary adapter should be used only until a properly grounded outlet fig A can be installed by a qualified electrician The green colored rigid ear lug or the like extending for the adapter must be connected to a permanent ground such as a properly grounded outlet box cover Whenever the adapter is used it must be held in place by a metal screw Note In Canada the use of a temporary adapter is not permitted by the Canadian Electrical Code ADAPTER GROUNDING PIN GROUNDING SCREW 3 APRIL 09 V VV VV V VV SAFETY PRECAUTIONS Do not vacuum water or liquids Do not vacuum up hard or sharp objects as they may damage the hose vacuum bag or the vacuum motor Do not drop the vacuum on the floor Do not operate the vacuum while it is standing on high pile carpet It is essential that the exhaust airflow is not restricted Do not wash or launder the cloth vacuum bag It would destroy the filtration capacity of the
Download Pdf Manuals
Related Search