DT Research DT590IB
Contents
1. DT590IC DT5901B I O Ports The DT590IC DT5901B has a comprehensive set of I O ports The following ports are located along the lower rear edge of the display unit gt GD ED CED DOOUO EANNAN ene Top Camera optional Side panel function buttons 2 USB ports Q Q Smart card reader optional E Battery packs optional Dc in USB ports Q Ethernet port RJ45 Audio jacks Q Display port COM port Options The DT590IC DT5901B has a number of optional modules These include e 2 mega pixels front camera with echo cancellation microphone e Smart card reader DT Research Inc 2000 Concourse Drive San Jose CA 95131 http www dtresearch com DT Resea rc h Copyright 2012 DT Research Inc All Rights Reserved DT Research is a registered trademark of DT Research Inc BOG010213DTS90ENG ENGLISH 4 DT Rese arch Medical Cal DT5901C DT5901B INTRODUCTION Thank you for acquiring DT Research s _ oe DT590IC DT5901B medical cart computer With a 19 inch TFT display and powered by the Intel Celeron or Core i7 processor the DT590IC DT590IB offers optimal combinations of performance and power savings With fully integrated point of care modules within an elegant space saving design the DTS90IC DT5901B is the optimum solution to enhance workflow and service Please take a few moments to review the contents of this document to ensure that the se2. at operates on the Microsoft Windows Bluetooth protocol The Bluetooth configuration application is invoked from the System Tray or from the Control Panel Follow the instructions and options provided within the application to configure and invoke Bluetooth connectivity with the corresponding peripherals NOTE Bluetooth devices or accessories that are not compatible with the Microsoft Windows Bluetooth protocol may not work with the DT590IC DTS9OIB
3. d using the Power Button hold 4 seconds feature to turn off the device this form of hardware shutdown is intended to be a means of recovery from device lockups and not as normal operation Power Battery LED Status e Blue indicates the battery is 25 to 100 charged e Blinking blue indicates the battery is charging e Orange indicates that the battery is between 11 to 25 e Blinking Orange indicates that the battery is below 10 Battery Indicator Wireless Networking Wireless LAN The DT590IC DT590IB is often delivered with an embedded user inaccessible 802 11a b g n WLAN adapter equipped with a hidden custom antenna e Through the support of typical WLAN adapters the The DTS590IC DT5901B should be able to detect all 802 11 access points in the vicinity for you to select the access point of your choice for connection e The SSID and WEP WPA WPA2 if enabled parameters on the DTS90IC DT590IB and the access points have to match The SSID is case sensitive and it is recommended that you enable WEP WPA WPA2 encryption or advanced alternatives for secure access e When WEP WPA WPAZ2 is enabled you may need to consult your network administrator or your networking equipment literature to properly configure associated settings such as Authentication mode etc e Refer to the access point operating manuals for setting up the 802 11 access points Bluetooth The DT590IC DT590IB features a built in Bluetooth adapter th
4. th the battery packs please open the battery slot caps and then put in the battery packs one by one If not please use the AC DC adapter with the DT590IC DT590IB for the power supply To activate the DTS90IC DT590IB push and quickly release the Power Button and the display will come on in a few seconds To put in Standby mode push and quickly release the Power Button To turn off for extended storage power off the device safely using any software function that shuts down computer provided in the software operating system NOTE The battery packs shipped with your device may be low in power please use the AC DC adapter with the DTS90IC DT590IB when setting up the device for the first time to fully charge the internal battery packs You may charge the external battery packs with them attached to the DTS90IC DT5901B or with the optional battery charger kit NOTE When the battery pack s is are charging the blue colored Battery LED should blink slowly If plugging in the AC DC adapter does not trigger this blinking activity and the LED stays dark the battery pack s may have been drained substantially Try unplugging replugging the AC DC adapter to the DT590IC DT590IB a few times to activate the charging process NOTE To conserve power use push and quick release the Power Button to put the device in Standby mode while not in use Pushing briefly on the same button will wake up the system within seconds NOTE Avoi
5. tup and startup proceed smoothly The DT590IC DT5901B medical cart computer is ready for use out of the box in its default configuration when powered by the power source provided The following discussion offers guidance on the hardware elements and features of the DT590IC DT5901B Please refer to your device provider for information pertaining to the software operating system or software applications Package Contents e One DT590IC or DT5901B e Three DR202 Li ion batteries optional e AC DC power adapter with power cord e Basic operation guide e Desktop stand optional DT590IC DT5901B Precautions e Always exercise care when operating and handling the DT590IC DT5901B e Never disassemble any portion of the enclosure as this will void any product warranty on the DT590IC DT590IB e Do not use any AC DC adapter other than the one provided with the device or a replacement acquired from the manufacturer e Inthe unlikely event that smoke abnormal noise or strange odor is present immediately power down the DT590IC DT590IB and disconnect all power sources Please report the problem to your device provider immediately Basic Features The DT590IC DT590IB integrates a bright 19 display with optional IR touch USB ports and is complemented by a suite of options including a front camera and a smart card reader for comprehensive point of care applications Powering ON and OFF If your DTS90IC DTS90IB comes wi
Download Pdf Manuals
Related Search