SCOTT CX 82 Sola
Contents
1. MH SCOTT CX 82 Dual Alarm Clock Radio with Digital Display C Instruction Manual PACKAGE INCLUDES 1 The unit 2 Instruction manual LOCATION OF CONTROLS ALARM SLEEP OFF button 8 1413 11 ALARM button TIME button SNOOZE button FAST button SLOW button SLEEP button ALARM 1 1 2 2 switch TUNING knob 10 LED display 11 VOLUME OFF BUZZER knob 12 ON OFF AUTO switch 12 6 13 Clock back up battery cover 14 FM antenna wire and AC power cord ONENEAN INSTALLING BATTERIES Installing the clock back up battery Clock back up The clock and alarm time can be maintained during a power failure with a 9V 6F22 battery not supplied During power failures the clock time may gain or lose a few minutes per hour and may require resetting Battery insertion 1 Remove the battery cover on the bottom of the unit by pressing the top edge 2 Insert a 9V 6F22 battery an alkaline battery is recommended into the battery compartment following the correct polarities marked inside the battery compartment 3 Replace the battery cover Note For optimum performance the battery should be replaced every 6 months Precautions when using batteries 1 Use only the size and type of battery specified 2 Ensure you follow the correct polarities when installing the battery as indicated in the battery compartment A reversed battery may damage the unit 3 An exhausted battery must be removed to prevent possible2. battery leakage 4 Dispose of batteries properly according to environmental regulations Notes on clock back up battery Please note that this unit will not operate fully by battery power alone The battery provides a back up system only in the event of an interruption of the AC power supply GB 1 CR38 SCOTT CX82 GB IM indd 1 7 13 2009 5 34 59 PM PRECAUTIONS Follow the advice below for safe and appropriate operations INSTALLATION Do not use the unit in places which are extremely hot cold dusty or humid Place the unit on a flat and even surface Do not restrict the airflow of the unit by placing it in a place with poor airflow by covering it with a cloth or by placing it on a carpet SAFETY When connecting and disconnecting the AC power cord from the AC mains outlet pull the plug and not the cord itself Pulling the cord may damage it and may be dangerous The mains plug must remain readily operable When you are not going to use the unit for a long period of time disconnect the AC power cord from the AC mains outlet AC VOLTAGE Before use check that the rated voltage of your unit matches your local voltage CONDENSATION When there is condensation inside the unit the unit may not function normally Letit stand for 1 to 2 hours before turning the power on or gradually heat the room up and dry the unit before use Ensure a minimum distance of 5 cm around the apparatus for sufficient
3. e a station 3 Adjust the volume level by turning the VOLUME OFF BUZZER knob 4 To turn off the radio adjust the ON OFF AUTO switch to OFF Achieve optimum reception In FM mode extend and position the FM antenna to achieve optimum reception MAINTENANCE Care and maintenance To clean the cabinet unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and water solution only Do not use benzene thinner or similar chemicals to clean the casing If at any time in the future you should need to dispose of this product please note that waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your local authority or retailer for recycling advice Waste mmm Electrical and Electronic Equipment Directive TECHNICAL SPECIFICATIONS Radio Tuning range FM 87 5 108 MHz Antenna FM wire antenna General Output power 300 mW Power consumption 3W Speaker 2 1 4 57 mm diameter 8 ohm impedance Power source AC 230V 50Hz Clock back up battery 9V 6F22 not supplied Dimension 40 H x 175 W x 145 D mm Weight 580 g Note Due to continuing improvements the technical specifications are subject to change without notice GB 4 CR38 SCOTT CX82 GB IM indd 4 7 13 2009 5 34 59 PM
4. m time is reached the buzzer will sound 5 To stop the alarm press the ALARM SLEEP OFF button The alarm will sound again the next day at the same time Wake to Radio Turn on and adjust the volume to desired level using the VOLUME OFF BUZZER knob and follow steps 2 to 5 in the section Wake to Buzzer for alarm operation Snooze function When the alarm sounds press the SNOOZE button to stop the alarm temporarily and it will sound again after 7 minutes To cancel the SNOOZE function press the ALARM SLEEP OFF button The alarm will sound again the next day at the same time GB 3 CR38 SCOTT CX82 GB IM indd 3 7 13 2009 5 34 59 PM Sleep function This function allows you to program the radio to turn off automatically after a certain amount of time up to 59 minutes 1 In OFF AUTO mode press and hold down the SLEEP button p and 0 59 is displayed The radio turns on Note The sleep function does not work when the ON OFF AUTO switch is in the ON position 2 Hold down the SLEEP button and press the FAST or SLOW button to adjust the minutes quickly or precisely from 59 to 0 minutes When the preset sleep duration elapses the radio turns off automatically To cancel the Sleep function before the preset sleep duration elapses press the ALARM SLEEP OFF button to turn off the radio immediately RADIO OPERATION me Listen to the radio 1 Adjust the ON OFF AUTO switch to ON 2 Turn the TUNING knob to receiv
5. ocated on the bottom enclosure GB 2 CR38 SCOTT CX82 GB IM indd 2 7 13 2009 5 34 59 PM OPERATING INSTRUCTIONS Connecting the power supply Insert the AC power cord into the AC mains outlet with a 230V AC 50Hz power source The LED display will flash Clock setting 1 Press and hold down the TIME and FAST buttons to set the clock quickly 2 Press and hold down the TIME button and press the SLOW button repeatedly to set the clock precisely minute by minute Alarm operation The unit allows you to wake up to the buzzer or radio Set the alarm time 1 1 Adjust the ON OFF AUTO switch to AUTO The alarm indicator s will light up 2 Adjust the ALARM 1 1 2 2 switch to 1 The AL1 LED indicator will light up 3 Press and hold down the ALARM and FAST buttons to set the alarm time 1 quickly 4 Press and hold down the ALARM button and press the SLOW button repeatedly to set the alarm time 1 precisely Set the alarm time 2 Follow the same steps in the section Set the alarm time 1 but adjust the ALARM 1 1 2 2 switch to the 2 position The AL2 LED indicator will light up arz Wake to Buzzer 1 Turn the VOLUME OFF BUZZER knob to BUZZ until a click sound is heard 2 Adjust the ON OFF AUTO switch to AUTO The alarm indicator s will light up 3 Adjust the ALARM 1 1 2 2 switch to select alarm 1 2 or both 1 2 The corresponding alarm indicators will light up on the LED display 4 When the preset alar
6. ventilation Ensure that the ventilation is not impeded by covering the ventilation openings with items such as newspapers tablecloths curtains etc Do not place naked flame sources such as lighted candles on the apparatus Pay attention to the environmental aspects of battery disposal Use the apparatus only in moderate climates not in tropical climates Do not expose the apparatus to dripping or splashing Do not place objects filled with liquids such as vases on the apparatus Mains plug is used as the disconnect device It shall remain readily operable and should not be obstructed during intended use To be completely disconnected the apparatus from supply mains he mains plug of the apparatus shall be disconnected from the mains socket outlet completely CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with an ATTENTION To reduce the risk of electric J The exclamation mark within arrowhead symbol within shock do not remove the cover There are no a triangle is a warning sign a triangle is a warning sign user serviceable parts inside the unit Refer all alerting the user to the pres alerting the user to the servicing to qualified personnel ence of important instructions presence of dangerous accompanying the product voltage inside the unit In case of malfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply The marking plate is l
Download Pdf Manuals
Related Search