Ergotron 97-487-800 mounting kit
Contents
1. ERGOTRON C ON www ergotron com USA 1 800 888 8458 X Europe 31 0 33 45 45 600 China 86 769 86018920 User s Guide Auto Retractable Keyboard Assembly for use with Ergotron products 25 022 60 593 CAUTION Product is shipped with a stop screw that MUST be removed before pivot use Failure to remove stop screw will cause equipment damage Max Weight Capacity Max Keyboard Depth lt 7 178 mm Minimizing Vertical Lift Storage Profile For keyboard to fit under the monitor when in storage position follow these guidelines Dimension A must be no greater than 7 7 8 200 mm NOTE Keyboard needs to attach to the lowest set of holes as shown in Step 3 Centerline of Four Hole VESA FDMI Pattern fa Rear of Monitor D E 4x 1x yyy i 3 32 M4x12mm 2x 2x gt OD q 8 32 x 1 4 E 888 97 057 W 00 rev A 03 09 Depending on the design of your VL you may need any one or combination of these 4 tools to remove your keyboard tray and pivot Depending on the design of your VL you may need any one or combination of these 4 tools to remove your keyboard tray and pivot Save these screws for use in steps 3a and 3c Pee ercccesesecssessesesecesoeseeeseel Attach pivot screws to middle set of holes third up from the bottom set so pivot attaches at lowest positi2. A 03 09 6 6 Ergotron Limited Warrant Ergotron warrants that its products will remain free of defects in material and workmanship for five 5 years All subject to the exceptions exclusions and limitations as set forth below Exceptions to this warranty include Three 3 year warranty on all Neo Flex by Ergotron products e StyleView Carts e Two 2 year warranty on all power supply components by Ergotron e Battery carries an up to a one 1 year performance warranty see Limitations below and six 6 month warranty against manufacturer s defects Note In EU the warranty against manufacturer s defects is two 2 years One 1 year warranty on all electronic non power supply components excludes AA batteries e OEM products resold by Ergotron are warranted by the respective manufacturer e Product that is refurbished by Ergotron and sold by Ergotron carries a 90 day warranty e Thirty 30 day warranty on all service programs Ergotron warranties are nontransferable Exclusive Remedy If any Ergotron equipment is or becomes defective in material or workmanship during the warranty period Ergotron will determine with the customer if the product defect is covered under warranty Ergotron at its sole discretion may replace or repair the unit determined to be under warranty at a designated Ergotron location or at the customer location The purchaser must get pre approved authorization to return product to Ergotron The Purchaser mu
3. exclusions and limitations Battery is not discharged below 25 capacity more than 25 times e Battery is fully recharged at least once every 36 hours Purchaser has not relied upon and Ergotron disclaims any and all warranties other than the expressed warranty stated above subject to the exclusions and limitations provided herein Ergotron disclaims all other warranties expressed or implied including but not limited to the warranties of merchantability and fitness for a particular purpose Ergotron further disclaims liability to purchaser and all others for all consequential incidental and special damages caused by or in connection with the products their use or misuse and their performance or nonperformance Americas Sales and Corporate Headquarters EMEA Sales ERGOTRON 2008 Ergotron Inc Allightsireserved St Paul MN USA Amersfoort The Netherlands While Ergotron Inc makes every effort to provide accurate and complete information on the installation 800 888 8458 31 33 45 45 600 and use of its products it will not be held liable for any editorial errors or omissions including those 1 651 681 7600 www ergotron com made in the process of translation from English to another language or for incidental special or www ergotron com info eu ergotron com consequential damages of any nature resulting from furnishing this instruction and performance of sales ergotron com equipment in connection with this instruction Ergotron Inc
4. ntil the tray no longer auto rises A Minimum Weight Capacity gt 0 75 Ibs 0 34 kg The equipment mounted to the tray must equal 0 75 Ibs 0 34 kg or greater for the tray to stay down with no auto rise gt ey Tighten both screws for less keyboard tilt 2 Loosen both screws for more keyboard tilt NOTE Adjust both screws equally l c You may need to adjust lift tension after equipment has been added or removed It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps Any time equipment is added or removed from this product resulting in a change in the weight of the mounted load you should repeat these adjustment steps to ensure safe and optimum operation Adjustments should move smoothly and easily through the full range of motion and stay where you set it If adjustments are difficult and do not stay in the desired position follow the instructions to loosen or tighten the tension to create a smooth easy adjustment motion Depending on your product and the adjustment it may take several turns to notice a difference 3 Follow these instructions to tighten or loosen tension Lift Up and down ee SSS KS SS ee SIER IS eS ee x DOSS SSS SOSSS SS SSS SSOSSSS Sos gt Pec eeeeccccescceseecseeseseeeeeeseeesoeseeenseeEeeS 888 97 057 W 00 rev
5. on Tighten all 4 screws ecococcococoooococococcocococoooocoooooo 888 97 057 W 00 rev A 03 09 2 6 4x yy M4 x 12mm b REMOVE STOP SCREW BEFORE USE CAUTION Product is shipped with a stop screw that MUST be removed before pivot use Failure to remove stop screw will cause equipment damage 888 97 057 W 00 rev A 03 09 3 6 8 32 x 1 4 5 a Remove and discard b 2x A Top tray must be removed for pivot to function properly bottom of the mouse tray to eliminate rattle when the tray is stowed upright acs Attach the loop soft side of the velcro to the cocooooocooo aN O i Osi ecococooooo Sterile Alcohol Prep ececoooo CEEE ALLS RSS SA SSS NT TS sSSSS SSS CL SSoSSSS OR SSS eo en s C Follow these 8 a Antonise Tension d instructions to tighten or loosen tension H 1 Mount all Equipment keyboard wrist rest mouse pad mouse ect rer 2 Tighten screw slowly turn clockwise until tray auto rises to full up position Screw may require several turns 888 97 057 W 00 rev A 03 09 4 6 Remove Auto rise NOTE If you would like to remove the auto rise feature G 1 Mount all Equipment keyboard wrist rest mouse pad mouse ect 2 Loosen screw to decrease the tension turn counter clockwise u
6. reserves the right to make changes in the product design and or product documentation without notification to its users For the most current product information or to know if this document is available in languages other than those herein please contact Ergotron No part of this publication may be reproduced stored in a retrieval system or APAC Sales Worldwide OEM Sales transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written consent of Ergotron Inc 1181 Trapp Road Eagan Minnesota 55121 USA Tokyo Japan www ergotron com Patents Pending and Patented U S amp Foreign Ergotron is a registered trademark of Ergotron Inc www ergotron com info cem ergotron com info apac ergotron com 888 97 057 W 00 rev A 03 09
7. st contact Ergotron to obtain an RMA Return Material Authorization number Ergotron will promptly repair or replace the item and ship it to Purchaser at no charge to the Purchaser Performance of repair or replacement does not renew or extend the warranty period THIS REMEDY IS THE EXCLUSIVE REMEDY FOR BREACH OF WARRANTY AS TO THE EQUIPMENT except in respect to personal injury Purchaser shall give Ergotron immediate written notice of any personal injury resulting from use of Ergotron equipment Exclusions and Limitations Ergotron disclaims liability for injuries or losses caused by or associated with installation or use of its equipment in any manner other than in strict conformance with the instructions set forth in its installation manuals supplemental assembly and installation instruction sheets technical bulletins or product literature or by equipment that has been altered damaged or misused Warranty on fully charged batteries left in an unused state for more than three 3 consecutive months is automatically void Warranty on fully discharged batteries left in an unused state for more than three 3 consecutive days is automatically void Two 2 year warranty on all power supply components by Ergotron battery carries a 90 day performance warranty and six 6 month warranty against manufacturer s defects Performance warranty is extended to 1 year on the battery providing e StyleLink software is installed and it shows compliance with
Download Pdf Manuals
Related Search