Tripp Lite RS1215-20 power distribution unit PDU
Contents
1. THIS PRODUCT EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE Specifically TRIPP LITE is not liable for any costs such as lost profits or revenue loss of equipment loss of use of equipment loss of software loss of data costs of substitutes claims by third parties or otherwise To receive service under this warranty you must be the original purchaser user of the product in question You must obtain a Returned Material Authorization RMA number from TRIPP LITE Products must be returned to TRIPP LITE with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase2. exact nature of the fault Therefore a qualified electrician should make necessary repairs If the Line Fault indicator light illuminates and power is not present at the outlets the ISOBAR s surge suppression components have been compromised as a result of surge damage For service call Tripp Lite Customer Support at 773 869 1234 Fully explain the perceived problem to the customer support person They will either remedy the problem over the phone or give you instructions about return repair or exchange Protection Present Green LED Indicates the surge suppression components are intact and providing full protection against spikes and surges This LED should be lit anytime the ISOBAR ON OFF switch is turned ON and power is present as indicated by the lighted power switch If the Protection Present LED does not light then some of the surge suppression components are not functioning and the unit should be returned for repair as soon as possible You may still use the unit however connected equipment will be protected from spikes and surges at a lesser level than normal ISOLATED FILTER BANKS amp CASCADE CIRCUITRY IBAR12 and ISOBAR12ULTRA Models Only Isolated Filter Banks prevent equipment plugged into each filter bank from interacting with equipment plugged into the other filter bank Cascade Circuitry provides different levels of protection between the Isolated Filter Banks There are two Isolated Filter Banks on IBAR12 and
3. of the ISOBAR filter networks UL 1449 1999 rev ISOBAR12ULTRA IBAR12 20ULTRA IBAR12 20T and DRS 1215 330V let through UL s best rating for surge suppression IBAR12 400V let through UL 1283 All ISOBAR models for line noise filtering CUL meets Canadian National Standards as certified by UL cL US Limited Lifetime Warranty Seller warrants this product if used in accordance with all applicable instructions to be free from original defects in material and workmanship for its lifetime If the product should prove defective in material or workmanship within that period Seller will repair or replace the product in its sole discretion Service under this warranty can only be obtained by your delivering or shipping the product with all shipping or delivery charges prepaid to Tripp Lite 1111 W 35th Street Chicago IL 60609 Seller will pay return shipping charges Call Tripp Lite at 773 869 1234 before sending any equipment back for repair The warranties of all TRIPP LITE surge suppressors are null and void if they have been connected to the output of any UPS system The warranties of all TRIPP LITE UPS Systems are null and void if a surge suppressor has been connected to its output receptacles THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT MISUSE ABUSE OR NEGLECT SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN EXCEPT TO THE EXTEND PROHIBITED BY APPL
4. ICABLE LAW ALL IMPLIED WARRANTIES INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES Some states do not allow limitations on how long an implied warranty lasts and some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitations or exclusions may not apply to you This Warranty gives you specific legal rights and you may have other rights which vary from jurisdiction to jurisdiction WARNING The individual user should take care to determine prior to use whether this device is suitable adequate or safe for the use intended Since individual applications are subject to great variation the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application Policy of Tripp Lite is one of continuous improvement Specifications are subject to change without notice Ultimate Lifetime Insurance Policy Applicable Only to ISOBAR Models Valid in U S and Canada Only TRIPP LITE warrants for the lifetime of the product at TRIPP LITE S option to repair or replace on a pro rata basis directly connected equipment that is damaged due to power transients while properly connected to TRIPP LITE products offering the ULTIMATE Lifetime Insurance Policy Reimbursement or restoration for data lo
5. ISOBAR12ULTRA models Isolated Filter Bank 2 the white outlets on these models rear panel provides the highest level of protection for your most sensitive equipment Isolated Filter Bank 1 the black outlets on these models front and rear panels provides standard protection for your less sensitive or noise producing equipment Model IBAR12 ISOBAR12ULTRA IBAR12 20ULTRA Series AGIB120V12SSRM AGIB120V12SSRM AGIB120V20SSRM AC Energy Absorption joules 1280 1280 1280 Surge Suppression amp spikes 60 000 96 000 96 000 UL 1449 Let Through Rating 400V 330V 330V HF Noise Suppression 1 MHz Filter Bank 1 40 dB 40 dB 80 dB Filter Bank 2 80 dB 80 dB AC Receptacles 2 NEMA 5 15R front 10 NEMA 5 15R back 2 NEMA 5 15R front 10 NEMA 5 15R back 2 NEMA 5 15R front 10 NEMA 5 15 20R back AC Line Cord 15 w NEMA 5 15P plug _15 w NEMA 5 15P plug _15 w NEMA 5 20P plug Circuit Breaker Resettable 15 amp 15 amp 20 amp Dimensions HxWxD inches 1 7 x 17 3 x 3 4 1 7 x 17 3 x 3 4 1 7 x 17 3 x 3 4 Weight lbs 4 6 5 0 5 4 Model IBAR12 20T RS 1215 RS 1215 20 Series AGIB120V20SSRM AGIP120V6IPRM AGIP120V20RM AC Energy Absorption joules 1280 NONE NONE Surge Suppression amp spikes 96 000 NONE NONE UL 1449 Let Through Rating 330V HF Noise Suppression 1 MHz Filter Bank 1 80 dB NONE NONE Filter Bank 2 NONE NONE AC Receptacles 2 NEMA 5 15R f
6. TRIPP LITE Owner s Manual POWER PROTECTION Rackmount Power Strips and Isobar Rackmount Surge Suppressors Line Noise Filters Designed to Occupy One Standard 19 in Rack Space Espanol p 5 Fran ais p 9 IMPORTANT SAFETY INSTRUCTIONS This manual contains information concerning the proper installation and use of Tripp Lite s Rackmount Power Strips and Isobar Surge Suppressors SAVE THESE INSTRUCTIONS Devices with surge protection feature an internal protection that will disconnect the surge protective component at the end of its useful life but will maintain power to the load now unprotected IBAR12 ISOBAR12ULTRA RS 1215 RS 1215 RA RS 1215 HG DRS 1215 DO NOT exceed the MAXIMUM LOAD of 15 amps that can be drawn from each AC outlet DO NOT exceed the MAXIMUM LOAD of 15 amps that can be drawn from all the outlets combined IBAR12 20ULTRA IBAR12 20T RS 1215 20 DO NOT exceed the MAXIMUM LOAD of 15 amps that can be drawn from each AC outlet located on the front of the IBAR12 20ULTRA and IBAR12 20T DO NOT exceed the MAXIMUM LOAD of 20 amps that can be drawn from each AC outlet on the RS 1215 20 or each AC outlet located on the rear of the IBAR12 20ULTRA and IBAR12 20T DO NOT exceed the MAXIMUM LOAD of 20 amps that can be drawn from all the outlets combined Rackmount Installation To Mount Unit in Rack Put four user supplied rackmount screws A through the unit s mounting ears B and into the rack ra
7. ency see specifications this switch will illuminate RED when moved to the ON position This indicates 120V AC power is present at the model s AC receptacles Diagnostic Indicator Lights ISOBAR Models Only When your surge suppressor is plugged into an AC outlet providing power of appropriate voltage and frequency see Specifications the three LEDs on the front panel show current power conditions as follows from left to right across the front of the unit Line OK Green LED Indicates that nominal AC power is present with no wiring faults detected When this LED is illuminated AC power is safe for connected equipment Line Fault Red LED Indicates a wiring fault has been detected If this LED illuminates at any time the unit is plugged in the fault should be repaired by a qualified electrician as soon as possible This LED indicates that phases are reversed ground is missing or some other sort of wiring error exists in the circuit the ISOBAR is plugged into The Line Fault detector circuitry will identify most common wiring faults but will not necessarily detect every possible type of fault If the Line Fault indicator light illuminates carefully check the AC receptacle the ISOBAR is plugged into The receptacle must be tight and securely grounded A loose AC receptacle may cause the Line Fault LED to illuminate It must be understood that this Red LED indicates the presence of a wiring fault but does not indicate the
8. ils as shown The user must determine the fitness of the rackmount screws to hold the unit in the rack before installation Wallmount Under Counter Installation 1 Detach Mounting Ears Unscrew the screws A holding the unit s mounting ears B to the sides of the unit 2 Reorient Mounting Ears Use the screws from Step 1 A to reattach the mounting ears B to the unit as shown Use only the manufacturer supplied screws or their equivalent 6 32 4 flat head to reattach the mounting ears The screws should be put through diagonally opposite holes on the ear 3 Mount Unit on Surface Put four user supplied screws C or similar mounting hardware through the unit s mounting ears B and into the mounting surface as shown The user must determine the fitness of the user supplied mounting hardware to support the unit before mounting Steps 2 amp 3 Circuit Breaker all Models If the current draw of the equipment connected to your model exceeds your model s circuit breaker rating 15 or 20 amps see Specifications for longer than a few seconds the circuit breaker will trip to prevent any possible damage When the circuit breaker trips its plunger will be extended Remove excess equipment and allow the breaker to cool one minute before depressing its plunger to reset the breaker Illuminated On Off Switch ati Models When your model is plugged into an AC outlet providing power of appropriate voltage and frequ
9. ion All above warranties are null and void if the TRIPP LITE product has been improperly installed tampered with or altered in any way or if the connected equipment was not used under normal operating conditions or in accordance with any labels or instructions All claims under this warranty must be submitted in writing to Tripp Lite within 30 days of the occurrence or the claim will not be considered This warranty does not include damage resulting from accident or misuse and applies to the domestic USA amp Canada use of these products only Tripp Lite reserves the right to determine whether the damage to the connected equipment is due to malfunction of the Tripp Lite product by requesting the equipment in question be sent to Tripp Lite for examination This policy is above and beyond only to the extent needed of that provided by any coverage of connected equipment provided by other sources including but not limited to any manufacturer s warranty and or any extended warranties EXCEPT AS PROVIDED ABOVE TRIPP LITE MAKES NO WARRANTIES EXPRESS OR IMPLIED INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE Some states do not permit limitation or exclusion of implied warranties therefore the aforesaid limitation s or exclusion s may not apply to purchaser EXCEPT AS PROVIDED ABOVE IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF
10. ront 10 NEMA 5 15 20R back 6 NEMA 5 15R front 6 NEMA 5 15R back 6 NEMA 5 20R front 6 NEMA 5 20R back AC Line Cord 15 w L5 20P plug 15 w NEMA 5 15P plug _15 w NEMA 5 20P plug Circuit Breaker Resettable 20 amp 15 amp 20 amp Dimensions HxWxD inches 1 7 x 17 3 x 3 4 1 7 x 17 3 x 3 4 1 7 x 17 3 x 3 4 Weight Ibs 5 4 4 6 4 6 Model RS 1215 RA RS 1215 HG DRS 1215 Series AGIP120V6IPRM AGIP120V6IPRM AGIB120V12LCRM AC Energy Absorption joules NONE NONE 1050 Surge Suppression amp spikes NONE NONE 36 000 UL 1449 Let Through Rating 330V HF Noise Suppression 1 MHz Filter Bank 1 NONE NONE NONE Filter Bank 2 NONE NONE NONE AC Receptacles 6 NEMA 5 15R front 6 15A hospital grade front 6 NEMA 5 15R front 6 NEMA 5 15R back 6 15A hospital grade back _ 6 NEMA 5 15R back AC Line Cord 15 WNEMA 5 15P plug 15 w 15A hospital grade plug 15 w NEMA 5 15P plug Circuit Breaker Resettable 15 amp 15 amp 15 amp Dimensions HxWxD inches 1 7x17 3x 3 4 1 7x 17 3 x 3 4 1 7x17 3x4 Weight Ibs 4 6 4 6 4 6 Spike protection is provided in all three modes hot to neutral hot to ground and neutral to ground All Models Nominal Input Voltage 120VAC Input Frequency 50 60 Hz All ISOBAR Models Transient Response Time Instantaneous 0 ns Transient amplitude reduction occurs faster than the clamp response of the varistors because of the high rejection rate
11. ss is not included Power transients include spikes and surges on the AC power data or telephone lines that the TRIPP LITE products have been designed to protect against as recognized by industry standards AC Power Line Transients To claim damages the TRIPP LITE product must be plugged into a properly wired and grounded outlet No extension cords or other electrical connections may be used The installation must comply with all applicable electrical and safety codes set forth by the National Electrical Code NEC Except as provided above this warranty does not cover any damage to properly connected electronic equipment resulting from a cause other than an AC power transient If user meets all of the above requirements TRIPP LITE will repair or replace at TRIPP LITE S option equipment up to the specified value See ULTIMATE Lifetime Insurance Policy Limits No coverage is allowed for damage entering from telephone or data lines unless they are separately protected as described below Reimbursement dollar limits will be equal to that of the Tripp Lite power protection protector Coverage is excluded where a suitable environment for the protection device is not provided including but not limited to lack of a proper safety ground Telephone service equipment must also include a properly installed and operating primary protection device at the telephone service entrance such devices are normally added during telephone line installat
Download Pdf Manuals
Related Search