Zonet ZFS3018P network switch
Contents
1. ZFS3015P ZFS53018P 5 8 Port 10 100Mbps Switch Quick Installation Guide Package Contents e One ZFS3015P ZFS3018P e One Quick Installation Guide e One Power Adapter Contact your local authorized reseller or the store purchased from for any items damaged and or missing Top Panel LED indicators Power Green Steady Power is ON Steady Network cable connected and connection established LNK ACT Green Flash Data packets are transmitting Off Network cable is unplug Diagram a ZFS3015P 0000000000000000000000000000000000000 Zonet Power gt connector 5 Port 10 100Mbps Switch ZFS3015P 5 4 3 2 1 PWR Note Power Connector is on the marked side of ZFS3015P b ZFS3018P 0000000000000000000000000000000000000 Power gt connector 8 Port 10 100Mbps Switch ZFS3018P 8 7 6 5 4 3 2 1 PWR Note Power Connector is on the marked side of ZFS3018P Rear Panel a ZFS3015P 5 RJ 45 ports b ZFS3018P 8 RJ 45 ports Installation 1 2 Connect the provided power adapter to the Power connector of the ZFS3015P ZFS3018P Connect your network devices to the RJ 45 ports of the ZFS3015P ZFS3018P with UTP STP Category 3 4 5 cables Caution The switch must put on a surface that is able to hold at least 5kgs weight Power adapter must be connected to the switch properly and securely Suggested at least 10cm empty space around the unit for sufficient ventilation and coolin2. g Do not recommend to put any items on top of the switch ZFS3015P ZFS3018P is not ideally to work in a high electromagnetic environment under direct sunlight dust and vibrating surfaces Maximum distance between the switch and the end node is 100 meters Must use an unshielded or shielded twisted pair UTP STP Category 5 or better cables to ensure proper transmission Loss of data packet may encounter when using cable other than Category 5 Troubleshooting da Check the power adapter and power wall jet to make sure they are function properly Check if the switch is turned ON and power LED is steady Check all cable connections between computer and the switch to make sure they are connected properly Maximum distance is 100 meters from the switch to end nodes Link LED s is ON flashing at the connected port s of the switch Test your computer s network adapter to make sure it is installed and functioned properly Check issues such as network collisions domain limitations and other physical installation aspects Make sure they all meet IEEE standard network installation requirements more details can be found at www ieee org If problem still persists write down your software hardware configuration and LED error indications and contact your local retailer or the store purchased for further assistance If the provided power adapter is missing purchase 9V 600mA power adapter for replacement
Download Pdf Manuals
Related Search