ASK C90 and C100 Projectors
Contents
1. ASK Proxima DP5900 Projectors Frequently Asked Questions How do I set up the DP5900 remote mouse The DP5900 can emulate a mouse when connected to a computer using one of the remote mouse cables serial PS 2 or Mac ADB provided with the projector In most cases the DP will automatically detect and configure the remote when the computer boots There are a few cases where the DP will not be detected as a mouse Before you begin ensure that if using an older operating system Windows 95 In Control Panel if using the serial 9 pin remote cable verify that the mouse driver being used is a Microsoft Serial Mouse Driver Otherwise use the Microsoft PS 2 Mouse Driver when using the PS 2 remote cable Windows 3 1 In Windows Setup the mouse driver should be set to Microsoft or IBM PS 2 mouse when using either the serial or PS 2 remote cable Macintosh Try loading the Macintosh without any extensions loading Verify that AppleTalk is disabled If necessary disable any modems 1 Turn off your computer and disconnect the external mouse if applicable 2 Connect one end of the ASK Proxima remote cable to the computer s 9 pin serial PS 2 or ADB port and the other end into the CONTROL port on the projector Note Use VGA input 1 with control port 1 and VGA input 2 with control port 2 3 Turn on the projector and light the lamp 4 Turn on your computer It should detect the projector as a mouse 5 Use the circular mouse pad to control2. the mouse pointer If the steps above do not activate the remote mouse follow the troubleshooting steps below 1 Verify there are no Cyclops drivers loading 2 Verify an external mouse works in the same port that is used for the DP5900 mouse Example if using the serial port on your PC test the port with a 9 pin serial mouse etc 3 Verify that the various functions on the remote work e g Can it bring up the menus If not try replacing the batteries 4 If unable to operate the remote mouse power down the projector and wait one minute leave PC MAC powered on Turn the projector back on The remote mouse should now work How do you find the lamp hours on the DP5900 Push the Up Arrow button on keypad for about 20 seconds The lamp hour that is left will be displayed in the screen A display will appear near the top middle of the display Lamp hours remaining are under Data Example Service Data No Data Mode 37 1888 Lamp ON time will be 1900 1888 12 hours highest value when lamp hours are started or reset Copyright 1997 2004 InFocus Corporation All Rights Reserved
Download Pdf Manuals
Related Search