Home
Fisher-Price 71565 Baby Monitor User Manual
Contents
1. ever you change the location of the transmitter Please see section Sound Reception on page 6 e To prevent entanglement never place the transmitter in a crib or playpen Place the transmitter receiver and AC adaptor cord s out of baby s reach e To prevent entanglement do not use extension cords with the AC adaptors e The receiver battery should be removed and the AC adaptors should be unplugged from wall outlets when the Sound n Lights Monitor is not used for a long period of time e Use only the AC adaptors provided with your Sound n Lights Monitor Use of any other adaptor may damage the transmitter and or receiver 1996 Fisher Price Inc East Aurora New York 14052 B Important Information Insert the AC adaptor plugs into standard household outlets 120v AC For a good electrical connection make sure the AC adaptor plug blades are a tight fit in the outlet If the AC adaptor plug to outlet connection is loose choose another outlet location for the AC adaptor plug e Position AC adaptor cords so that they are not walked on or pinched by items placed upon or against them Do not use more than one transmitter and one receiver at the same time in the same house Never use the transmitter or receiver near water For example do not use near a bathtub washbowl laundry tub kitchen sink or wet basement etc e Place the transmitter receiver and AC adaptors where there is adequate v
2. L5R 3W2 In Great Britain telephone 01734 770488 In Australia call the Fisher Price Australian Consumer Advisory Service toll free at 1 800 800 812 or write to Fisher Price Mattel Pty Limited 461 Plummer Street Port Melbourne Victoria 3207
3. dial to a comfortable level The moving light display will light when sound is received by the receiver e If all five bars in the moving light display light The receiver power is ON and the transmitter power is OFF Turn the transmitter power ON The receiver is out of range of the transmitter Move the receiver closer to the transmitter The receiver and the transmitter are not on the same channel Set the channel switches on the transmitter and receiver to the same channel Loud sounds are transmitting Please Note The moving light display will not light if the battery is weak even though you may still hear sounds Replace the battery with a fresh 9v alkaline battery To protect your privacy be sure to turn the transmitter and receiver OFF when not in use KF Sound Reception It is very important to test the sound reception of the Sound n Lights Monitor before first time use and whenever you change the location of the transmitter Test the Sound n Lights Monitor transmission and reception In the room you intend to use the transmit ter have an adult speak into the transmitter df an adult is not available use a ticking clock or radio Place the receiver in the room in which you intend to use the receiver Adjust the receiver location or volume dial until you hear sounds clearly If you experience interference buzzing static etc while using one channel setting
4. switch both units to the other channel Selecting a channel is usually a one time adjustment If interference occurs on both channels or if further problems develop please refer to the Problems and Solutions Guide beginning on page 7 SP Care Keep the Sound n Lights Monitor free from dust The outer surface of the transmitter and receiver can be cleaned with a cloth lightly dampened with a mild cleaning solution Do not immerse any part of the Sound n Lights Monitor Kh Sound n Lights Monitor Model Number 1565 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions C1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation FCC Note United States only Fisher Price Inc Consumer Affairs Department 636 Girard Avenue East Aurora New York 14052 One 1 Year Limited Warranty Fisher Price Inc 636 Girard Avenue East Aurora New York 14052 warrants that the Sound n Lights Monitor is free from all defects in material and workman ship when used under normal conditions for a period of one 1 year from the date of purchase Should the product fail to perform properly we will repair or replace it free of charge Purchaser is respon sible for shipping the product to the address indicated above and for all associated
5. the terminals of a fresh 9v alkaline battery into the connectors e Close the battery compartment Please Note e Remove the battery during long periods of non use Always remove an exhausted battery from the product Battery leakage and corrosion can damage the product e Never short circuit the battery terminals e A non rechargable battery is not to be recharged e Only a battery of the same or equivalent type as recommended in the Battery Installation instructions is to be used If a removeable rechargeable battery is used it is only to be charged under adult supervision e A rechargeable battery is to be removed from the product before it is charged e If you use a battery charger it should be examined regularly for damage to the cord plug enclosure and other parts Do not use a damaged battery charger until it has been properly repaired E Set Up and Use IMPORTANT NOTE To prevent entanglement never place the transmitter in a crib or playpen Place the transmitter receiver and AC adaptor cord s out of baby s reach Va N Antenna On Off Switch Channel Switch Power AC Adaptor Jack i Indicator Socket Plug AC Adaptor Transmitter C e Place the transmitter in the same room with your child For best sound pick up point the microphone directly toward the crib or play area Make sure the antenna points upward for best transmission e F
6. SE SOLUTION Transmitter power indicator does not light Transmitter not turned ON Turn the transmitter ON Power is turned OFF Make sure that any light switches that control power flow to the wall outlet are ON Make sure house fuses and circuit breakers are ON AC adaptor not properly connected Check AC adaptor jack to socket and plug to outlet connections AC adaptor problem Test the transmitter using the other AC adaptor included with this product If the transmitter works with the other AC adaptor call Fisher Price at 1 800 432 KIDS to replace the broken AC adaptor Receiver power indicator does not light Receiver not turned ON Turn the receiver ON Power is turned OFF Make sure that any light switches that control power flow to the wall outlet are ON Make sure house fuses and circuit breakers are ON AC adaptor not properly connected Check AC adaptor jack to socket and plug to outlet connections AC adaptor problem Test the receiver using the other AC adaptor included with this product If the receiver works with the other AC adaptor call Fisher Price at 1 800 432 KIDS to replace the broken AC adaptor Weak or dead battery Replace the battery in the receiver with a fresh 9v alkaline battery or use the AC adaptor No sound Channel switches not on same setting Set channel switch on tr
7. Sound n Lights Monitor Model Number 71565 Please read these instructions and keep them for future reference Includes two AC adaptors to power the transmitter and receiver The receiver also runs on battery power 9v alkaline not included Fisher Price LY Consumer information Occasionally a consumer may experience a problem with one of our products If this should happen please call us toll free rather than return this product to the store Usually we can solve the problem over the telephone or by sending you replacement parts Please call Fisher Price Consumer Affairs toll free at 1 800 432 KIDS 8 AM 6 PM EST Monday through Friday Hearing impaired consumers using TTY TDD equipment please call 1 800 382 7470 Or write to Fisher Price Consumer Affairs 636 Girard Avenue East Aurora New York 14052 A CAUTION This product cannot replace responsible adult supervision of a child e Read and follow all instructions in this booklet and on the product for proper use of this product e This product is not intended to be used as a medical monitor and its use should not replace adult supervi sion It is important that an adult stay within the range of the Sound n Lights Monitor at all times during use e This product does not detect non audible functions such as a child moving e It is very important to test the sound reception of the Sound n Lights Monitor before first time use and when
8. ansmitter and receiver to the same channel Signal interference due to other nursery monitors cordless telephones etc Change the channel setting on both the transmitter and the receiver Identify and eliminate the source of interference Test reception by moving the transmitter and or receiver to different locations throughout the house Relocate the transmitter and or receiver Out of range or insufficient signal Test reception by moving the transmitter and or receiver to different locations throughout the house Relocate the transmitter and or receiver Volume not turned up Adjust volume control on receiver Improper antenna position Make sure the antenna on the transmitter and receiver are pointing upward Weak or dead battery in receiver Replace the battery in the receiver with a fresh 9v alkaline battery or use the AC adaptor AC adaptor not properly connected Check AC adaptor jack to socket and plug to outlet connections PROBLEM PROBABLE CAUSE SOLUTION Weak reception Out of range or insufficient signal Test reception by moving the transmitter and or receiver to different locations throughout the house Relocate the transmitter and or receiver AC adaptor cord s not fully extended Fully extend AC adaptor cord s Improper antenna position Make sure antennas are pointing upward Receiver moving light display does not light Weak
9. entilation To prevent overheating keep the transmitter receiver and AC adaptors away from heat sources such as radiators heat registers direct sunlight stoves amplifiers or other appliances which produce heat e Always remember that you are using public airwaves when you use the Sound n Lights Monitor Conversations even from rooms near the transmitter may be broadcast to other nursery monitors radios cordless telephones or scanners outside your home To protect the privacy of your home always turn the transmitter off when the Sound n Lights Monitor is not in use e Any modification of the transmitter or the receiver will violate FCC compliance and can void the user s authority to operate the equipment The Sound n Lights Monitor is not designed for consumer repair If your Sound n Lights Monitor is not working properly please refer to the Problems and Solutions Guide beginning on page 7 71565 1 71565 0920 C Your Sound n Lights Monitor Transmitter On Off Switch Turns the transmitter power ON or OFF Power Indicator tg Ande tate as Sends transmits sounds to the receiver alts te Beth epiek Lights up to let you know the transmitter is ON Microphone For clear audio pick up 2 Position Channel Switch Flexible Antenna Aids in sound transmission AC Adaptor Socket on side Allows y
10. freight and or insurance cost Fisher Price Inc will bear the cost of shipping the repaired or replaced item to you This warranty is void if the owner repairs or modifies the product This warranty excludes any other liability other than the above mentioned including but not limited to any incidental or consequential damages SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATION OR EXCLU SION MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE Important Note The electronic components in the Sound n Lights Monitor are not designed for consumer repair Evidence of any attempt at consumer repair will void the warranty Return the AC adaptors transmitter and receiver please remove the battery from the receiver before sending to Fisher Price Inc for service Problems and Solutions Guide IMPORTANT If you have a problem with the Sound n Lights Monitor first check the Problems and Solutions Guide below If you still experience a problem with the Sound n Lights Monitor call Fisher Price Consumer Affairs toll free at 1 800 432 KIDS 8 AM 6 PM EST Monday through Friday Hearing impaired consumers using TTY TDD equipment please call 1 800 382 7470 Or write to Fisher Price Consumer Affairs 636 Girard Avenue East Aurora New York 14052 PROBLEM PROBABLE CAU
11. or best transmission unwrap and fully extend the AC adaptor cord Insert the AC adaptor jack into the transmitter socket e Insert the plug into a standard wall outlet Set the transmitter channel switch to the same channel as the receiver e Slide the on off switch on the front of the transmitter to the ON position The power indicator will light Antenna Po Moving Light Display On Off Switch Receiver AC Adaptor Use XS a Antenna Moving Light Display On Off Switch Power Indicator Channel Switch Volume Dial Receiver Battery Use Ne e Decide whether you will use the AC adaptor or a 9v alkaline battery to power the receiver If you will be using the receiver near an outlet we recommend using the AC adaptor e Place the receiver where you can hear see it Or wear the receiver using the convenient belt clip Make sure the antenna points upward for best reception If you will be using the AC adaptor to power the receiver unwrap and fully extend the AC adaptor cord for best reception Insert the AC adaptor jack into the side of the receiver Insert the plug into a standard wall outlet e Check to be sure the channel switch on the receiver is set to the same channel as the transmitter Slide the on off switch on the front of the receiver to the ON position The power indicator will light e Adjust the volume by turning the volume
12. or dead battery in receiver Replace the battery in the receiver with a fresh 9v alkaline battery or use the AC adaptor Interference buzzing static etc Signal interference due to other nursery monitors or cordless telephones etc Change channel switch on both transmitter and receiver to the other channel Identify and eliminate source of interference Do not use more than one receiver or transmitter at the same time in the same house Channel switches not on same setting Check channel switch on transmitter and receiver to be sure they are on the same channel Feedback squealing or whistling Receiver is too close to the transmitter Move receiver further away from transmitter Volume is set too high Lower volume on the receiver All five bars on the receiver moving light display light Receiver power is ON but transmitter power is OFF Turn the transmitter power ON Out of range or insufficient signal Move the receiver closer to the transmitter Channel switches not on same setting Check channel switches on transmitter and receiver to be sure they are on the same channel AC adaptor not properly connected to transmitter Check AC adaptor jack to socket and plug to outlet connections If you have any questions about this product In Canada call 1 800 567 7724 or write to Mattel Fisher Price 6155 Freemont Blvd Mississauga Ontario
13. ou to change channels if interference occurs For use with the provided AC adaptor Receiver 00 Receives signal from the transmitter to hear sound Volume Dial Controls the volume of sound Power Indicator Lights up to let you know the receiver is ON Moving Lights Display Shows sounds are being transmitted Speaker 0 Allows you to hear baby s sounds 2 Position Channel Switch AC Adaptor Socket on side Battery Compartment Door Flexible Antenna Belt Clip on back AC Adaptors 2 included On Off Switch Allows you to change channels if interference occurs For use with the provided AC adaptor For easy access to battery compartment Aids in sound reception For added portability when moving from room to room Both the transmitter and receiver operate on standard household current 120v AC outlet with either of these AC adaptors Turns the receiver power ON or OFF D Battery Installation The receiver operates either with the AC adaptor included with your Sound n Lights Monitor or with a 9 volt alkaline battery Shown Actual Size Ne is Battery Compartment Door Ne e Locate the battery compartment door on the bottom of the receiver Push the finger tab on the battery compartment door to open the battery compartment door Snap
Download Pdf Manuals
Related Search
Related Contents
Xilinx UG069 XUP Virtex-II Pro Development System, Hardware Prozone Pool Products CSS10 User's Manual 取扱説明書 フラップバルブダイアフラムポンプ DSLink 200 Manual de instrucciones GF0.10 Tristar BL-4014 blender User Manual Lx 500 4764 PCI-X Cryptographic Coprocessor Installation Manual Manual de Instruções K 2.200 Copyright © All rights reserved.
Failed to retrieve file