SK iSD900 Quick User Guide
Contents
1. F type spray nozzle y e Screw the F type spray nozzle onto the PANA SPRAY nozzle by approx 10 turns iSD HP e Insert the F type spray nozzle into the rear part of the iSD HP and lubricate the head for 2 3 seconds If the iSD HP is not pushed into the nozzle enough oil may not get into the iSD HP and ye it may flow backward Cautions gt e Do not lubricate iSD900 motor e Before mounting the lubricated iSD HP to the iSD900 motor wipe off excess oil e Hold the iSD HP securely to prevent it from flying off by the pressure of the spray PANA SPRAY plus separately sold NSK NAKANISHI INC 700 Shimohinata Kanuma Tochigi 322 8666 Japan OM E0504E 10 03 0052. cations are subject to change without notice Setting up rotation speed Set the rotation speed before calibration 1 Starting at off mode press and hold Calibration Key and press Power Key 2 Use the UP DOWN Key for speed selection gt I 5 3 Press ON OFF Key to set the selected speed Once the rotation speed is set the system will automatically change to calibration mode Complete the calibration process described at the front 9 System switches to the rotation speed setting mode Changing batteries Change batteries only after turning off the power 1 Remove the rubber cover from the battery cover with a thin flatolade screwdriver Fig 1 2 Remove the screw fixing the battery cover with a Phillips screwdriver Fig 2 3 Remove the battery cover by sliding it toward the charging terminal Fig 3 4 Replace the batteries Use only designated batteries AAA nickel metal hydride batteries and nominal 1 2 V Rubber Cover Battery Cover re Battery Cover Do not open any part other Cautions gt e Do not misalign the plus and minus side than the battery cover e Place the battery cover screw and rubber cover by reverse of the removal method Do not overtighten the screw e Charge the batteries fully before use after changing batteries Cleaning amp Lubricating contra angle head iSD HP e Apply PANA SPRAY PANA SPRAY Plus after each use and or before autoclaving
3. iSD900 Quick User Guide ON and OFF power 1 Keep Pressing the Power Key for more than 2 seconds to turn on off the power Adjusting the torque setting only available when the motor is stopped 2 Press the UP DOWN Key to adjust the torque limit Torque can set from 10 to 40 Nem in 1 or 5Ncm incerements During operation if the load reaches set torque the motor will automatically stop a Changing the rotation direction 3 Press Reverse Key to change the rotation direction forward or reverse pa ON OFF Key Ro Calibrating the handpiece 4 Insert the calibration bur into iSD HP LCD Panel Sum 5 Keep pressing the Calibration Key for more than 2 seconds ak Reverse Key LCD display changes to L with alarm sound and CAL will be displayed Calibration Key UP DOWN Key Beis 6 Press ON OFF Key Motor will start rotating at no load mode rae Power Key After finishing no load mode display changes to H with alarm sound The motor will automatically stop Please do not press the ON OFF Key when the bur insert to the torque calibrator 7 7 Place the open end of the calibration bur into the torque calibrator Press ON OFF Key again The motor will start rotating at loaded mode The torque calibrator should be placed on a flat and stable surface After finishing loaded mode the system will automatically switch to e mado Now Ready to operate Specifi
Download Pdf Manuals
Related Search