American Standard 4332.400.002 Installation Guide
Contents
1. gt Marked with a Red Stripe to Hot and right supply Marked with Blue Stripe to Cold wall supply Use adjustable wrench to tighten connections Do not over tighten Faucet supplies are 27 1 2 long from faucet base Note If additional supply length is required installer must purchase additional parts separately Important If SUPPLY HOSES 1 2 are too long loop as illustrated to avoid kinking TEST INSTALLED FAUCET Move HANDLE 1 into off position Unthread AERATOR 2 from SPOUT 3 Turn on water supplies and check connections for leaks m Operate HANDLE 1 on and off hot and cold to flush water lines thoroughly Replace AERATOR 2 Check all drain connections for leaks Move HANDLE 1 to off position HOT amp COLD SUPPLIES M968576 m Clogged CARTRIDGE outlets or inlets may cause reduced flow To clean first turn off water supply then E Loosen and remove LEVER HANDLE 1 Loosen HANDLE SCREW 2 with 2 5mm Hex Wrench and then pull HANDLE BASE 3 off Unscrew ESCUTCHEON CAP 4 Unscrew the CARTRIDGE NUT 5 Remove CARTRIDGE 6 Clean inlets of CARTRIDGE 6 and MANIFOLD 7 Reassemble CARTRIDGE 6 Replace CARTRIDGE NUT 5 CAP 4 and HANDLE assembly check flow SERVICE If SPOUT 3 leaks at swivel point the O RINGS 2 need to be replaced To remove SPOUT 3 E Loosen the SPOUT SET SCREW 1 with a 8mm Hex wrench E Rotate the SPOUT 3 side to side wh2. Americam Standard Installation PEKOE Instructions SINGLE FUCTION KITCHEN FAUCET 4332 001 XXX SINGLE FUCTION BAR FAUCET 4332 400 XXX Thank you for selecting American Standard the benchmark of fine quality for over 100 years To ensure that your installation proceeds smoothly please read these instructions carefully before you begin Certified to comply with ANSI A112 18 1M M968576 Recommended Tools 3 Phillips Screwdriver Channel Locks Adjustable Wrench Plumbers Putty or Caulking Tubing Cutter INSTALL FITTING 4332 001 400 Turn off hot and cold water CAUTION supplies before beginning Make certain the SEAL 1 is properly seated in recess of faucet body Insert supply HOSES 2 and SHANK 3 through center hole of sink or mounting surface Assemble RUBBER WASHER 4 PLASTIC WASHER 5 METAL WASHER 6 and threaded LOCKNUT 7 onto SHANK 3 from underside of sink or mounting surface Hand tighten LOCKNUT 7 and check that faucet is centered Use a screwdriver to tighten SCREWS 8 on LOCKNUT 7 Work your way around LOCKNUT 7 tightening the screws slightly each time until all are snug to ensure even pressure 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning Connect FLEXIBLE SUPPLIES 1 2 directly to wall supplies Connection z STRIPE on fitting supplies are 3 8 compression Connect left supply We g
3. ile pulling upward to i remove SPOUT 3 from faucet body REMOVE Replace the defective parts grease O RINGS 2 then push SPOUT 3 back into position Tighten SET SCREW 1 ea Check that SPOUT 3 rotates freely and does not leak y at the swivel point 3mm HEX WRENCH 6 CARE INSTRUCTIONS DO SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER DRY WITH A SOFT COTTON FLANNEL CLOTH DO NOT DO NOT CLEAN THE PRODUCT WITH SOAPS ACID POLISH ABRASIVES HARSH CLEANERS OR A CLOTH WITH A COARSE SURFACE M968576
Download Pdf Manuals
Related Search