Rosewill RCR103 User's Manual
Contents
1. en it with the screws 4 Connect the USB2 0 cable from the RCR 103 to your motherboard caution 1 Please refer to your motherboard manual for the USB header pin assignment information The wrong connection may HARM the RCR 103 2 Do not take out the memory card or the USB device connected to the RCR 103 when the Access LED is flashing Otherwise the data will be lost CARD READER RCR103 USER S Manual Software Installation If your operation system if Windows 95 98 98SE please install the driver 1 Put the CD packed with the RCR 109 into the CD ROM drive 2 The InstallShield Wizard will be popped out Please follow the on screen introduction to finish the installation Change the front panel 1 Remove the upper cover of the RCR 103 2 Apply a suitable size of the screwdriver with the flat head and insert the screwdriver into the gap showed on the picture Gently press the locked tab and push onward to make front panel out 3 Apply the same procedure of the step 3 and step 4 on the other side of the front panel and install the desired front panel to the RCR 103 Thank you for purchasing a guality Rosewill Product Please register your product at www rosewill com for complete warranty information and future support for your product2. osewill CARD READER RCR103 USER S Manual CARD READER RCR103 USER S Manual ee U Feature Hardware Introduction QED indicator 1 USB port for plugging into any USB device cF microarive 2 Slot for SD MMC and RS MMC cards sp amp MMC 3 Slot for Memory Stick Memory Stick PRO Tu Memory Stick Due and Memory Stick PRO a use 2 0 port Due cardse Fully compliant with USB 2 0 4 Slot for Compact Flash cards and MicroDrive EEU 5 Slot for Smart Media cards 6 LED indicator Red Access LED there will two situation with RED LED The RED LED will be on when the memory card is inserted The RED LED will be flashing when the memory care is accessed Green When the RCR 103 is connected successfully the Green LED will be on MS MS Pro MS Duo MS Pro Duo GO Smar Media Package e RCR 103 e Manual e Screws 4 pieces e Driver disk System Requirement 1 Available on board USB 1 1 or USB 2 0 port on the motherboard 2 Support Windows 95 98 98SE 2000 ME XP Mac system 8 6 9 x 10 1x or 10 2x or above Linux kernel versions 2 4 x or above Installation Hardware Installation Before starting to install the RCR 103 please make sure the operating system for your computer is installed completely 1 Shut down the computer before installing the RCR 103 2 Remove the computer case cover and locate an empty 3 5 floppy drive bay 3 Insert the RCR 109 into the empty 3 5 floppy drive bay and fast
Download Pdf Manuals
Related Search